Dip Meters
See Also: Antenna Measurement
-
Product
Field-installation Type MLSS Meter (Four-Wire Transmission)
HU-200SS
-
HU-200SS connects immersion type MLSS sensor (SS-90) and measures MLSS in activated sludge. A wide range (0-2000mg/L)of SS contents can be measured with excellent reproducibility using the near-infrared radiation transmission method. Any of the calibration curves of MLSS, Clay (inorganic mud) and Kaolin may be used as standard substances of SS. If "MLSS" is selected for an activated sludge treatment tank, "Clay" for the precipitation treatment of construction sludge, or "Kaolin" for white mud, a concentration can be obtained closer to an analyzed value.
-
Product
Miliohm Meters
-
Measures low resistance to detect faulty connections that degrade electrical system performance.Prevent electronic failures.
-
Product
Humidity/Temperature Meter
-
Measure the relative humidity and temperature in a tire with the tire humidity/temperature meter.
-
Product
Resistivity Meters
-
Periodic compliance checks of ESD work surfaces are super important. Monitors only verify the ground plane, or path to ground. The surface itself can wear down, become dirty, or if you use low quality mat—just not hold up. A handheld Surface Meter is great for running monthly, or prescriptive compliance verification of your ESD surfaces.
-
Product
Tachometers/Torque Meters
-
Tachometers measure rotational or linear speed and come in two styles: contact and non-contact. Contact models come with various rubber/plastic adapters for interfacing the instrument’s shaft with the surface of the spinning or moving surface under test. Non-contact models come with reflective tape that is placed on the surface to become the target of the instrument’s low-power laser.
-
Product
Microscopic Melting Point Meter
DRK8030
-
Shandong Drick Instruments Co., Ltd.
Heat transfer material is a silicone oil, in full compliance with USP standard measurement method can simultaneously measure three samples, direct observation of the melting process can be measured colored samples.
-
Product
Power Supply for Watthour Meter Test
DAC-3100
-
DAC-3100 is a power supply system that can generate precise and stable power under electronic-burden conditions for watthour meter tests.This system has the Touch-Panel Control unit, and you can control it via PC.
-
Product
LCR Meter
MCR-6000A Series
-
MCR-6000 Series is a new generation of high precision and high stability of boutique LCR meter with a 4.3 inch 480*272 TFT display screen.
-
Product
Clamp Meters / Clamp Current Transformers
Earth clamp meter
-
A specialized electrical testing tool used to measure ground loop resistance, leakage current, touch voltage, and loop inductance without needing to disconnect the grounding system.
-
Product
Portable pH Meter
Starter 300
-
This portable meter offers convenience, reliability and durability in one compact design.
-
Product
Voltage Dip & Swell Simulators
VDS Series
-
A simulator to reproduce voltage variation phenomena in commercial power supplies (AC100V/200V).This type of immunity test against voltage variation phenomena is defined in IEC 61000-4-11 and is widely used in many industries.
-
Product
Turns Ratio Meter
Model TRM200
-
Turns Ratio Meter Model TRM200 is widely used in transformer industry in manufacturing and repairing service. It directly display the ratio of LT turns & HT turns. It is capable to measure turns ratio till 1:1200. Turns ratio meter is designed to be a rugged and reliable. It is equipped with stable 250mA source. The design is based upon in-house invented & patented technology. TRM200 has also option for 1amp current source on demand.
-
Product
AC/DC Clamp Meter
ST-3600
-
Standard Electric Works Co., Ltd
● 3½ digit LCD with maximum reading of 1999.● Over range indication : "1" is displayed on highest digit.● Low battery indication: "B" sign appears on the display.● Response time: approx. 1 second.● Data hold: for all ranges
-
Product
Single-Phase Transformer Winding Resistance Meters
RMO-TW Series
-
RMO-TW series is perfect for winding resistance measurements of inductive objects. It is ideal for testing transformer windings (power transformers, distribution, autotransformers) and for on-load tap changer verification. In addition, any RMO-TW transformer ohmmeter & tap changer analyzer can also perform transformer demagnetization.The series contains 4 models, with maximal test currents from 10 A (RMO10TW) to 50 A (RMO50TW). They are fitted in a portable and lightweight metal housing.All transformer ohmmeters from RMO-TW series generate a true DC ripple-free current with automatically regulated measurement and discharging circuit. The injection of current and discharge of energy from the test object are automatically regulated.Three independent channels enable testing of three windings in series. Consequently, this enables measurements of winding resistance in every tap position of an on-load tap changer without discharging between the tests.DV-Win software enables control and observation of the test process, as well as saving and analyzing the results on a PC. It provides a test report, arranged in a selectable form as an Excel spreadsheet, PDF, Word, or ASCII format. Additionally, DV-Win measures and calculates the OLTC transition time, the ripple and the winding resistance for each tap changing operation. The software can also perform the calculations necessary for the “Heat Run” test. Finally, a user can export all results in the form of a report.
-
Product
Model B: Concrete Moisture Meter
MRC003305
-
Specifically designed for the concrete block industry. Includes calibrations for over 34 different kinds of concrete block. Direct reading scales for average percent moisture content.
-
Product
Handheld QQ Meter
-
DC current: 25/250mADC voltage: 0.5/2.5/10/50/250/500VAC voltage: 10/50/250/500VResistor: R x 1/R x 10/R x 1kSpecial functions:Low battery displayAnti-drop protective pouchesMulti-protective circuitGeneral characteristics:Colors: grey and yellowNet weight: approximately 130gWindows size: 54x44mmSize: 110x76x25.5mmPower: 1 x 1.5V, 7#
-
Product
Field-Installation Type ORP Meter (Four-Wire Transmission)
HO-200
-
HO-200 connects ORP sensor and measures ORP and temperature in the sample water. It is suitable for neutralization reaction treatment management of aeration tank, denitrification tank, etc.
-
Product
Absolute Moisture Meters
-
Explore PCE Instruments' absolute moisture meter offerings. Our absolute moisture meter products can measure relative air humidity, while our combination devices can also measure temperature. Each absolute moisture meter measures different ranges of humidity, depending on the model. Relative humidity is an important factor in everything from gardening to transport and industry.Our absolute moisture meter products are versatile, as they can take measurements, store the data to memory and transfer the data to a computer for detailed analysis. Different moisture probes that correspond to the materials to be measured can be connected to each absolute moisture meter. For most of the materials, you will find calibration curves within the internal memory of our absolute moisture meter products. You then only need to select the appropriate calibration curve for the material you wish to measure.
-
Product
Transformer Winding Resistance Meters
-
Vanguard Instruments Company, Inc.
The TRM-40 is Vanguard Instruments’ third generation transformer winding resistance meter. The TRM-40 is designed specifically to measure DC resistance values of transformer windings, rotating machine windings, or any dc resistance of an inductive device.
-
Product
FibreSeek | PON Power Meter
TP40
-
Testing in the FTTx environment just got easier with Yamasaki’s latest piece of PON Test Equipment, the TP40 FiberSeek FTTx PON Power Meter. The TP40 includes FTTH PON Testing, 6 Wavelength Optical Power Meter & Visible Fault Identifier all in one unit. This rugged hand held unit includes a removable rubberized boot; bright backlit LCD; auto shut off function; wide measurement range; upstream burst mode; accurate testing and bright flashing VFI.
-
Product
Non-Contact Displacement Meter
VT-5200/5700 series
-
By combining the latest developed VE series Electrostatic capacitance-type Gap detector, the Electrostatic capacitance-type Non-contact Displacement Meter VT series can measure the gap/displacement between a measurement target (conductors such as iron, aluminum, copper, and various metal plating) and a sensor with high accuracy without contact.
-
Product
Lake Paddle Wheel Flow Meters
-
Operating much like a turbine flow meter, the paddle wheel flow meter consists of a freely rotating wheel which is outfitted with magnets on the blades or “paddles” of the wheel. As the fluid flows through the meter, spinning the wheel, sensors detect the magnets with each pass.
-
Product
Sound & Noise Meters
-
Lutron Electronic Enterprise Co., Ltd.
portable, handheld instruments with calibrated microphones that measure real-time noise levels in decibels (dB), simulating how the human ear perceives sound
-
Product
SF6 Density Meter Tester
JHMD-1
-
Xiamen Jiahua Electrical Technology Co.,Ltd
JHMD-1 is a smart tester. By using high accuracy core units, pressure sensor, A/D, D/A transducer, 32 bit ARM MCU and TI company’s high speed signal chip, it can automatically calibrate the density relay, measure pressure at signal activity temperature, convert pressure from any temperature to 20℃ standard pressure, print test data and save for review. It identifies the fault during the test. The whole procedure is under automatically operation, JHMD-1 is a high accurate, high stable, reliable tester.
-
Product
Pocket Chroma Meter
CHROMA-2
-
CHROMA-2 Pocket Chroma Meter is developed based on TOSHIBA TCD1304DG linear array CCD detector. It makes traditional laboratory instrument available for the production on-line quality acceptance, thus greatly improved the efficiency of fluorescent lamp, CFL, LED.
-
Product
Half-Cell Meter
331HM
-
These easy to use Elcometer 331 Half-Cell Meters measure the condition and potential corrosion of rebars and steel structures within concrete.
-
Product
LCZ LCR Meter
SS1061
-
LCZ Meters are a test system for passive components designed for the use in electronic inspection or production process for quality control. They meet any demanding requirement on production speed and precision, discrimination of qualified products from unqualified ones, as well as internal setup, storing and calling function for up to 10 instrument groups, so they are actually optimum test instruments for component incoming and production inspection. Like as: transformer, inductor, resistor, capacitor, relay, motor, generator, eletric valve, contactor,cable,wire,etc.
-
Product
U Series & Thin Edgewise Panel Meter
ST-58E
-
Standard Electric Works Co., Ltd
● Movement : Taut Band suspension type.● Accuracy : ± 2.5%● Mounting : Horizontal or Vertical● Pointer : Tube (Red)● Full Scale Deflection : 60˚● Measuring Range : F.S. 1mA DC. Customer’s specs are available
-
Product
Burris Gravity Meter
V-Grav
-
The new control app designed for Android Tablets now has several new features: Visually monitor the Beam and Levels during measurements. The new Survey feature allows for sequential numbering of stations. Data files can now be viewed on the tablet for in the field Quality Control. Easily add various filters during measurements in noisy environments. GPS functionality. Transfer data to a computer via cable transfer or email with ease. Saved files will not be lost in case of loss of power to the tablet.
-
Product
Voltage Meter MDN8I-PXIe
MDN8I-PXIe
-
The MDN8I-PXIe module is made in the PXIe standard and is designed to measure instantaneous voltage values over eight isolated channels with differential inputs.
