PIN Diode Switches
-
product
Dynatrol® Level Switch for Light Bulk Solids
CL-10GJ
Dynatrol® CL-10GJ Level Detector operates with consistent results on problem applications that have a tendency to bridge or pack. It handles difficult products such as flour, cocoa, sugar, pharmaceutical powders, powdered lime and additional bulk solid materials for high-, intermediate- or low-point level detection. The CL-10GJ is typically used with bulk solids in the density range of 10-15 lbs/ft3.
-
product
Fail Safe Waveguide Switches
Waveguide switches enable very rapid switching between two RF channels. Fail Safe Waveguide Switches return to the de-energized position when the power is disconnected and requires a small holding current in the energized position. All models have low VSWR and high power handling capacity. They withstand the full power rating of the waveguide and most models can be pressurized to 0.2 MPa (2 ATO) for high peak power applications.
-
product
15 Pin D-Type Cables - Connector to Unterminated
The connector to unterminated cable assemblies below are not compatible with Pickering products, however, are offered for developing a connection solution for use with other products.
-
product
PXI-2515, 35-Channel, 0.25 A PXI Signal Insertion Switch Module
778572-15
35-Channel, 0.25 A PXI Signal Insertion Switch Module—The PXI‑2515 is a multiplexer switch module that enables connectivity by routing high-speed digital I/O (DIO) signals between a device under test (DUT) and an NI high-speed DIO device or a parametric measurement device. You can use modules such as PXI Source Measure Units (SMUs) and PXI Digital Multimeters (DMMs) with high-speed digital devices. With the PXI‑2515, you can perform parametric tests on digital pins without external connectivity or impedance mismatch challenges.
-
product
15 Pin D-Type Cables - Connector to Unterminated for Pickering
The connector to unterminated cable assemblies below are suitable to use with Pickering cards and modules that utilize a 15-pin D-type connector.
-
product
3 Pin Power D-Type Cables - Connector to Unterminated
The connector to unterminated cable assemblies below are not compatible with Pickering products, however, are offered for developing a connection solution for use with other products.
-
product
PXI Switch - 24-CH 2-Wire Multiplexer Module
PXI-7921
ADLINK PXI-7921 is a relay multiplexer which consists of 24 2-wire relays (DPDT, 2 Form C). As a multiplexer, the PXI-7921 provides 48x1 1-wire, 24x1 2-wire and 12x1 4-wire configurations. Users could choose one of the configurations by software. PXI-7921 typically connects one instrument, such as a DMM, a digitizer or a signal source, with many points which need measurement or excitation. The contact position of the relays can be changed either by direct software commands or by following the instructions previously stored in the on-board scan list. The scan list advances upon the trigger from external measurement devices, such as a DMM. The scan list could also advance when the scan-delay timer expires. In the PXI-7921, PXI trigger functions are supported and software programmable. Multiple modules can therefore be synchronized without additional field wiring.
-
product
6 Ft Harness, 78 Pin Male Connector On One End, Loose Wires (numbered) On Other End
GX96105
6 ft harness, 78 pin male connector on one end, loose wires (numbered) on other end.
-
product
What is an SPST Switch?
Learn more about SPST switches. A Single Pole Single Throw (SPST) switch is a switch that only has a single input and can connect only to one output. This means it only has one input terminal and only one output terminal.Learn more on What is an SPST switch at Precision website here.
-
product
Development Switch
TTEMonitoring Switch, 1 Gbit/s, 12 Ports
To complement the existing offering of development products, the TTEMonitoring Switch 1 Gbit/s 12 +1 Ports supports the fast online-mirroring of real-time data streams going through the 12 +1 operational ports of the switch. This switch provides 12 + 1 x 1 Gbit/s full duplex ports which can be equipped with small form-factor pluggable (SFP) modules. Electrical (1000 Base-TX) and optical (1000 Base-SX) SFPs are available.
-
product
Speed Switches & Sensors
Monitor Speed and Detect Motion of Conveyors and Other Rotating Apparatus for Premium Protection of Expensive Belting and Equipment
-
product
LXI High Voltage Switching Multiplexer Plugin Module
65-231-908-HI
The 65-231-908-HI plug-in module is part of a scalable high voltage multiplexer platform that provides a high voltage switching solution with capability up to 9 kV.
-
product
Ultra-Slim Safety Door Switch with Solenoid Interlock
SG-B1 Series
Panasonic Industrial Devices Sales Company of America
The SG-B1 Series and the SG-A1 Series are among the world’s thinnest Safety Door Switches. The SG-B1 Series features a solenoid interlock and five built-in contacts. The SG-A1 Series Safety Door Switch comes with three built-in contacts.
-
product
32 Channel Relay Output Switch
DP-VME-4224
DP-VME-4224 is a 32 Channel Relay Output Switch. Applications for this module includes hardware simulation, digital simulation, high-reliability systems, and automatic test equipment, and relay output for soft PLCs.
-
product
Programmable Switching DC Power Supply
SPS5000X Series
The SPS5000X-Series is a programmable Switching DC Power supply series that provides a wide range of output power using single-channel and multi-channel output configurations coupled with constant power capability. The series of power supplies includes sixteen models with voltages to 160 VDC and power to 1080 W. The SPS5000X supplies can be connected in series (2 units) or in parallel (3 units) to meet the requirements of 0~320V and 0~270A, with a maximum combined power of 3240W.
-
product
PCB Adapter, ITA, QuadraPaddle, 192 Position, To PCB-Mounted 2x68 Pin Female VHDCI Connectors
510151123
PCB Adapter, ITA, QuadraPaddle, 192 Position, to PCB-Mounted 2x68 Pin Female VHDCI Connectors
-
product
Switch Indication Maintainer
The SIM
The SIM - Switch Indication Maintainer is a handheld device used to simulate normal switch correspondence while the switch is handthrown or handcranked to perform periodic maintenance or testing.
-
product
Rotating Diode Assembly, P/N 6118CA
CEHCO is a specialist in the repair of Rotating Diode Assemblies.
-
product
Optical Switch
5504
The FOD 5504 Optical Switch is a unique handheld instrument for calibration sets and measurement automation. Routine comparison with Master device procedures in calibration laboratories, can be simply performed with before unachievable repeatability. No more need to move fiber and connect it repeatedly. Fix cables on a table, only once clean and connect patchcords.
-
product
SMD Tester Capacitance Resistance Diode Tweezers Test Pen Multimeter SMD Meter
VA503
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
SMD tester Capacitance Resistance Diode Tweezers Test Pen Multimeter SMD Meter. SMD Components Identifier
-
product
50 Pin IDC Connector Breakouts
The connector breakouts below are suitable to use with Pickering cabling products that utilize a 50-pin IDC connector.
-
product
Mating Coax Connector and 20 Coax Pins Crimped to 3' with BNC Connectores
GT96406
Mating coax connector and 20 coax pins crimped to 3 foot wires with BNC connectores
-
product
Standard Voltage 37 Pin D-Type Cables - Calibration Cables for Pickering
The cable assemblies below are suitable for use with Pickering precision resistor cards and modules that utilize 37-pin D-type calibration port connector.
-
product
Switch Fabric Modules
Switched fabrics provide the interprocess communication backbone for OpenVPX systems - and these modules enable you to achieve the maximum benefit.
-
product
15 Pin D-Type Connectors for Pickering
The connectors below are suitable to use with Pickering cards and modules that utilize a 15-pin D-type connector.
-
-
product
SS Body Pressure Switch
P117G
The P117G Stainless Steel Miniature Pressure switches are sharp, highly versatile devices that can be used in hundreds of OEM and routine mechanical applications. It is among our most popular switches given its durability and diverse set point options. There are numerous fitting and electrical connectors available featuring TB, TS, Military and DIN Connectors.
-
product
PCI Express Passive Switches
MAX4888
High-Speed PCI Express Passive Switches Enable Gen I Switching
-
product
Development Switches
TTESwitch A664 Lab
The TTESwitch A664 Lab supports multi-environment development efforts for hard real-time operations in distributed systems. The Deterministic Ethernet switch enables the design of highly dependable systems with focus on high availability, reliability, integrity, security, maintainability and safety.
-
product
DC Switching Power Supply
Power Source : Wide Input(90V to 260V~) 50Hz/60Hz Output Current : 0~3A, 1A(Fixed) Rs-232C Interface(Option) Programmable(Option)
