Log Periodic Antennas
Multielement, unidirectional, narrow-beam antenna that has impedance and radiation characteristics that are regularly repetitive as a logarithmic function of the excitation frequency.
See Also: Antennas, Broadband Antennas, Directional Antennas, HF Antennas, Biconical Antennas, Horn Antennas, Isotropic Antennas, Loop Antennas, Antenna Software, Antenna Analyzers, Dipole Antennas
-
product
Log Periodic Dipole Array
ALP500
Standard remote antenna ideal for fixed applications. The ALP Series antennas are a Log Periodic Dipole Array (LPDA) design that provides a useful directional pattern over a broad frequency bandwidth.
-
product
Conical Horn Antennas
Conical gain horns are offered as both standard and custom models with either a circular or rectangular waveguide interface. While conical gain horns with a rectangular waveguide interface can only support linear polarization, models with a circular waveguide interface can support various polarization types including horizontal, vertical, left-handed circular, and right-handed circular polarization for broader applications. The listed models operate across the full waveguide band and offer 23 dB nominal gain, 12 degrees typical half power beamwidth, a 24 dB typical side lobe level and 1.15:1 VSWR at center frequency. The below standard offering covers the frequency range of 8.5 to 140 GHz. However, other frequencies and standard models with 10, 15, 20 and 25 dB gain are also available.
-
product
Array Antennas
An antenna array (or array antenna) is a set of multiple connected antennas which work together as a single antenna, to transmit or receive radio waves. The individual antennas (called elements) are usually connected to a single receiver or transmitter by feedlines that feed the power to the elements in a specific phase relationship. The radio waves radiated by each individual antenna combine and superpose, adding together (interfering constructively) to enhance the power radiated in desired directions, and cancelling (interfering destructively) to reduce the power radiated in other directions. Similarly, when used for receiving, the separate radio frequency currents from the individual antennas combine in the receiver with the correct phase relationship to enhance signals received from the desired directions and cancel signals from undesired directions. More sophisticated array antennas may have multiple transmitter or receiver modules, each connected to a separate antenna element or group of elements.
-
product
Multi-Port Antennas
*Contains between 4-12 ports*Multi-band antennas with separate high and low band ports*Deploy 4x4 (MIMO) on both high and low bands*Independant tilt control for each band
-
product
Eight-Channel Portable Data Acquisition and Logging System
DaqPRO
DaqPRO is battery operated and is capable of sampling, processing and displaying measurements without connecting to a computer. Designed to serve the needs of professional data loggers, DaqPRO is a professional, cost-effective, compact and stand-alone data logging system that can be used with a wide variety of applications. This 16-bit, high-resolution, eight-channel data logger offers the pros graphic displays and analysis functions for measuring voltage, current and temperature in real-time.
-
product
Dipole Antennas
Provides reliable, repeatable measurements. Suitable of FCC, MIL-STD, VDE, Tempest and Immunity stesting.
-
product
Antenna Impedance Converter
The low noise impedance matching equipment has a high impedance input with minimized capacity. With the 50 Ω output it can be used with common EMI receivers or spectrum analyzers to measure the emissions received by an antenna on a vehicle.
-
product
Horn Antenna
ZLB7-SJ12-40G-1015
Dual Polarized Horn Antenna, Frequency 12~40GHz, Gain 12dBi,Iso 25dB Typ., 2.92mm Female connectors, Small Size 55*55*82mm, 5G Mesurement.
-
product
Reference Antennas
Type NRD
Reference antennas are precision dipole antennas that offer a fixed 2.15 dB of gain over an isotropic antenna along the major lobe axis at specified frequencies (2.15 dBi). They are intended to be used for antenna field pattern and gain measurements, or general RF sensing in the laboratory.
-
product
Mobile Antennas
Amphenol Procom offer a wide range of products for Mobile communication applications. Amphenol Procom's Mobile Antennas are designed by experienced engineers with a focus on the professional user. In our collection you will be able to find Whip Antennas, Mobile Mounts, GPS Combination Antennas, Low Profile/Covert, Motorcycle Antennas, Danmike, and other Mobile Antenna Components.
-
product
VHF Antennas
From small craft to large ships, Shakespeare® VHF antennas are the go-to antennas to keep you connected utilizing the essential VHF marine radio.
-
product
Aircraft SATCOM Antennas
Never miss a connection with Astronics AeroSat aircraft SATCOM antenna systems. Available for linefit or retrofit applications, these certified HTS-ready solutions have provided seamless inflight connectivity through millions of flight hours for more than a decade.
-
product
Antenna
Simulsat
Quintech Electronics and Communications Inc.
Simulsat is the world’s only true full-arc multiple satellite antenna that is capable of receiving satellite transmissions from 35 or more satellites simultaneously, without adjustment or degradation in performance from one satellite to the next.
-
product
Phase Array Antenna System
Electronically steers radio waves without physical movement by using an array of antennas.
-
product
Antenna Switch
SixPak
The SixPak has two components: a relay matrix and a control box, there are several options for the controller.The relay matrix allows the selection of any 6 antennas by 2 radios or feedlines. Its lockout circuitry prevents both radios from selecting the same antenna. (The 6x1 type of SixPak is now replaced by our RatPak remote 6 way antenna switch.)The usual set-up has one SixPak dual rotary control box, which is manually operated from the radios positions. The control box for the 6x2 contains two rotary switches and 12 LEDs, so the operator can see which antennas are selected.
-
product
Antennas
Radiall offers a complete range of antennas dedicated to military and industrial applications. It includes radio tactical communications, vehicles, positioning, LMR/PMR and telemetry applications. Additionally, Radiall offers custom designed antennas and high-end support to its customers for any special requirements.
-
product
GNSS Smart Antenna
R780
Tougher than Tough Enough. The R780 GNSS Smart Antenna is small, tough and useful. As a GNSS rover system or as a base station, the R780 does it all.
-
product
Millimeter Wave Antenna Testing
If you are involved in antenna or system level design using mmWave or THz frequencies, then you understand the importance of dependable testing equipment. It may be that you are designing passive phase array or that you are designing a mmWave radar sensor system, but when it comes to validation of your design, simulation can only bring you so far. Phased array antennas have to be measured over the air (OTA) to ensure the radiation pattern of your design efficiently conducts energy in the right direction which is where the MilliBox comes in.
-
product
Antenna, Omni-Directional Wideband Discone
EM-6105 | 10 KHz – 2 GHz
The EM-6105 is a broad band collinear array allowing very wide Omni-Directional frequency coverage in a single package. Below approximately 100 MHz, the EM-6105 acts as an active vertical rod which offers 10 to 12 dB more signal handling capability than competitive antennas (overload field strength: 2 V/meter) which greatly reduces intermodulation generated signals in a typical read world RF environment. In the congested spectrum above 100 MHz the antenna is passive and contributes no intermodulation products so the overload point is determined solely by the receiving instrument. This immunity to overload can often make the difference between useful signal output and an indecipherable jumble of spurious products and is accomplished without compromising sensitivity. The antenna collapses for convenient storage and transport. The EM-6105 is supplied with an EM-6106 Battery Pack.
-
product
Cable & Antenna Analyzers
Site engineers and technicians have been using sweep testers also known as cable and antenna analyzers to validate installations or to find trouble locations and imperfections in wireless sites.
-
product
Multilingual MM Antenna Analyzer
MMANA-GAL
MMANA-GAL is an antenna-analyzing tool based on the moment method, which was introduced in MININEC. The program provides ability for changing the language of signs and messages of the program.
-
product
Antennas
Below are a selection of compatible antennas available for the NAV6 Series of NAVTEX products as well additional accessories for mounting and a fitting to your boat. Please browse the tiles below to find out more.
-
product
Antenna Test System
ATS1000
Offering measurements on active and passive devices - supporting also extreme temperature testing. 5G is all about data, speed and reliability using high frequency millimeter wave bands. The lack of conventional external RF connectors makes 5G antenna characterization challenging. 5G antenna, chipset and UE manufacturers as well as wireless market operators need a viable solution for research, diagnostics and debugging up to type approval.
-
product
Spiral Antenna UHF Trafo
UHF Spiral antenna is a partial discharge sensor designed to receive electromagnetic (EM) emissions from a PD occurring in the monitored asset. It is a broadband antenna with a flat response which makes Spiral antenna suitable in a number of different applications. It has been optimized to operate in a frequency range typical for PD activity and it was designed to provide maximum sensitivity and high gain. Its compact and robust design (passive sensor) makes Spiral antenna the optimal sensor for direct installation on high voltage Transformers. It can be virtually applied in any electrical equipment provided that it has apertures or EM transparent surfaces. Contact our sales department for consulting.
-
product
Lens Antennas
A lens antenna is a directional antenna that uses a shaped piece of microwave-transparent material to bend and focus microwaves by refraction, as an optical lens does for light.[1] Typically it consists of a small feed antenna such as a patch antenna or horn antenna which radiates radio waves, with a piece of dielectric or composite material in front which functions as a converging lens to collimate the radio waves into a beam.[2] Conversely, in a receiving antenna the lens focuses the incoming radio waves onto the feed antenna, which converts them to electric currents which are delivered to a radio receiver. They can also be fed by an array of feed antennas, called a focal plane array (FPA), to create more complicated radiation patterns.
-
product
Combination Antennas
By combining multiple technologies such as GNSS, cellular, and WiFi in a single housing, our combination antennas help you to increase efficiency and coverage for applications such as fleet management, vehicle tracking, and passenger connectivity on the go.
-
product
Vehicular Antennas
Pulse manufactures a diverse line of outdoor automotive antennas. Our ruggedized, built- to-last antennas cover frequencies 136 MHz to 6 GHz, including GNSS and multi-band antennas. Most antennas are available in a variety of mounting styles including NMO, direct mount, glass, and magnetic mounts, and in many different form factors such as low profile, stealth blade, low profile transit, and whips. Pair your vehicular antenna with our wide variety of high performance, high frequency NMO Mounts making your vehicular installation easier while also insuring the best possible antenna performance. Pulse is a leader in automotive aftermarket antennas and has been a main supplier to large Automotive OEM’s for decades. Find your next automotive antenna and NMO Mount today using the product finder below.
-
product
Troposcatter Antennas
Kratos Defense & Security Solutions, Inc.
Troposcatter antennas consist of a reflector structure, feed assembly, and support. Reflectors are precision-formed by aluminum spinning to maintain extremely accurate contour and high performance. Back structures are hot-dip galvanized structural steel. All aluminum parts are corrosion coated and painted.





























