Return Path
-
Product
Signal Path Analyzers
HL5200 Series
-
HYPERLABS HL5200 Series Signal Path Analyzers™ provide ESD-robust, multi-channel test and measurement capabilities for a fraction of the cost of traditional benchtop systems. These differential instruments have up to 20 channels and can be used to take TDR, TDT, and XT (crosstalk) measurements. Beginning in June 2015, S-parameter (S11/S21) data will also be available.
-
Product
Switch Path Manager Signal Routing Software
-
Our signal routing software, Switch Path Manager (SPM), simplifies signal routing through switching systems and speeds up the development of switching system software. Switch Path Manager supports our switching modules and the interconnection between them. Once a switching system model has been created, simply defining the endpoints that are required to be connected together can perform signal routing.
-
Product
High Speed Logic and Data Path Management
-
The ADI Data Path Management portfolio offers Data Path Signal Conditioners, Digital Crosspoint Switches, Level Translators, Serializer/Deserializer & Selector Muxes and Track/Hold Amplifiers for meeting the tight requirements of modern high data rate system. ADI's system solution focused products are easy to integrate to any signal chain with single supply usage while achieving low jitter, high output swing, fast rise/fall time.
-
Product
Return Loss, Impedance & Balance Measurement Accessory
Model SLM620-1
-
For Loss- Frequency Range : 300Hz to 620KHz.- Impedance : 60 to 1000 ohms (40dB maximum).- Accuracy : ±1dB (upto 300KHz) ±2dB (300KHz to 620KHz).For Impedance- Frequency Range : 300Hz to 620KHz.- Impedance : 60 to 3000 ohms.- Accuracy : ±10% (upto 300KHz) ±20% (300KHz to 620KHz).
-
Product
PIM & Return Loss Measurement
Range to Fault (RTF)
-
Range To Fault (RTF) is an exciting new technology from Kaelus that enables operators to accurately measure the location of PIM and Return Loss faults in their RF infrastructure. Reflection data together with PIM data provides an unmatched level of clarity for identifying the location of faults in the RF path.
-
Product
Forward Path NPRT 2200 Noise Power Ratio Test Set
NPRT 2200-F
-
The NPRT 2200 measures the NPR of a device across a range of power levels. This test quantifies intermodulation distortion and determines the dynamic range of optical transmitters, amplifiers and other active HFC network devices. The included PC software uses predefined test setups to run a "Power Sweep" series of NPR measurements and graph the results.
-
Product
Laser Open Path H2S Detector
GD1
-
Teledyne Gas & Flame Detection
The GD1 has been designed with features that provide an effective response to the detection of gas hazards in a wide range of industrial environments from offshore production facilities to wastewater treatment plants. At the heart of the detector is a tuneable laser diode that eliminates environmental effects from sun, rain and fog. The laser scans single absorption lines where there is no interference from other gases.The GD1 needs no recalibration and can replace multiple standard detectors to cover the same risk. The complete optomechanical design and construction is so stable that an ultra fast speed of response can be achieved while providing unparalleled service life and detector stability, thus saving on maintenance and service costs.Supplied with worldwide hazardous area approvals. Suitable for use in systems with SIL 2 requirement.
-
Product
AM Open Path FTIR Air Monitoring Systems
-
AM Open Path FTIR Air Monitoring Systems bring the versatility of multicomponent analysis and the immediacy of real-time results to a variety of field applications. Now you can avoid the "hit or miss" guesswork of point sampling and the inaccuracy and delays of "bag and carry" offsite analysis.
-
Product
Tray Return Systems
-
Rapiscan® Systems range of Tray Return Systems (TRS™) are designed to allow for increased throughput, reduction in staff tray handling and the ability to increase passenger focus amongst various other benefits at security checkpoints.
-
Product
Return Band Alignment System
6103/6106
-
Enable a single technician to perform return band alignment with this easy to use return band alignment system for CATV. This system consists of a headend signal level receiver/telemetry transmitter (the HECTER 6103) and a small, field portable, dual-carrier signal generator/telemetry receiver unit (HECTER'S PUP 6106).
-
Product
Bench-top 12 Cores Or 24 Chanels MPO/MTP Insertion Loss & Return Loss Tester
-
Anfkom International Co.,Limited
This test station do the auto-testing on 12 core(24 core) for insertion loss and return loss, highly efficient multi-core fiber insertion and return loss measurement and make high precision on the measurement result with OTDR mandrel free technical adopting.
-
Product
Optical Path Converter
LS512A/LS512B
-
There are many LED manufactories using two integrating spheres and one spectrophotometer to do test. The previous testing way is: when you use big sphere to test, the customer need to connect the detector cable and optical fiber from the Spectrophotometer to the big sphere, after the calibrating and then you can do the test. When you use the small sphere, you need to take away the detector cable and optical fiber from the big sphere to the small sphere, then need to calibrate again. It is too troublesome to take out the detector cable and optical fiber between the big sphere and small sphere, and you need to calibrate again for every change. The frequent change will also shorten the life of the detector cable and optical fiber.
-
Product
Switch Path Manager License - SPM Full (Pro)
90-900-001
-
Simplifies signal routing through switching systems and speeds up the development of switching system software. It is available as a site license (see below for additional information).
-
Product
Open Path Infrared Detector
Ultima OPIR-5
-
Get continuous monitoring of methane, propane, and other combustible gases with this open path infrared detector. Provides 4-20 mA analog signals, as well as digital display and relay contacts.
-
Product
Hand Held Loss Test Set with Return Loss Option
LTSH1315
-
The KD Optics LTSH1315 is a combined laser or LED source and power meter designed to make attenuation testing in the field easy, reliable and consistent. A return loss option is available for 850nm multimode, 1310nm and 1550nm singlemode.
-
Product
Escape Path Marking
-
The EPM system provides floor lighting and exit door identification to passengers and crew evacuating an aircraft in limited visibility.
-
Product
Economical Type Forward Path AGC Optical Receiver
HR8136, HR8153
-
Hangzhou Huatai Optic Tech. Co., Ltd.
HR8100 series is an economical type forward path AGC optical receiver. Its technical performance and index are the same as HR9100, except without 20-segment output level indication and network management interface.
-
Product
Bench-top Insertion & Return Loss Test Station
STC-IRL3201
-
Shanghai Stone Communication tech Co., Ltd
STC-IRL3201 is a high performance loss test station that is designed specially for Optical Passive Components production Test and Lab Test. It combines three different working modes as a return loss meter, optical power and loss meter and a stable laser source in one test station.
-
Product
Signal Path Analyzers
HL2200 Series
-
HYPERLABS HL2200 Series Signal Path Analyzers™ provide high-performance test and measurement capabilities for a fraction of the cost of traditional benchtop systems. These differential, multi-channel instruments are ideal for interconnect characterization, debugging cable assemblies, coupon testing, controlled impedance analysis, and other applications requiring a fast rise time.
-
Product
Optical Return Loss (ORL) Meter
OPTOWARE-S300 (FOTS-ORL Meter Systyem)
-
The Optical Return Loss(ORL) Meter is an efficient system for the characterization and test of optical components and systems to be performed in high quality.
-
Product
CATV Return Band Two Carrier Generator
PC-2
-
The PC-2 is a compact, temperature-stable two RF-carrier source. It is designed to be used for activating and testing the return-band. When used with a signal level meter, the PC-2 assists in measuring insertion loss of cable, amplifiers, splitters, and taps using the stimulus-response method.
-
Product
Full-Function Top-class AGC Forward Path Optical Receiver
HR9136, HR9153
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Guangtai HR9100 series AGC forward path optical receiver is designed and produced by absorbing the advantages of all kinds of CATV AGC optical receivers from both home and abroad. Featured with high index, multi-function and high reliability, it is suitable for high-end subscribers.
-
Product
Diesel Return Flow Sensor
TP-RFS400
-
Common Rail Diesel injection systems are becoming more and more advanced. The diesel return flow sensor RFS400 can be used together with a lab scope (automotive oscilloscope) to diagnose the most advanced Diesel injection systems.
-
Product
Switch Path Manager Lite License - SPM Lite
90-900-901
-
A low-cost "lite" version of our Switch Path Manager has a site license (can be used on unlimited PCs) and a boot limitation of two switching modules.
-
Product
Open Path CH4 Analyzer
LI-7700
-
The LI-7700 is designed specifically for eddy covariance flux measurements to evaluate methane emissions from the terrestrial landscape. It provides low-maintenance long-term operation in demanding field deployments.
