Product

Incremental > Standard Encoders - Hollow Shaft

-

SCANCON

SCANCON

Incremental > Standard Encoders - Hollow Shaft

Product

ATTR Auto Transformer Turns Ratio Tester

-

Chongqing Assen Power Equipment Co., Ltd

Chongqing Assen Power Equipment Co., Ltd

Transformer turns ratio tester is a new type of fully automatic tester that uses modern electronic technology to measure the ratio of single-phase and three-phase transformers, and does not require any manual “zero” balance.

Product

Standard IR Target Projectors

-

Santa Barbara Infrared, Inc.

Santa Barbara Infrared, Inc.

Santa Barbara Infrared’s 14000Zi Series reflective infrared target projectors are turnkey test systems for electro-optical (E-O) testing of FLIRs and other infrared (IR) imaging systems. The standard target projectors are assembled from SBIR’s STC Series Collimators, Infinity Blackbodies and 300 Series Target Wheels. SBIR also offers a standard athermal target projector with a 5.7° field of view (FOV).

Product

Electron Multiplication (EM) Standard Image Sensors

-

Teledyne e2v

Teledyne e2v

EM (Electron Multiplication) is a technology that uses on-chip gain in the charge domain to effectively eliminate read noise from an image sensor. This enables advanced ultra-low light applications that require extreme sensitivity at fast frame rates. Examples include life science applications such as single molecule detection, super resolution microscopy and spinning disk confocal microscopy along with physical science applications such as nanotechnology imaging, Bose Einstein condensates and soft X-ray spectroscopy, and astronomy applications such as adaptive optics and lucky imaging. The inclusion of an additional conventional output allows further flexibility for applications such as true 24 hour surveillance.

Product

Injection Transformer

J2101A

-

PICOTEST Corp.

J2101A - PICOTEST Corp.

The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the FRA inputs require attenuation probes.

Product

Dytronic Primary Transfer Ultra Stable Standard

RD-22 Ultra

-

Radian Research, Inc.

RD-22 Ultra - Radian Research, Inc.

The RD-22 Dytronic Primary Transfer Ultra Stable Standard represents the state-of-the-art technology in a commercially available AC transfer reference. The Ultra Stable RD-22 is a variant of the RD-22 Primary Transfer Standard that has been optimized for 120/240 V @ 5A operation to provide optimum stability. In a stable test environment, repeatability for a 10-second test of ±0.6 µWh/VAh is attained at 120 V and 240 V at 5A inputs with a 95% confidence interval. A typical experimental 2 repeatability of less than ±0.25 µWh/VAh is achieved. In a stable test environment, a reproducibility of ±2 µWh/VAh over a five-day interval is attained at 120 V and 240 V at 5A inputs with 95% confidence interval.

Product

High Impedance Transformers

-

Osborne Transformer Corp.

Osborne Transformer Corp.

Osborne high impedance transformers are used to step-up, step-down and isolate voltages in single phase and three phase circuits. A properly designed high impedance transformer can be used an an equivalent to an isolation transformer connected in series with an inductor. The high impedance characteristic may be employed as a current limiting feature in both the primary and secondary circuity.

Product

Instrument Transformer Calibrators

CTPT 81

-

UDEYRAJ ELECTRICALS PRIVATE LIMITED

CTPT 81 - UDEYRAJ ELECTRICALS PRIVATE LIMITED

Tests: Ratio error. Excitation current and curve. Polarity CT / PT TESTER

Product

BDV Transformer Oil Test Sets

-

Neutronics Manufacturing Co.

Neutronics Manufacturing Co.

NMC''s Transformer BDV Oil Test Set is a portable unit as per relevant Indian Standard Specification IS :6792 :1992, suitable for operation on 230 / 240 Volts, A.C. 50 Hz. A three core flexible cable is connected to the unit with three pin socket to connect the mains. The H.V. Transformer is a completely dry, resin encapsulated with two H.V. terminals with mounting saddles. The center point of the transformer is earthed, so that the voltage of each terminal to earth is only half the test voltage.

Product

Single Phase Reference Standard Meter

-

Signals & Systems India Private Limited

Signals & Systems India Private Limited

The Single Phase Portable Reference Standard (SPRS-1102) from SANDS is a portable meter test equipment that helps to calibrate the error present in the single-phase energy meter i.e. the meter under test (MUT). The SPRS supports both static and electro-mechanical types of meters. It can also be used to compute the voltage, current, energy, phase angle etc of the meter under test. It has an LCD display and an alphanumeric keypad to suit the user. It can be interfaced with the PC for analysis. It has the capability of storing 1000 test results.

Product

Fourier Transform Optical Spectrum Analyzer, 350 - 1100 nm

OSA201C

-

Thorlabs, Inc.

OSA201C - Thorlabs, Inc.

Thorlabs' Optical Spectrum Analyzers (OSAs) perform highly accurate spectral measurements. Compatible with fiber-coupled and free-space light sources, these compact benchtop instruments suit a wide variety of applications, such as analyzing the spectrum of a telecom signal, resolving the Fabry-Perot modes of a gain chip, and identifying gas absorption lines. Many commonly available OSAs use grating-based monochromators, which have slow acquisition times due to the need to mechanically scan the grating and average out noise at each wavelength. Thorlabs' OSAs acquire the spectrum via a Fourier transform using a scanning Michelson interferometer in a push/pull configuration. This approach dramatically improves the acquisition time, enables a high-precision wavelength meter mode with 7 significant figures and ±1 part-per-million accuracy, and allows the included software to provide robust statistical analysis of the acquired spectra, as explained in the Design tab.

Product

Fourier Transform Infrared Spectrophotometer

IRTracer-100

-

Shimadzu Corp.

IRTracer-100 - Shimadzu Corp.

This system achieves excellent sensitivity with an SN ratio of 60,000:1, high resolution at 0.25 cm-1, and high-speed scanning capable of 20 spectra/second. The performance of medium and higher end models is supported by high reliability including advanced dynamic alignment and an interferometer with a dehumidifier. This is compatible with applications active in a variety of circumstances, with a library of approximately 12,000 spectra and data analysis programs for contaminant analysis, and time course and rapid scan programs for reaction tracking.

Product

Instrument Transformer Comparator

PMT20010

-

Power Measurement Technologies Inc.

PMT20010 - Power Measurement Technologies Inc.

The PMT20010 Comparator is an automatically balancing bridge that measures the accuracy of instrumentation potential and current transformers.

Product

Standard VXI Module Shield Kits With Address Switch Opening

-

ICS Electronics

ICS Electronics

* Single-slot kit fits all VXI-1 Revision 1.0 to Revision 3.0 chassis.* Clamshell design fits C-size modules with 96-pin connectors.* Side shields include connector shrouds for maximum shielding.* RFI limiting, air vent slots along top and bottom edges for good air circulation thru the module.* Extruded front panel is bend resistant.* Address switch opening on component side shield.* Complimentary layout support includes PCB design template and CAD layout files.

Product

Transform Imagery into Geospatial Understanding

Feature Analyst™

-

Textron Systems

Feature Analyst™ - Textron Systems

Textron Systems' Feature Analyst is tightly integrated with the Esri® ArcGIS® platform to extract feature data from imagery in order to populate geographic information systems (GIS) databases. Analysts can rapidly and accurately collect vector feature data from high-resolution satellite and aerial imagery in order to gain spatial understanding.