Data Analysis
Data Analysis Software is used to sort through data in order to identify patterns and establish relationships.
See Also: Experiments
-
product
Capture & Replay Of I/Q Data Files
SimIQ
Generate RF from I/Q files & accelerate product development. SimIQ enables Spirent’s GSS9000 and GSS7000 Series simulators to capture, replay and share I/Q data files without the need for additional hardware. This capability opens up opportunities for testing receiver algorithms earlier in the development cycle, saving time and money while delivering greater collaborative processes to global teams through simple sharing and consistent playback.
-
product
Spectrum Analysis, Up To 90 GHz
S930909B
The S930909B spectrum analysis adds high-performance microwave spectrum analysis up to 90 GHz to the N5290A/91A broadband network analyzers and other various banded millimeter-wave network analyzer configurations
-
product
Oven Data Logger
215
Memory stores up to 260,000 readingsIdeal for testing for powder or liquid coatings in batch or conveyor ovensVariable measurement interval, date, time, °C / °FHigh temperature resistant teflon coated probe cables are easy to clean after each runQuick display shows maximum temperature, Cure-Index figure and pass/fail for each probeMeasure up to 6 different temperatures at one timeIdeal in situations where powder coated thickness is inconsistentStart and stop logging at a pre-set temperatureLarge menu-driven display for easy operationPrint full colour report directly to any HP printerUSB data output to ElcoMaster® software and combine with other key inspection measurements
-
product
Mission Data Programmer
MS 1602
The MIP programmer is used to program, read and erase mission data of Mirage 2000 Aircraft. This system is micro controller based design. This system facilitates to program the four EPROM devices at a time. This system contains four read write slots and one read only slot. Read only slot used to read the device data safely. System also has capability to program the one slot device data to another slot device.
-
product
The all-in-one data logger for the entire vehicle networking
PM-200
The PM-200 sets the bar considerably higher on the topic of safeguarding and troubleshooting vehicles. Bus systems such as CAN, CAN-FD, FlexRay™, LIN, MOST150 and Automotive Ethernet are logged at a data speed up of to 120 MB/s. SSD removable media allow for quick evaluation and distribution of the data. Various upgrade options enable configuration for any application. Flexibility, programmability and support from debugging protocols make it possible to meet the high demands of functionality and fleet tests as well as of test runs.
-
product
Data Acquisition
Data Acquisition module incorporating 16 Analog-to-Digital (ADC) inputs, 8 Digital-to-Analog (DAC) outputs, and 48 bi-directional Digital I/O in a single module.
-
product
System Grounding & Earthing Analysis
ETAP's system grounding & earthing foundation automatically detects the system earthing configuration based on source and transformer grounding or earthing type selection. The resulting earthing types are displayed both on the one line diagram and for the various connected cables.
-
product
Fibre Channel Data Playback
RMSR-2002-PS
Curtiss-Wright Defense Solutions
The TTC RMSR-2002-PS playback unit houses two data cartridges. Data is read through the Fibre Channel Interface. Front panel indicator LEDs show Active, Lock and Fault status for each cartridge.
-
product
DATA LOGGER
Dl7
Monitor and Record low differential pressures and temperature with the model DL7 Differential Pressure Data Logger. Unit includes an onboard thermistor for ambient temperature measurement
-
product
Torque Data Acquisition Software
SW-1SV-USB data acquisition software is for all Cedar torque instruments.Force Recorder is compatible with the new HTGS & HTGA digital torque testers.
-
product
Data Acquisition Hardware: USB
Ease of connection, low cost and good performance are key to our USB product range.
-
product
AutoPump Air-Powered Data Module
The QED AutoPump Data Module is a water-resistant enclosure that protects and shields surface instrumentation from weather and/or harsh site conditions while providing easy access, via a see-through window, to key system instrumentation readings.
-
product
Transportation Data Logger MSR175
MSR175
Transportation data logger MSR175 for shocks, jolts, temperature. The MSR175 stand-alone data logger uses high-resolution sensors to continuously record what happens to your goods during transportation. The logger data can then be analysed very accurately – be it in order to ascertain damage or to improve transport packaging – using the “MSR ShockViewer” software.
-
product
Veracode Static Analysis
SAST
*Find Flaws Accurately, at ScaleScan over 100 languages and frameworks quickly and accurately.*Prioritize and Fix Flaws FastRapidly find and fix vulnerabilities with real-time feedback and reduce flaws introduced in new code by up to 60% with IDE scans.*Deliver a Frictionless Developer ExperienceCode confidently with contextual learning and easy integration with over 40 developer tools and custom APIs.*Streamline Governance, Risk Management, and ComplianceManage and measure the security posture of your applications with enterprise-wide security policies, robust reporting, and comprehensive analytics.
-
product
Data Acquisition Switch System
M300
No matter the product performance test in the R & D stage or the automatic test in the production process, for the application of multiple test points and multiple signal measurement, the M300 series data acquisition / switch system with modular structure combines the precise measurement function with the flexible signal connection function, and can provide a wealth of test measurement solutions.
-
product
Two-way Wireless Thermocouple Temperature Data Logger with LCD
RFTCTemp2000A
The RFTCTemp2000A is two-way Wireless thermocouple based temperature data logger with LCD. Transmits up to 2000' maximum (outdoors unobstructed). Built-in memory also stores data internally. Features a built-in temperature sensor for cold junction compensation (CJC). An external thermocouple probe is required (not included). Accepts J, K, T, E, R, S, B, and N type thermocouples.
-
product
Circuit Simulation, Power Analysis and Jitter Analysis Design Tools
GreenPoint®
The GreenPoint Design Simulation Tool is an interactive online design and verification tool to help you generate and validate an electronic design. The simulation module provides an interactive design and verification environment. The power analysis module provides an interactive environment to analyze the performance of intelligent power modules (IPMs). The Phase Noise Explorer module enables an interactive environment for advanced phase noise/jitter analysis of clock tree designs.
-
product
MultiGas™ TFS™ Gas Monitor For Multi-Compound Gas Analysis
The MultiGas™ TFS™ Monitor is an online, multi-compound, trace gas monitoring system in a stand-alone 19-inch rack enclosure. It uses an innovative tunable filter spectroscopy technology enabling high selectivity and stability measurement. Low detection limit (sub-ppm levels for most gases) is achieved through the use of high throughput optics coupled with a long-path gas cell and a high sensitivity detector.
-
product
3-Slot Data Acquisition Mainframe With GPIB And Three 20-Channel Multiplexer Modules
DAQ973MB
The DAQ973MB Better Multiplexer Bundle offer includes a DAQ973A three-slot data acquisition mainframe and three 20-channel DAQM901A multiplexer modules. This bundle provides the following:3-slot mainframe with USB, LAN, and GPIB6.5-digit (22-bit) internal DMM60 channels of multiplexer switches6 channels of dedicated current measurements2- and 4-wire scanning300 V switching80 channels/s scanningbuilt-in thermocouple reference junctionbuilt-in signal conditioning to measure thermocouples, RTDs and thermistors, AC / DC volts and current; resistance, frequency / period, diode test, and capacitance
-
product
IoT Data Loggers for LoRaWAN Networks
LR35 Series
The data loggers of the LR35… series are wireless devices for IoT (Internet of Things) applications that use LoRaWAN® technology for long distance data transmission.
-
-
product
Transient Stability Analysis
I*SIM
PTW I*SIM is a program for transient stability analysis. It is designed to simulate system response during and after transient disturbances such as faults, load changes, switching, motor starting, loss of utility, loss of generation, loss of excitation, and blocked governor events. I*SIM is designed to study today's most challenging simulation problems in one convenient and easy-to-use program.
-
product
Dynamic Imaging particle analysis system
FlowCam® Biologics
Yokogawa Fluid Imaging Technologies, Inc.
Detection & measurement of protein aggregates and other paticulates Formulation research & development QC diagnostics Stability studies and shelf-life simulation
-
product
Aggregation Analysis System For Biopharmaceuticals
Aggregates Sizer
The "Aggregates Sizer" aggregation analysis system enables the quantitative evaluation of particle amounts in the SVP range as a concentration (unit: μg/mL). Aggregations of biopharmaceuticals can be categorized into 3 ranges: IVP (In-visible Particle), SVP (Sub-visible Particle), and VP (Visible Particle), according to their particle size. Until now, no particle size analyzer could cover the SVP range with a single measurement. Therefore, multiple methods had to be used. Aggregates Sizer completely covers the SVP range.
-
product
Automated Data Management and Capacity Monitoring Solution
SafeCapacity
SafeCapacity, an automated data management and capacity monitoring solution, addresses the difficulties inherent to exponential data growth, 24 by 7 operational requirements, and optimization of data across varying levels of storage resources.
-
product
Real-Time Analysis, 255 MHz, Basic Detection, Multi-touch
N9040B-RT1
See, capture, and understand elusive signals as short as 17.17 s with 100% POI and a complete set of advanced triggers View signal dynamics with integrated real-time displays Maximize your investment by adding RTSA at a fraction of the cost of a dedicated solution Easily integrate the 89600 software and thoroughly analyze complex signals Industry-leading 3 year warranty Every spec verified, adjustments included Lock in support & peak performance from the start
-
product
Gas Analysis
Si-CA 130
The Si-CA 130 features a touch-screen display and comes with PC-based management software (in addition to the smartphone app) for more in-depth combustion gas analysis. The three field-replaceable cells and sensors offer expanded measurement capability.
-
product
Data Loggers
Data loggers are electronic devices which automatically monitor and record environmental parameters over time, allowing conditions to be measured, documented, analysed and validated. The data logger contains a sensor to receive the information and a computer chip to store it.
-
product
Fully automated Crude and Detergent Fibre analysis
Fibertec™ 8000
The Fibertec 8000 is a fully automated system for determination of crude fibre, detergent fibre and related parameters according to standard reference 'crucible' methods such as Weende, van Soest and other recognised methods. Approvals for the crucible method include ISO, EEC, AOAC, AOCS. The Fibertec 8000 provides unrivalled accuracy, the highest safety and the lowest operator time of any fibre solution.Parameters: Crude fibre, neutral detergent fibre, acid detergent fibre, acid detergent lignin. Sample types: Raw materials and finished products in Feed and Agriculture.
-
product
Data Logging Class 2 Sound Level Meter
Castle Sonus GA216L
The Sonus GA216L Sound Level Meter is a fully compliant, integrating and data logging instrument, capable of a wide diversity of applications including Noise at Work and Environmental Noise monitoring.
