Temperature Chambers
Life test cycling of temperature accelerating electronic degradation.
See Also: Environmental Chambers, Chambers, Humidity Chambers
-
Product
Temperature Transmitter
T4111
-
Transducer is designed for temperature measurement at C or F by means of an externaltemperature probe with Pt1000 sensor. Measured temperature is converted to linearized unified signal 4-20 mA. Measured values are displayed on LCD display. It is possible to switch OFF theLCD at all. Current loop has two-wire connection and requires power from evaluation device.
-
Product
Anechoic Chambers
-
Eckel Noise Control Technologies
Anechoic Chambers are echo-free enclosures with a sound energy absorption level of 99% to 100%, or a reflected sound pressure level of 10% or less. The frequency at which the energy absorption drops below 99%, or the pressure reflection exceeds 10%, is known as the low-frequency cut-off. Sound absorption is obtained by lining the walls, ceilings, and floor with wedges or other sound absorbing elements or SuperSoft panels, depending on performance level required and cut-off desired.
-
Product
Temperature and Humidity Regulator
H3331-2
-
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy. Three two-state inputs.
-
Product
Reach-In Temperature Environmental Chamber
-
Burnsco Environmental Test Chambers
Our popular reach-in chambers have been designed for maximun testing flexibility while remaining a standard, cost saving unit.
-
Product
Temperature Control Battery Short Circuit Test Chamber
-
Guangdong Bell Experiment Equipment Co.,Ltd
DGBELL'S Temperature control battery short circuit test chamber is designed to comply with standard. According to the short-circuit test requirement, the short-circuit must be less than 5 mΩ to achieve maximum curren.
-
Product
LilyPad Temperature Sensor
-
Detecting temperature changes has never been easier. The MCP9700 is a small thermistor type temperature sensor. This sensor will output 0.5V at 0 degrees C, 0.75V at 25 C, and 10mV per degree C. Doing an analog to digital conversion on the signal line will allow you to establish the local ambient temperature. Detect physical touch based on body heat and ambient conditions with this small sensor.
-
Product
TSD-101-W Chambers Chambers
-
ESPEC developed the TSD-101-W with an large interior of 28"x16", while strictly limiting the overall size of the system. The footprint is reduced by 40%, as well as lowering power demand by 60% compared to conventional units.
-
Product
Drive-In Chambers
-
Environmental testing of automobiles requires additional consideration of the facility where the chamber will be installed, and its planned use. Test methods for vehicles can include additional conditions besides temperature and humidity in an attempt to simulate real-world conditions.
-
Product
Temperature and humidity duct probe
T3113
-
Relative humidity, temperature sensors at 150mm stem. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
Product
Greenhouses And Growth Chambers
-
Understanding Plant Health and Light Management Starts with Accurate Measurements
-
Product
Digital Temperature Switch
TS
-
The TS Digital Temperature Switch is designed to regulate many heating and cooling applications. Easy programming via the tactile front keypad enables quick setup of the 12 parameters for simple, reliable operation.
-
Product
Stability Chambers
-
Lunaire Environmental is a leading manufacturer of steady state and shelf life testing chambers and walk-in rooms which provide constant climate testing and meet ICH guidelines. These steady state chambers and rooms are perfect for long-term material testing on packaged products in controlled temperature storage. Lunaire steady state climatic test chambers are also ideal for research facilities and laboratories because they simulate wide range of temperature, and temperature and humidity environments. Click here for an overview brochure on Tenney and Lunaire equipment offerings.
-
Product
Combined Pressure and Temperature Transducers
-
We can offer some different styles of Combined Pressure and Temperature Transducers. The EPTT5100 combined pressure and temperature transducer has an internal temperature sensor. The miniature EPTTE1400 combined pressure and temperature transducer has an external temperature probe.
-
Product
IP X1, X2 Chamber - Drip/IP Test Chamber
-
The drip box testing chambers from Weiber are rain test machines used for testing the outer protection of signal devices, external lighting equipments and car lamps etc. The equipment finds widespread usage in electronics industry and automotive and aerospace industries and is commonly employed for quality testing of products. The test chamber comprises of the guiding upright column, a drip mold, a rotating sample table with adjustable speed and a level meter to allow observation of the level in the drip mold. The equipment uses high quality construction materials for a sturdy construction and is designed for safe and reliable operation. The guiding upright column is made up of high-quality, plastic coated square steel pipe, whereas the drip mold is made up of high-quality stainless steel finish plate undergoing knurling.
-
Product
Temperature Logger for Thermistor Probe
TGP-4020
-
Loggers with probes can be used to record temperature in awkward to reach areas or applications where a fast time response is required. A versatile range of probes are available for this unit and can measure between -40 to +125C. Like the logger, probes are waterproof to IP68.
-
Product
Thermal Vacuum Chamber & Control
-
Based on several successful deliveries of complex DAQ systems, WinSoft was selected by 2 major satellite manufacturers to design and build a DAQ and Control systems which are connected to various thermal vacuum chambers - all connected to a central database.The chambers are used for environmental testing. The data collected by the DAQ system is recorded continuously every few seconds over a period of a few months.
-
Product
IP X7, X8 - Waterproof Test Chamber
-
The IP X7 and IP X8 test equipment simulates the water immersion environment to test the water resistance and sealing of the samples during storage, transportation and usage. It is widely applied to electrical and electronic products, lamps and lanterns, electrical cabinet, electrical components, automobile, motorcycle and its spare parts and other products. It provides the basis to improve the performance of the products.
-
Product
High Temperature Accelerometer
HA602-A100
-
Charge Amplifier for use with CM362 High Temperature Accelerometers, Acceleration
-
Product
High Temperature Chip Resistors
ERJ-Hxx Series
-
Panasonic Industrial Devices Sales Company of America
Panasonic’s ERJ-Hxx Series Automotive Grade Thick Film Chip Resistors feature a maximum Category Temperature of 175°C and a maximum Rated Operating Temperature of 105°C. The ERJ-Hxx Series is AEC-Q200 compliant, ensuring strict quality control standards are in place to enforce optimal quality and reliability. The ERJ-Hxx Series Resistors offer a small size, higher power Resistor alternative that provides enhanced flexibility of PCB design by reducing solder-joint crack risk. This series is ideal for use in automotive, ICT, general industrial applications, and more.
-
Product
Dual Stage Temperature Switch
TSS2
-
Regulate temperatures for heating or cooling control with the Series TSS2 Dual Stage Temperature Switch. The Series TSS2 is designed to accept two inputs with independent relays output for dual stage temperature control.
-
Product
Temperature Transmitter
T4211
-
Transducer is designed for temperature measurement at C or F by means of an externaltemperature probe with Pt1000 sensor. Measured values are displayed on LCD display. It ispossible to switch OFF the LCD at all.
-
Product
In-situ Wafer Temperature Monitoring
-
CI Semi's family of noncontact temperature monitors (the NTM line), offers high end pyrometry products for the measurement of wafer temperatures during process. CI Semi’s flag ship of the line, the NTM Delta, incorporates real-time, same point emissivity measurement and compensation making it the ideal solution for in situ monitoring for processes such as RTP, CVD and PVD. The NTM family is sold to leading tool manufacturers.
-
Product
Temperature and Humidity Regulator
H3431-4
-
Relative humidity, temperature probe on a cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy. Three two-state inputs.
-
Product
Thermostatic Chambers
-
Various test devices are available for tensile, bending and compression testing in specific environments.
-
Product
Walk-In Chambers And Drive-In Chambers
-
CSZ Walk-In Chambers are available in a variety of models and sizes to meet virtually any requirement and/or test application. These chambers are typically used for testing or storing products that require a large capacity chamber.
-
-
Product
Interior Temperature Transmitter
T0318
-
For exacting interiors in building energy management and HVAC systems. Are designed for easy installation on ordinary KU68 wiring boxes for household switches and sockets.
-
Product
Environmental Test Probe, Temperature
72-8366
-
Simple thermocouple junction at the end of a 1m wire provides effective low cost ambient temperature measurement. It is suitable for measuring air temperature and may be placed in direct contact with hard surfaces. Type K thermocouple temperature probes are commonly used with all types of industrial temperature controls and measurement equipment, and are compatible with Tenma handheld thermometers and digital multimeters that include temperature function. All are terminated with standard Type K plugs.
-
Product
Certified Refurbished Environmental Test Chambers
-
LR Environmental Equipment Co. Inc.
LRE is the Only Company that Offers CERTIFIED Refurbished Environmental Test Chambers and Industrial Ovens. When purchasing environmental chambers or Industrial Ovens, you generally have two choices, new or used. Now there's a third category, LRE Certified Refurbished. Although they're not new, these LRE Certified Refurbished environmental chambers and ovens are as close to new standards as you can get.
-
Product
Multi-points Temperature Tester
-
Shenzhen Chuangxin Instruments Co., Ltd.
TP series of multiplex temperature meter is a kind of instrument which suits to real time monitor and trace multi-points temperature simultaneously. With the features of Simplified operation, high precision and reusable thermocouple, it is widely applied in electronic ballast, motor tools, lighting fixtures and household appliances. The application software records and save the temperature rising curve in real time for analyze purpose.
