Gas Leak Detection
See Also: Gas Leak Detectors
-
Product
Personal RF Detection Meters, Low Frequency
-
Personal RF Detection Meters, Low Frequency by Sensory Perspective Ltd.
-
Product
Zero Gas Generator - Calibration of Ambient Air Monitoring Systems
ZNV-7
-
HORIBA Europe’s Zero Gas Generator ZNV-7 has been developed to check the zero point and dilute the span gas sources in order to carry out the calibration of ambient air monitoring systems. The increasing sensitivity of ambient air analyzers is required by strict official guidelines, which demands pure and dry air in a sufficient quantity at constant pressure.
-
Product
Combustion Leak Tester
AC560000
-
Fast, economical and accurate method to test for combustion gas leaks in head gaskets, cylinder heads and engine blocks. Dual chamber design provides more accurate test results. Test fluid can be used for both gasoline and diesel engines.
-
Product
Laser Spectroscopic Motor Exhaust Gas Analyzer
MEXA-ONE IRLAM
-
The MEXA-ONE IRLAM is an analyzer for the direct, simultaneous real-time measurement of the four relevant nitrogen-containing exhaust gas components NO, NO2, N2O and NH3.HORIBA's innovative infrared gas analysis technology, IRLAM™ (Infrared Laser Absorption Modulation), enables low-noise, high-precision measurement of four nitrogen compound gases (NO, NO2, N2O, NH3) in the low concentration range.
-
Product
Open Path Infrared Gas Detector
IR5500
-
The IR5500 is an open path infrared (IR) gas detector that continuously monitors for flammable gas leaks over large open areas. It monitors in both the LEL-m and ppm-m ranges to detect both small and large leaks. The IR5500 offers the benefits of early detection with its high sensitivity to gas concentrations at the ppm levels.
-
Product
CX4000 – FTIR Gas Analyzer
-
Gasmet CX4000 is an industrial multi-component FTIR gas analyzer for continuous emission monitoring applications, integrated into a Continuous Emissions Monitoring system (CEMS II e). It can be used to measure up to 50 components simultaneously, and additional gases can be easily added without any hardware changes. The corrosion-resistant sample cell is heated up to 180 °C, which makes CX4000 an ideal tool for analyzing trace concentrations of pollutants in wet, corrosive gas mixtures.
-
Product
Flow Leak Testing
Leakmaster UltraFlow v3
-
NEW AND IMPROVED EtherNet/IP FEATURING "SLAVE MODE". PROGRAMMABLE ELECTRONIC PRESSURE REGULATOR . DIGITAL MASS FLOW SENSOR WITH BROAD TESTING RANGE . LED STATUS INDICATOR. DUAL ACCESS DOORS FOR FLEXIBLE MOUNTING
-
Product
Insight Vertical Fall Pharmaceutical Metal Detection System
-
The Insight Pharmaceutical Vertical Fall Metal Detection system is designed for inspecting powders and granules with a throughput of up to 3000kg per hour.
-
Product
Refrigerant Leak Detector w/ Solid Electrolyte Sensor
RLD15B
-
UEi Test & Measurement Instruments
The RLD15B Refrigerant Detector is designed and certified to meet the new tougher standards and detect the latest refrigerants. Equipped with a heated sensor to increase accuracy and reduce false alarms, the RLD15B displays approximate leak sizes with the digital leak size indicator to help pinpoint leak sources. Finally, the mechanical pump draws gas over the sensor faster providing a quick response in a variety of contaminated or windy environments.
-
Product
Digital Infrared Thermo Leak Detector
IR-711
-
Shenzhen Calibeur Industries Co., Ltd..
'-4 colors backlight to indicate thermo leak by diviation setting;'- Measurement Range: -40° to 716°F (-40° to 380°C); '- Accuracy : < 0°C： ±3% or ± 3°C ≥0°C： ±2% or ±2°C '- Distance Spot Ratio: 12:1; '- Emissive: fixed at 0.95;'- Response time: 0.5 seconds;'- ℃/℉ selectable;'- Three ranges of leak difference exchange: ±0.5℃, ±3.0℃, ±5.5℃ ±1℉, ±5℉, ±10℉'- Size: : 42*85*185mm'- Weight: 170g'- Power: 1pc 9V Battery .(not included)
-
Product
BSE Detection
SLIM
-
SLIM™ is an innovative design for under-the-column BSE detection.SLIM™ puts El-Mul’s ScintiFast™ together with a segmented, shaped light guide and Silicon Photomultipliers (SiPM) to create a fast, sensitive, segmented and compact BSE detector for e-beam tools.
-
Product
SF6 Gas Moisture Detector
JH4000SF-1
-
Xiamen Jiahua Electrical Technology Co.,Ltd
SF6 gas moisture is not only a major item for gas quality acceptance but also a key index to evaluate installation, maintenance and operation of SF6 electrical equipments. In IEC60480-2004 Guidelines for the checking and treatment of sulfur hexafluoride (SF6) take from electrical equipment and specification for its re-use, moisture is listed as a detection item for SF6 fresh gas, equipment acceptance, preventive test and maintenance.
-
Product
Photo-Frame Style Smart Signal Detective Jammer
WF-DJ7
-
Shenzhen Tangreat Technology Co., LTD.
WF-DJ7 is a Painting Smart Signal Jammer.WF-DJ7 is designed mainly used for indoor cellphone signal detection and shielding, such as meeting rooms,border control units, Border Patrol and Drug Enforcement, Customs, Houses, Churches, Courts, Theaters, Offices,classrooms. checkpoint personnel, Hospitals, Recording Studios, Banks, Contract Tendering Rooms, Testing Facilities, Security Services, Military Units, Secret Services, News Conference Scene, Libraries, Museums,Prisons and so on.
-
Product
Motion, Temperature And Leak Detection Sensors
-
Select from a wide range of motion and temperature sensors for motion detection, temperature, humidity, and carbon dioxide (CO2). We carry passive infrared (PIR) sensors that detects human-body generated infrared waves to indoor motion detection. They can be configured to automatically switch on a light or trigger alarms if motion is detected. The DL-300 can also be used on mobile devices so it is easy for you to monitor your room temperature, humidity, carbon dioxide (CO2) and mono dioxide (CO) level on your phone.
-
Product
Trace Gas Analyzers
-
Campbell Scientific offers both open-path and closed-path trace gas analyzers for measuring carbon dioxide and water vapor. Campbell Scientific also offers a closed-path analyzer for measuring methane, nitrous oxide, or isotopologs of carbon dioxide.
-
Product
Transportable Gas Analyzer
CGT-7100
-
The CGT-7100 analyzer measures the concentration of gases in a continuous way, using a ratio photometric non-dispersive infrared absorption (NDIR) method. All pretreatment parts required for measurement, such as the pump, filter, and electric dehumidifier, are built-in. The analyzer can measure three components including CO, CO2, or CH4 (any two of these) and O2, and is compatible with measurement at 100 vol%. The CGT-7100 has wireless communication capability, so measurement values and charts can be displayed on PCs or smart devices. And measurement data can be exported using a USB flash drive.
-
Product
Gas Chromatography
-
Is an analytical technique used to separate and detect the chemical components of a sample mixture to determine their presence or absence and/or quantities.
-
Product
Multichannel Gas Alarm & Control System
X40
-
Teledyne Gas & Flame Detection
Your product description goes here.
-
Product
Air Leak Testers
-
Air Leak Tester is the automatic leak detector detects any leaks by the minute change of differential pressure and conducts OK/NG judgment. Ideal to be built into a production line for a labor saving and a quality control purpose.
-
Product
Gas Valve Pressure Adapter (EM201B)
BF100
-
UEi Test & Measurement Instruments
*Works with C125, C127, C155, C157, EM201B*Barbed brass fitting*Includes 18 Inch tubing
-
Product
Wireless Wire Break Detection System
A909
-
The A909 is a wireless system that allows to detect wire breaks for cabling machines having no sliding contacts brushes.
-
Product
Smart Gas Meters
-
FQ prepaid IC card gas meter is used for measuring the flow of gas in the pipe.
-
Product
Gas Analysis
HPR-90
-
The HPR-90 automated package cracking analysis system is a complete system optimized to analyse gas within sealed volumes such as light bulbs.
-
Product
Gas Tester for Measurement of Petrol, CNG, and LPG Powered Vehicles
M4GT / MAHA 4 GASTESTER | VP 135120
-
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA 4-Gas Tester serves for the measurement of petrol, CNG and LPG powered vehicles as well as the precise analysis of the gas components HC, CO, CO2, O2 with lambda value calculation. The M4GT impresses with its low weight, compact design and short warm-up time for easy handling, precise measurement results and rapid measurement readiness.
-
Product
Real-Time Analysis up to 255 MHz, Optimum Detection, Multi-touch
N9041B-RT2
Signal Analyzer
See, capture, and understand elusive signals as short as3.51 s with 100% POI and a complete set of advanced triggers, up to 110 GHz View signal dynamics with integrated real-time displays Maximize your investment by adding RTSA at a fraction of the cost of a dedicated solution Easily integrate the 89600 VSA software and thoroughly analyze complex signals Industry-leading 3 year warranty Every spec verified, adjustments included Lock in support & peak performance from the start
-
Product
Photoacoustic Infrared Gas Monitor
Chemgard
-
The stable, durable Chemgard Photoacoustic Infrared Gas Monitor is purpose-built and detects minute amounts of a wide variety of gases. Three different enclosure styles ensure there is a configuration for wildly different situations.
-
Product
SF6 Gas Recovery Device
-
Weshine Electric Manufacturing Co., Ltd
SF6 gas recovery device is used for the manufacture and use of SF6 gas insulated electrical equipment and the recovery of SF6 gasin scientific research departments. It also has the ability to purify SF6 gas, vacuum and charge.It can vacuum SF6 electrical switch and measure the vacuum degree.It can fill SF6 gas into SF6 electrical switches.It can recover the gas of SF6 electrical switch.It can purify the recovered SF6 gas.Store SF6 gas.
-
Product
CO, Alcohol and VOC Gas Sensor Breakout
MiCS5524
-
Give your next sensor project a nose for gasses with the Adafruit MiCS-5524 Gas Sensor Breakout. This breakout makes it easy to use this nice sensor from SGX Sensortech. The MiCS-5524 is a robust MEMS sensor for indoor carbon monoxide and natural gas leakage detection, it''s suitable also for indoor air quality monitoring; breath checker and early fire detection.
-
Product
OEM Gas (NO) Analyzer
BE-220FSD
-
The BE-220FDS is an OEM NDIR detector for measuring NO in automotive emission gases. The BE-220FSD can output NO concentration by digital data and analog voltage. In addition, it can be connected with the HORIBA BE-150 bench by serial line and relay the commands for BE-150. The BE-220FSD meets OIML Class 0 and complies BAR-97 & GB18285-2018 specifications.
-
Product
Carbon and Sulfur in Inorganic Materials by the Combustion Infrared Detection Technique
844 Series
-
LECO combined our customers' feedback with innovative engineering to develop the CS844, an elemental analyzer designed for wide-range measurement of carbon and sulfur content of primary steels, ores, finished metals, ceramics, and other inorganic materials using the combustion technique. Our exclusive MS Windows®-based software, coupled with a boom-mounted touch interface, gives you complete access to instrument control, analysis settings, diagnostics, reporting, and more—without sacrificing valuable bench space.
