-
product
Interface for Two Dual-Redundant 1760 Channels
EXC-1553PCMCIA/Px-1760
This credit card sized interface supports up to two dual redundant 1760 channels and is compatible with all common variations of MIL-STD-1760 providing a wide range of features normally found only on full size testers. Each channel of the EXC-1553PCMCIA/Px-1760 operates simultaneously as a Bus controller and/or multiple (up to 32) Remote Terminals, or as a Triggerable Bus Monitor. The card supports Checksum, SRQ bit and Header Words as well as error injection and error detection. The card’s smal...show more -
product
Multiport Coaxial Switch, DC to 26.5 GHz, SP6T
87106C
The Keysight 87106C multiport switch improves insertion loss repeatability and isolation, which is necessary for higher performance test systems. The repeatability and reliability of this switch is vital to ATS measurement accuracy and can cut the cost of ownership by reducing calibration cycles and increasing test system up time. The Keysight 87106C terminated multiport switch provides the long life and reliability required for automated test and measurement, signal monitoring, and routing appl...show more -
product
Fleet Management System
PBE Fleet
PBE FLEET, our industry leading Fleet Management System (FMS) extracts, records and presents crucial operational data for the monitoring and management of a mining fleet. This enables all levels of the mining operation to have the knowledge to support quick and effective decisions.PBE FLEET is a suite of specialized software modules running on a rugged Nexis computing platform, which is installed on-board the mining fleet with GPS and wireless mesh capabilities. Nexis links on-board vehicle systems back to the office for real-time management of your fleet. Operators engage through the in-cab screens.
-
product
PCI Card
EXC-4000PCI/xx
Each channel using the M4K1553PxS (RT validated) module operates either as a Bus Controller, Remote Terminal, or Bus Monitor.NOTE: the M4K1553PxS module is NOT compatible to the M4K1553MCH module.The EXC-4000PCI/xx is supplied with C drivers (including source code), Merlin+ Windows software and may be used with Exalt, Excalibur’s Analysis and Laboratory Tools, a Windows monitoring application. Mating connector provided for I/O connection.
-
product
Field-installation Type Dissolved Oxygen Meter (Four-Wire Transmission, Optical Type)
HD-200FL
Optical dissolved oxygen sensor with no electrolyte replacement and rugged membrane.Highly intelligent, including automatic recognition of membrane properties when replacing the sensor cap.The HD-200FL is an optical (fluorescent) dissolved oxygen meter suitable for monitoring aeration tanks used for sewage treatment, effluent treatment, and other processes. Compared to conventional membrane polarographic type sensors, there is no need for electrolyte (internal fluid) replacement or warming, up. ...show more -
product
Maximum Demand Controller
Nippen Electrical Instruments Co.
NIPPEN Maximum Demand Controller offer demand monitoring with date and time of occurrence. The present and predictive demand are displayed separately. The Maximum Demand Controller (MDC) has 4 relays to facilitate tripping of non essential loads.The trip setting is done according to the contract demand offered by the Electricity Board. Demand control is done by 1) Step Demand Control 2) Forecast Demand Control
-
product
Software
Delphin offers a wide range of software solutions for data acquisition, displaying, archiving and analysis as well as process visualization and monitoring. Different product series, each with a different application focus, offer our customers the right solution for their individual measurement task.
-
-
product
Rogowski Coil
INTEGRATORS FOR ROGOWSKI COILS
*High accuracy Class 0.5 (IEC 61869-2)*Combined with LEM ART & ARU class 0.5 Rogowski coils, they offer a universal metering and monitoring solution easily integrated with a monitoring device.*DIN rail mounted.
-
product
Database Performance Monitor
Database performance monitoring and optimization for traditional, open-source, and cloud-native databases.
-
product
Acoustic Doppler Velocimeter
Argonaut-ADV
Providing robust velocity measurements in a compact, easy-to-use package, the SonTek Argonaut-ADV is the ultimate instrument for shallow water flow monitoring.
-
product
Standard Handheld Display
TW-3.0-S
The TW-3.0-S Standard Handheld Display is a modern, slimline, multifunctional load monitoring device which is unique to DLM. This innovative design is built with the user in mind. It has a large, high quality LCD screen which is optically bonded removing the need for a back light and improving clarity in bright sunlight. For ease of use each handheld can be given a customisable friendly name made visible on the screen to make instant identification possible. This multi featured high precision unit ensures reliable load readings while also being simple to operate. It can be used in conjunction with any DLM manufactured load cell, just look for the d+ logo on our products.
-
product
Performance Testing Services
Ensure your system is robust and reliable enough to handle peak loads.If your site is running slow or your system is down, you’re losing money. Using the right tools and best practices for your business, our performance engineers help to avoid system failures for websites, APIs, and mobile apps through load testing, stress testing, performance monitoring, and more. Learn more about our performance testing services below.
-
product
Gas Chromatograph for Analyzing
GC2010D
Chongqing Kailian Yongrun Industrial Co.,Ltd.
Transformer uses oil as coolant and insulator. Gases are formed within the transformer oil due to natural aging, faults from oxidation, vaporization, oil breakdown, electrolytic action or insulation decomposition. Because the transformer oil bathes each internal component, dissolved gases in the transformer oil contain lots of diagnostic information. Meanwhile, the transformer is very expensive to be replaced, so monitoring these gases is very important to know the current quality of transformer or even when the transformer should be removed from service before failure. Presence of each gas composition and its concentration indicates possible failure of transformer.
-
product
cRIO-9030, 1.33 GHz Dual-Core CPU, 1 GB DRAM, 4 GB Storage, Kintex-7 70T FPGA, 4-Slot CompactRIO Controller
783450-01
The cRIO-9030 is a rugged, fanless, embedded controller that you can use for advanced control and monitoring applications. This software-designed controller features an FPGA, a real-time processor running the NI Linux Real-Time OS, and embedded user interface capability. You also can use the Mini DisplayPort to add a local human machine interface (HMI) for application development. Additionally, the cRIO-9030 features an SDHC slot and a variety of connectivity ports, including two tri-speed RJ-45...show more -
product
Safety Relays
*Evaluation units for fail-safe sensors and E-STOP switchgear*Connection of mechanical fail-safe switches and fail-safe sensors*Evaluation systems for safe rotational speed or standstill monitoring
-
product
Automatic Cleaning and Calibration
Knick Elektronische Messgeräte GmbH & Co. KG.
Fully automatic process monitoring in combination with the analysis measuring system Protos and the retractable housings SensoGate or Ceramat. Highly accurate measurements even under difficult process conditions such as high pressure, high temperatures and high levels of impurities.
-
product
Thermometer
H0530
Sensor H0530 is designed for online monitoring of temperature. Three binary inputs to detection of two-states signals are the advantage. Other devices are controlled by two relay outputs.
-
product
Aggregator Network TAPs
Aggregator/regeneration network TAPs are used to capture 100% full duplex network traffic; the traffic can then be sent to multiple monitoring appliances to analyze your network. Aggregation TAPs support breakout and regeneration/SPAN modes and let you see every bit, byte and packet.
-
product
Laser energy meter with high dynamic range
PM 200
In the past laser energy meters often required a whole selection of pyroelectric detectors for measuring different energies. From this point of view the PM 200 is a very modest instrument. A single detector enables monitoring of energies from the detection limit at 3 ?J up to highest energies of 200 mJ. The active sensor area with an aperture diameter of 34 mm ensures simple and reliable alignment for the detection of large beam profiles.?
-
product
NI-9232, 3-Channel, 102.4 kS/s/channel, ±30 V, C Series Sound and Vibration Input Module
782000-01
3-Channel, 102.4 kS/s/channel, ±30 V, C Series Sound and Vibration Input Module - The NI‑9232 can measure signals from integrated electronic piezoelectric (IEPE) and non‑IEPE sensors such as accelerometers, tachometers, and proximity probes. The NI‑9232 is also compatible with smart TEDS sensors. The NI‑9232 incorporates software-selectable AC/DC coupling, IEPE open/short detection, and IEPE signal conditioning. The input channels simultaneously measure signals. Each channel also has built-in an...show more -
product
Wireless Gateways
Networked Communication Solutions, LLC
Allows your NCS wireless sensors to communicate with the NCS Online Wireless Sensor Monitoring and Notification System.
-
product
MultiStandard Advanced Monitoring Probe
EdgeProbe Advanced MultiStandard
The ideal tool for accurate & cost-effective monitoring probe for:DTV terrestrial transmission (DVB-T/T2, ISDB-T/Tb)DTV cable transmission (DVB-C/C2)DTV distribution over satellite (DVB-S/S2, T2-MI, OneBeam, MPTS)DTH uplink and reception (DVB-S/S2, MPTS)Digital Radio transmission (DAB/DAB+/T-DMB)Combine any two RF standards in one single 1RU device.Combined with a Network Monitoring System or not, the EdgeProbe Advanced provides a powerful broadcast network alert & diagnosis tool allowin...show more -
product
Charger/Discharger Complex
K-3986
Kongter Test & Measurement Co., Limited
K-3986 is not only a battery charger or load unit for battery String. It is comprehensive unit with one-stop-solution for battery maintenance. With charging and discharging for the same battery string, it will greatly simplify your maintenance for batteries. Extra functions like wireless online monitoring and battery activation will enable you to know your batteries comprehensively. With optional DAC, you could also have a real time monitor for the whole process of measurement.
-
product
Internal Temperature-40 to +85C
TGIS-0017
This model is battery powered and measures temperature using a built-in sensor, providing cost-effective environmental monitoring ideal for inaccessible locations.Features include robust casing, two user-programmable alarms and multiple start / stop options. Data recorded by the TGIS-0017 is downloaded to PC via a cable; no expensive base station is required.
-
product
Passive Diagnostics Solution
EtherTAP2
EtherTAP2 is a monitoring interface that enables the in-depth analysis of PROFINET and EtherNet/IP traffic. Just like its highly popular predecessor, it acts as a bridge between your industrial network and our Osiris diagnostics platform. However, its newly designed housing and improved functionality guarantee the early detection of communication errors and give round-the-clock access to passive diagnostics.
-
product
Gaming Platform Based on AMD Ryzen™ Embedded R1000/V1000 Series Supports up to Eight Independent Displays Including 4K UHD
ADi-SA2X-RZ
ADi-SA2X-RZ all-in-one gaming platform features powerful processing and graphics performance for gaming infotainment and retail. Equipped with AMD Ryzen™ Embedded R1000/V1000 Series, the ADi-SA2X-RZ provides compelling graphics performance from a Radeon™ RX Vega Graphics and/or a PCI Express 3.0 x16 discrete graphics card together with multi-display support for up to eight independent monitors. With the powerful processing performance, advanced security functions, smart middleware solutions, and...show more -
product
All-Purpose Radionuclide Identification Device
identiFINDER® R4xx Series
With over 20,000 devices deployed globally, the identiFINDER® R400 is the most widely deployed handheld radionuclide identification device (RID) in the world. It is used to detect, locate, measure, and identify radioactive sources and produces rapid visible, audible, and tactile alerts that expedite response measures. The identiFINDER R400 provides operators the ideal balance of size and weight for a wide variety of monitoring scenarios including all-purpose surveying, emergency response, and environmental monitoring.
-
product
Audio Loudness Monitoring And Logging System
The Mividi® Audio Loudness Monitoring and Logging System (Loudness Logger) provides a cost-effective solution for broadcast compliance monitoring and logging. It is a Windows PC based system that supports audio decoding, loudness monitoring and logging, log file management and playback. It takes transport stream input from UDP over IP or ASI interfaces, as well as Internet OTT streaming input using HLS, RTMP, RTSP, and MPEG-DASH protocols. A single system can support continuous monitoring and recording over 50 channels simultaneously.
-
product
Wired Hazard Monitoring
Grain dust is extremely volatile and can easily explode with the proper ignition source in confined spaces. OSHA has mandated that grain elevators in Class II, Division 1 environments must have the 3 monitoring sub-systems for elevator safety (1910.272(q)(4)(ii), 1910.272(q)(5), 1910.272(q)(5)).
