Broadcast Monitors
-
Product
Permanent PQ & Energy Monitoring Products
-
Compact monitoring solution that combines PQ monitoring (with waveform recording) and 4 quadrant energy monitoring in one instrument.
-
Product
Fiber Optic Type Chemical Concentration Monitor
CS-600F
-
The CS-600F achieves a higher level of functionality best suited for manufacturing, such as the ability to perform in-line measurement of high temperature chemical solutions in various applications, stable operation for reduced downtime, and compact size for improved space productivity in order to meet the precise chemical solution concentration management required in leading-edge semiconductor wet process.
-
Product
Wireless Moisture Monitors Data Loggers
-
Lignomat’s monitoring systems can measure:*wood moisture, bamboo, gypsum, sheetrock, solid materials*relative humidity and temperature, DPT, GPP, EMC*EMC*concrete moisture using in-situ RH probes ASTM F 2170*Surface and interior temperature https://www.lignomatusa.com/wp-content/uploads/2015/02/wireless-moisture-data-logger.jpg
-
Product
HF / HCl Concentration Monitor
HF-960H
-
The HF-960H accurately measures concentrations of hydrofluoric and hydrochloric acid used in semiconductor manufacturing and other processes. The dedicated FES-510 series sensor is made from materials that are highly resistant to chemicals, making this unit ideal for the management of hydrofluoric and hydrochloric acid, even in high concentrations.
-
Product
Data Monitoring System
1S663-001
-
The 1S663-001 Data Monitoring System was specifically developed for the Cessna Citation X and serves as the primary diagnostic tool for the aircraft?? electronic Logic Modules. The system is FAA certified for airborne operation. Aft compartment and cabin modules can be tested two at a time while remaining in place. The system is also capable of monitoring the fuel quantity system during flight.
-
Product
Air Quality Monitoring System
-
A system that measures metrological parameters such as wind speed, wind direction, rainfall, radiation, temperature, barometric pressure and ambient parameters.
-
Product
Fume Hood Monitor
FHM10
-
Fume hoods are a primary source or protection in laboratories. Face velocity measurements are often used to gauge the performance of a fume hood’s ability to contain and exhaust hazardous chemicals. By accurately measuring face velocity and alarming on unsafe conditions, TSI’s FHM10 Fume Hood Monitors provide a high level of fume hood safety. And, the FHM10 helps users comply with standards and regulations set forth by OSHA, NFPA, ANSI Z9.5, and SEFA, calling for monitors to be installed on fume hoods.
-
Product
Systems For Monitoring And Managing Multiservice Networks
-
Designed to obtain information about the state of the network in operation. The system allows you to organize the protection of operated equipment or other important facilities. The system is open and allows you to increase the necessary functionality as the operator's business develops. Used in optical and coaxial networks.
-
Product
Online Condition Monitoring
-
PRÜFTECHNIK Condition Monitoring GmbH
Online Condition Monitoring systems track machine vibration and other relevant machine condition parameters around the clock so you can trend and analyze data. Entire plant sections or only critical machines can be monitored with online systems to optimize plant availability. The Fluke Reliability solutions from Pruftechnik and Fluke below alert you to abnormal readings requiring action and help you extend asset life.
-
Product
Single channel Motor Insulation Monitor
-
The SURETECH Motor Insulation Monitor measures insulation resistance to earth of electric motors when themotor stops. Motors running from mains (380 / 220V) and higher voltages up to 6.6kV can have their insulationcontinuously monitored.
-
Product
Systems for Oil Quality Monitoring
-
*Reliable monitoring of oil contamination*Reliable machine and plant protection by permanent oil moisture monitoring
-
Product
Logger and Handheld Instruments for Temperature Measurement and Monitoring
-
Temperature measurement and monitoring is vital for the quality of temperature-sensitive products wherever they are studied, produced, stored or transported.
-
Product
Battery Monitoring System
FST-TA
-
Foresight Electronics Co., Ltd.
Continuous 24/7 on-line monitoring One CELLCHECK monitor one cell, including internal resistance, voltage and temperature Software is available to collect data from CELLCHECK Serial port with Optical isolation, meet MODBUS protocol, easy to be accessed by UPS controller Easy to install without specialized training Full resistance, battery temperature and voltage monitoring for comprehensive battery state of health analysis String current and ambient temperature monitoring
-
Product
SparkFun Single Lead Heart Rate Monitor
AD8232
-
The AD8232 SparkFun Single Lead Heart Rate Monitor is a cost-effective board used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG or Electrocardiogram and output as an analog reading. ECGs can be extremely noisy, the AD8232 Single Lead Heart Rate Monitor acts as an op amp to help obtain a clear signal from the PR and QT Intervals easily.
-
Product
Gas Monitor System
-
Henan Bosean Electronic CO.,Ltd.
Used to detect combustible, flammable and toxic gases, and oxygen depletion.
-
Product
Photoacoustic Infrared Gas Monitor
Chemgard
-
The stable, durable Chemgard Photoacoustic Infrared Gas Monitor is purpose-built and detects minute amounts of a wide variety of gases. Three different enclosure styles ensure there is a configuration for wildly different situations.
-
Product
DP Monitor for Compressed Air Systems
Com.Air
-
The Com.Air dew point monitor has been designed by Edgetech Instruments to offer the highest level of reliability and accuracy available in compressed air system dew point measurement.
-
Product
Bulk Current Monitoring Probe
MP-50
-
The Current Monitoring probes may be used whenever RF current measurements are required. Current measurements are made by placing a current carrying conductor within the “sensing” window of the probe and measuring the probe’s output voltage with an RF detector. Calibration of the probe permits the conversion of the voltages measured to current. Current measurements can be made over the frequency range shown in the transfer impedance curve furnished with each probe. There is virtually no loading of the circuit and the technique permits normal operation of the device under test during measurements. The MP-50 can be used for the procedure for clamp injection when the common- mode impedance requirements cannot be met given in chapter 7.4 of IEC/EN 61000-4-6 „Immunity to conducted disturbances, induced by radio frequency fields”. The MP-50 can also be used as current monitor for BCI testing as per ISO11452-4, RTCA/DO-160 section 20, MIL-STD-461 and various automotive standards.
-
Product
12" SVGA / XGA Industrial Panel Mount Monitor
IDS-3212
-
12.1" SVGA / XGA LCD panel with LED backlight for 20% power savings, and environmental protection. -20° C ~ +60° C wide range operating temperature, 5-wire resistive touch screen solution or 3mm tempered smudge resistantprotected glass.
-
Product
Advanced Monitoring Probe
DAB/DAB+
-
Combined with a Network Monitoring System or not, the EdgeProbe Advanced provides a powerful broadcast network alert & diagnosis tool allowing Digital Radio network operators to monitor global trends and anticipate potential failures.EdgeProbe Advanced is able to monitor DAB/DAB+ signals at transmitter outputs as well as at modulator input, through its RF inputs (up to 4 in 1RU), and at Head-End/distribution links, through its ETI and IP (EDI) inputs.
-
Product
Data logger and Monitoring
-
Testo offers a wide range of data loggers for long-term recording of measurement data, e.g. for climate or temperature monitoring. Data monitoring systems are recommended for integrated measurement data monitoring. The testo Saveris system offers tamper-proof data recording and WLAN technology that provides access to your measurement data anywhere and at any time on PC, smartphone, or tablet.
-
Product
Oxygen Deficiency Monitor
Series 1300
-
Deploying a permanently mounted oxygen deficiency monitor in areas where inert gases are stored or piped is highly recommended. Like most things in life, not all oxygen deficiency monitors are the same. Alpha Omega Instruments Series 1300 Oxygen Deficiency Monitor has an array of features and safeguards that makes it today's premier monitor.
-
Product
Advanced Active/Passing Monitoring System
SQmediator
-
SQmediator® is an advanced active/passive monitoring system engineered to proactively manage the end-to-end performance of a range of network applications, including Voice over IP, IP Videoconferencing, Web and Email. Its multi-service, multi-tenant architecture supports advanced data aggregation, one-click custom dashboards for customers and locations, per-metric service thresholds, real-time alerts, and a web services API for integration with external management systems
-
Product
Remote Display Gas Monitor
Chillgard® 5000 Remote Display
-
The Chillgard® 5000 Remote Display provides gas monitor information before room entry where potentially hazardous gas levels may exist. It mimics the Chillgard 5000 Gas Monitor readings for gas concentration, alarm status, calibration.
-
Product
COMINT Monitoring System
-
A modern COMINT system can handle thousands of parallel signals. With a reliable and intuitive management software, the increased situational awareness creates a firm base for any decision making
-
-
-
Product
Receiver Systems for Monitoring, Surveillance and Logging
-
We produce complete turn-key radio monitoring systems ranging from portable single-channel applications for field tests and drive-by coverage measurements, to large scale computerized multi-channel surveillance systems capable of monitoring thousands of channels simultaneously.
-
Product
Central Visibility and Remote Monitoring
Torque Visor
-
Visor provides central visibility and remote monitoring of multiple probes, plus easy access to a comprehensive log of system events. Operators can retrieve detailed analysis directly on the respective probe, and spot fault trends across services or several geographic regions.
-
Product
MPEG Stream Monitor / Validator
TeleSight
-
Real-Time validation including video and audio bitstream conformance, video quality, bitrate, and audio levels Supports up to 20 streams simultaneously. View real-time playback of all input channels simultaneously or zoom in on one (real-time playback performance is dependant on machine, number of streams, and content). Mix variety of inputs types. Mix variety of supported MPEG formats.
