Network Monitoring
Observe and analyze network communications to detect abnormal activity.
See Also: Test Access Points, SNMP
-
Product
Network Cable Tester
AudioJog Pro 8
-
Audio/Lighting/Network cable tester with SINGLE & DOUBLE ended testing.
-
Product
Real Time Monitor Interface
ANALYSIS 4N
-
It supports a management on the on-site equipment, such as to add subnets, to add subnet equipment, or to config equipment parameters, etc. Subnet fulfills the following applications: parallel communication, interaction with equipment, batch logging, downloading, configuration, ending, timing synchronization and system status viewing.
-
Product
Precision Resistor Network
-
Analog Devices provides a portfolio of quad resistor networks with excellent matching specifications over the entire temperature range. All of our resistors can be accessed and biased independently, making them a convenient and versatile choice for any application that can benefit from matched resistors. Our resistor networks provide the precise ratiometric stability required in highly accurate difference amplifiers, voltage references, and bridge circuits.
-
Product
Digital RF Power Monitor
3024
-
The COMM-connect 3024 RF Power Monitor from LBA Technology can control up to 8 external RF Measuring heads. The high dynamic range with external couplers and RF measuring heads cover from 1W to 1MW. The Power conversion algorithms handles multi carrier, multi mode, peak, average and RMS signals. The power readout is auto scaled and VSWR can be calculated between any probes. Also the measured and calculated results along with alarms can be shown in the local LCD. The instrument has SNMP support to allow network management. The instrument can be configured for VSWR and Power limits to give alarms. The alarms can be configured to operate relay drivers or isolated Optcouplers. The alarms can also be configured as SNMP traps sending relevant information to the network control center. The COMM-connect 3024 WEB enabled RF Power Monitor gives an unlimited number of applications to monitor and control the last part of your RF network installation from transmitters to the antenna.
-
Product
BGAN Network Emulator
BNE
-
Square Peg Communications Inc.
The Gatehouse BGAN Network Emulator (BNE) is a test tool developed and optimized to work in concert with the Square Peg BPLT to provide end-to-end emulation of the BGAN Network. The combination of the BPLT and BNE provides an on-the-bench emulation of the I4 satellites, the BGAN Radio Access Network (RAN) and the Core Network (CN). It is a very powerful test solution that enables terminal manufacturers, system integrators and application developers to test their applications thoroughly and consistently and to verify that applications are optimized to work under any network condition thereby providing the best possible user experience.
-
Product
Partial Pressure Monitor for RGA
PPM100
-
Stanford Research Systems, Inc.
The PPM100 is a stand-alone controller/monitor for SRS residual gas analyzers. It measures partial pressures from SRS RGAs and total pressure from up to four capacitance manometers. Graphical output is available on a touchscreen LCD display.
-
Product
Systems for Oil Quality Monitoring
-
*Reliable monitoring of oil contamination*Reliable machine and plant protection by permanent oil moisture monitoring
-
Product
Condition Monitoring
MVX & MV-120
-
The MVX and MV-120 are powerful and intelligent, real-time, multi-channel data analyzers. The MVX and MV-120 gather multiple data-types, including vibration, IEPE, and voltage, in real-time, giving you the power to stop machine failures before they happen.
-
Product
Wireless Network Emulators
-
Keysight’s industry-leading range of wireless network emulators and device test solutions enable the entire mobile device ecosystem to accelerate the market introduction of new wireless devices by streamlining the workflow from early prototyping, development, and design verification to conformance, carrier acceptance, and high-volume manufacturing.
-
Product
PXI Monitored Multiplexer, Dual 64-Channel, 1-Pole
40-619-302
Multiplexer Module
The 40-619-302 is a high density PXI 2 A multiplexer module in dual 64-channel configuration using high quality electro-mechanical signal relays allowing each channel to switch current up to 2 A and voltage up to 250 VAC/DC - Single
-
Product
Bus Analyzer, Monitor, Debugger & Programmer
BusPro-I™
-
The BusPro-I has all the power, flexibility, and features you need to monitor and debug the I2C bus circuitry on your board. The BusPro I2C can be used to monitor and log I2C bus traffic in real-time, generate I2C transactions to communicate with peripheral components on the bus, and in-system program I2C compatible EEPROMs.
-
Product
Power Quality Monitoring Equipment
-
Outram Research Ltd manufacture, sell and hire a wide range of Power Quality Monitoring Equipment. From a single phase, plug and play instrument for solving residential Power Quality complaints to comprehensive 3 phase, 8 channel, high speed troubleshooting technology used by Power Quality Consultants, Distribution Network Operators and Electrical Utility Companies around the world.
-
Product
Network Analyzer, Tester, LED
72-9450
-
This cable tester allows for quick and easy troubleshooting of RJ45 and USB cables. Checks for continuity, faulty wiring, open, shorts, straight through or cross pinning of cables.
-
Product
Real-time IP network measurements
IPProbe
-
Real-time network measurements for multiple IP interfaces. Detection of Packet loss, IAT (Inter Arrival Time), Delay, Bitrate and ETR290 problems. Stable packet generation and receiving is a key feature required in any modern IPTV environment. Any irregularity and/or discontinuity in this packet stream means buffering problems or losing frames. IP jitter provides a means to see the distribution and stability in the IP stream.
-
Product
Network Analyzer, Lan Tester, LED
72-6706
-
The Tenma Multi-Network and Modular Cable Tester easily reads the correct pin configuration of 10Base-T cable (Category 5, 5e and 6), 10Base-2 cable (coax), RJ-45 and RJ-11 modular cables, 356A, TIA-568A/568B and Token Ring cable by comparing transmitting end to the corresponding receiving end
-
Product
Temperature/Humidity Monitors
-
Together, an environment's temperature and relative humidity (RH) indicate how comfortable it "feels" to humans. General sells a variety of temperature/humidity monitors that either show real-time readings like the A600FC High Temperature Analog Humidity-Temperature Meter or log measurements over time for trending purposes such as the HT50 USB Temperature-Humidity Data Logger. Trend analysis is the rationale for another popular application for temperature/RH monitors - water damage restoration.
-
-
Product
Network Impairment Simulator
-
Testing system performance under realistic network conditions requires the introduction of impairments that could be expected to be seen on networks, especially public networks which are uncontrolled. There are a number of ways to do this. A basic method is to use network simulation devices that can emulate conditions expected to be encountered.
-
Product
In-line Wet Process Concentration Monitoring
-
CI’s family of wet process concentration analyzers (WetSpec line) offers cost effective solutions for in-line wet chemistry monitoring. These products range from conductivity and NDIR solutions for simple chemistries concentration measurement, to spectroscopic systems for measuring multiple constituents and residues in complex solutions. The main concentration monitoring application that are served by CI Semi’s products are cleaning (SC1, SC2…) etching (HF, BOE, MAI….) and photo resist strippers (EKC, ACT, Piranha….).
-
Product
CNC Machine Network Solution
WebAccess/CNC
-
Webaccessoryess/CNC supports diverse SCADA drivers, CNC, I/O, PLC devices for efficient equipment data collection & networking app development.
-
Product
Workstation Monitors
-
Dou Yee Enterprises (S) Pte Ltd
Dou Yee Enterprises Workstation Monitors including critical process electrostatic moinitoring, event monitor embeddable ERDS monitoring, and multi-channel field voltage detection
-
Product
PXIe-5633, 26.5 GHz PXI Vector Network Analyzer
790406-12
Vector Network Analyzer
The PXIe-5633 is a single-slot PXIe Vector Network Analyzer (VNA) that helps you streamline your production test applications. This VNA supports automatic and manual precision calibration, full vector analysis, de-embedding, and pulsed S-parameter capabilities, making it ideal for validation and production operations without the high costs and large footprints associated with traditional benchtop VNAs. The PXIe-5633 also integrates into NI RFmx and Instrument Studio software to provide automated control for test program development. Additionally, the PXIe-5633 features a hardware pass-through path that you can use for PXI Vector Signal Transceivers (VSTs) testing directly at the VNA ports. With combined modulated and S-parameter measurements on a single connection, you can cover both VST and VNA tests on a single device.
-
Product
MIL-STD-1553 Data Acquisition Module for Ethernet Networks
eDAQ-1553
-
Avionics Interface Technologies
One or two dual redundant MIL-STD-1553 bus interfaces - Transformer and Direct bus coupling supported - Two 10/100/1000 Mbit/s Ethernet LAN Interfaces - Streams MIL-STD-1553 bus data in standard IRIG 106 Chapter 10 format. - Compatible with 3rd party recorders and telemetry tools - All captured MIL-STD-1553 bus data provided with timestamps - Full error injection & detection capabilities - Works with AIT’s Flight Simulyzer™ GUI Analyzer/Simulator software
-
Product
Air Quality Monitoring System
-
A system that measures metrological parameters such as wind speed, wind direction, rainfall, radiation, temperature, barometric pressure and ambient parameters.
-
Product
NAM (Network Acquisition Module)
-
The NAM is a stable, robust data hub with unrivalled configurability, ideal for large or complex regional and national seismic arrays and other multi station monitoring solutions.
-
Product
Basic Rate and Primary Rate ISDN Network Simulator
Emutel Duo
-
Emutel Duo is a convenient and flexbile basic rate and primary rate ISDN network simulator. With 3 software selectable S/U interfaces and optional 2 E1/T1 interfaces you can test and develop a full range of ISDN equipment.
-
Product
Radiation Monitoring Systems
-
Monitoring the radiation situation on the territory of radiation-hazardous and radiation-sensitive objects and premises, conducting radiation monitoring of the environment.
-
Product
Remote Display Gas Monitor
Chillgard® 5000 Remote Display
-
The Chillgard® 5000 Remote Display provides gas monitor information before room entry where potentially hazardous gas levels may exist. It mimics the Chillgard 5000 Gas Monitor readings for gas concentration, alarm status, calibration.
-
Product
Precision Studio Monitor
Amie
-
Amie unleashes your creative power by extending the accurate translation of the Meyer Sound Acheron screen channel loudspeakers to smaller studio environments.
-
Product
Continuous Emission Monitoring System
CEMS
-
CEMS, the “Environmental Eye” for Source Emissions.A Continuous Emission Monitoring System (CEMS) is an integrated system to measure fuel flow, dust, and concentrations of air pollutants such as SO2, NOx, CO, CO2, THC and O2 in accordance with the applicable regulations for the emission source.
