Gas
1) fills any space it's contained in and is amorphous. 2) liquid fuel powering vehicles.
See Also: Dissolved Gas, Gasoline, Ammonia
-
product
Natural Gas Analysis
Recently, natural gas has been recognized as a clean resournce for energy, in addition to being a raw material for chemical products. Recently a cutting-edge drilling technology has increased the use of shale gas. As the production area diversifies, the need for gas composition analysis has increased. Shimadzu addresses analytical requests with a wide system GC lineup. For analysis of liquified gas, such as LPG, a dedicated injector with a vaporizer is available. Both manual injection and online injection are available. The operation software can automatically calculate needed values, such as indexes, calorific values, etc.
-
product
Inductively Coupled Plasma Mass Spectrometer
ICPMS-2030
With its newly developed collision cell and optimized internal structure, the ICPMS-2030 provides superior sensitivity. At the same time, thanks to the adoption of its proprietary mini-torch unit and provision of an Eco mode, the quantity of argon gas needed for analyses has been greatly reduced to the industry's lowest levels. As a result, low running costs are assured. The Development Assistant function of the software automatically sets the optimal analysis conditions for quantitative analysis. Then, after measurements are complete, the Diagnosis Assistant function automatically checks the validity of the necessary data. While reducing the burden on the user, the efficiency of analyses is enhanced and the reliability of the data can be increased. It complies with FDA 21 CFR Part 11.
-
product
High-concentration, High Flow Ozone Generator
SEMOZON® AX8407
The SEMOZON AX8407 generator converts pure oxygen into ozone through silent electrical discharge and achieves high output and high concentration level. It requires only minute levels of dopant nitrogen gas, far below the levels required for competitive ozone generators. As a result, the presence of contaminants, e.g. NOx compounds, is extremely low.
-
product
Dual Surge Current Generator
MIG0624T-K12
Designed for testing telecom surge protection devices according to ITU-T K12. The generator has two indepedent impulse outputs which allow testing of two and three terminal protection devices such as gas discharge tubes (GDT). The generator can be configured for two terminal devices or with the outputs in parallel to increase the current impulse for two terminal devices.
-
product
Conventional Extractive System
ML660
The Teledyne ML®660 conventional extractive system is designed to extract and condition hot, wet stack gas for a dry basis measurement of any combination of SO2, NOx, CO, CO2, and O2. This system can be configured specifically for 40CFR60, 40CFR63, 40CFR75 compliance, and process control applications.
-
product
Hydraulic testing solutions for Engineering Components
The unit illustrated to the left here allows automatic pressure testing of gas cylinders to BS and DOT standards. The system includes automatic weighing, filling, testing to 500 bar with expansion measurement, and full mechanical handling for up to 180 gas cylinders per hour.
-
product
24" Rackmount Drawer with Keylock, Unshielded, 7"H x 20"D
DR-072420-K
Unshielded drawers are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock
-
product
Oxygen Analyzer
DT3000
The Datatest Model DT3000 is a Zirconia sensor, microprocessor based, oxygen analyzer. The DT3000 comes with probe configurations for temperatures up to 3200F. The microprocessor based controller provides long-term stability and reliability, plus optional features for controlling back purge, calibration gas injection, and self-calibration. 4 - 20 mA output and Modbus RTU serial port are standard. The DT3000 is available in either a NEMA 4 wall mount or panel mount configuration.
-
product
Chemical Analysis and Corrosion Testing
Performing chemical analysis of metal alloys including both ferrous and non-ferrous alloys.Chemical analysis involves determining the chemical constituents of metals and related materials.An industry leader and co-operating laboratory for qualifying Calibration Standards for Chemical Analysis.Our chemical laboratory processes include Spectroscopy – Optical Emission Inductively Coupled Plasma, gas analysers, wet chemical, Intercrystalline/ Intergranular Corrosion (including G28, G48 etc).
-
product
Micro-Baratron® Pressure Transducers
Micro-Baratron® pressure transducers are ideally suited for use in delivery systems that feed ultrapure gases to critical process systems. Their wetted surfaces exposed to the gas stream have a finish of better than 5 µin Ra. These transducers exhibit superior dry-down characteristics, and contribute no particles above background.
-
product
Power Meter
8015 PM
Standard Electric Works Co., Ltd
● Determine the running cost of your appliances.● Measure voltage, current, frequency, watt, power factor, and greenhouse gas emissions.● Optical USB to RS-232 data transmission.● 2 Optical LEDs are built-in for data transfer.● Transferring and showing real-time data to a PC.● Make informed decisions when purchasing appliances and equipment.● Reduce your electricity bill.● Calculate electrical expenses by real, hour, month. ● Can make different kinds of plugs for different countries / areas, such as Type B, E, G, I plugs.....etc.● Data communication function.● Freely set upper and lower limit for V,A,W and alarm when measured value is out of limit.● Backlight function.
-
product
High Pressure Gas Conditioners
HPG
Bemco HPG, High Pressure Gas Conditioners are similar to the PTS Portable Temperature Conditioners except they are designed for continuous operation at up to two atmospheres (29.4 psia) of pressure. This higher base operating pressure doubles the gas density per cfm of circulating air or gaseous nitrogen allowing the use of smaller connecting tubes while also increasing thermal capability. .
-
product
Flow Monitor
Deltaflow 180
The DeltaFlow® 180, measures volumetric flow from smoke stacks or pipes for process and compliance applications; it is a complete flow monitoring solution with easy installation in all applications including those with elevated temperature, particulate loading and corrosive gas concentration.
-
product
Soil Analysis
We offer a full spectrum of analytical technologies, and sample clean up and moisture extraction reagents, designed to provide reliable, accurate, and precise results that make compliance easier and help you reduce regulatory risks. Organic Elemental Analysis, Trace Elemental Analysis, X-Ray Fluorescence (XRF) Spectrometry, Automated Discrete Photometry, Gas Chromatography Mass Spectrometry (GC-MS), Accelerated Solvent Extraction (ASE).
-
product
Silicon Based Thermopile Detector: 4 Channels
ST120 Quad
A four-channel silicon-based thermopile in a TO-5 package. Each small active area is 1.2mm x 1.2mm . Time constant of 25ms with Nitrogen encapsulation gas. Delivers a very low Temperature Coefficient of Responsivity of -0.04%/C. This detector has a very short thermal shock response to ambient temperature change.
-
product
Gas Sensors And Modules
Figaro USA offers a wide variety of gas sensors and gas modules ranging from ammonia, CO2, CO, SO2, and many others.
-
product
Coriolis or Thermal Mass Flow Meters
The RBCM Coriolis or Thermal Mass flow meter is measurable of liquid, gas, liquid-solid and gas-solid two phase fluid mass flow instantaneous rate and cumulative total and realizes display and remote transmitter of all measuring parameters.
-
product
BGA Rework Station
PDR IR-D3 Discovery
The system is tool free, gas free, instantly/precisely controllable, clean, modular, upgradeable and produces 100% yield BGA rework without any complications. It provides the extremely high levels of profiling and process control necessary for the effective rework of even the most advanced packages, including SMDs, BGAs, CSPs, QFNs, Flipchips and is ready for 0201 and lead-free applications.
-
product
Fixed Digital Gas Detector
OLCT 10N
Teledyne Gas & Flame Detection
The OLCT 10N is a digital combustible gas detector designed for to detect combustible, toxic gases or oxygen. Intended for use in combination with the MX 16, MX 32 and MX 43 controller, the OLCT 10N provides a fast and accurate response.All transmitter information is received by the controller in less than 1 second.Non-intrusive operator interface requires only a simple magnetic wand and allows one man calibration without opening the enclosure.
-
product
Pressure Calibration Custom Systems
Our custom systems integrate standard Fluke Calibration products, pressure generation and control accessories and/or data acquisition hardware to meet customer requirements. Systems may be mobile calibration carts or rack mounted instrument panels or benches. 7250-sys Ruska gas pressure controller system, and engineered systems customized to fit your application needs.
-
product
Tritium Monitoring
Designed for trapping environmental monitored elements in both gas and organic form.
-
product
Sensors And Components
ION Science is a leading manufacturer of VOC gas sensors, with PID sensor technology trusted by major gas detection manufacturers globally for accurate detection of volatile organic compounds (VOCs). To the ever-growing sensing portfolio, ION Science offers Development Boards and Kits specially designed to offer OEMs at a simple, low-cost with means of integrating MiniPID sensors into existing systems and applications. Due to tightening legislation and the growing global focus on air quality, worker safety and environmental emissions are driving the requirements for a new generation of measurement and monitoring systems. The multi-award-winning Disc Pumps are now available and distributed by ION Science.
-
product
Lightning Surge Generator
CDN-58A4
Shanghai Sanki Electronic Industries Co., Ltd.
CDN-58A4 signal line/data line coupling decoupling network, suitable for surge pulse and ring wave pulse unshielded symmetrical communication line, according to the new standard IEC61000-4-5.Ed3. Appendix A Figure A4 design. According to the characteristics of the line, the pulse coupling can be realized by gas discharge tube, capacitor, diode and other different methods.
-
product
Total Nitrogen and Sulfur Analyzer
XPLORER-NS*
The XPLORER-NS was developed as a total nitrogen/total sulfur combustion analyzer, capable of handling fully automated applications for liquids, solids, and gases (including LPG samples.) Changing from the liquids & gas module to the solids module has never been easier. Just push one button and the liquids module is automatically retracted from the heated zone. No clamps or manual locks required.
-
product
Compact Flow Sensor Lapiflow (R)
FSM3
It is a flow sensor that can support 5 types of gas such as air, nitrogen, argon, carbon dioxide, mixed gas with one unit.
-
product
Manual Fixture Kit With Changeable Cassette, Max number of probes (2N) 1000 units, Max UUT 580 x 400 mm (wxd)
CMK-04
Linear click system with ball bearings, using gas springs.10 mm ESD-proof top cover with aluminum reinforcement bars.Steel base cabinet with detachable aluminum back and bottom panels.Detachable interchangeable case system with an 8 mm spring-loaded probe protection cover.Base cabinet fitted with a telescopic guide rail and catch.
-
product
Gas Chromatographs
200 series GC
Ellutia Chromatography Solutions
Compact and great for mobile useUses minimal power, therefore more environmentally friendlyCosts less but still produces the same high-quality solutionMaintains full GC control with Ellution softwareLow service maintenance & low cost of spare parts
-
product
Moisture Analyzer
5830
The 5830 employs a unique non-equilibrium measurement technique that continuously exposes the gas to wet sample gas followed by dry sample gas, enabling a fast response to both rises and falls in moisture concentration.
-
product
Manual Fixture Kit
230350 – CMK-01
Linear click system with ball bearings, using gas springs.10 mm ESD-proof top cover with aluminum reinforcement bars.Steel base cabinet with detachable aluminum back and bottom panels.Detachable interchangeable case system with an 8 mm spring-loaded probe protection cover.Base cabinet fitted with a telescopic guide rail and catch.
-
product
Laser Spectroscopic Motor Exhaust Gas Analyzer
MEXA-ONE IRLAM
The MEXA-ONE IRLAM is an analyzer for the direct, simultaneous real-time measurement of the four relevant nitrogen-containing exhaust gas components NO, NO2, N2O and NH3.HORIBA's innovative infrared gas analysis technology, IRLAM™ (Infrared Laser Absorption Modulation), enables low-noise, high-precision measurement of four nitrogen compound gases (NO, NO2, N2O, NH3) in the low concentration range.
