Coil Coating Wet Film Wheels

Elcometer 3230 - Elcometer Limited

The outer wheels are knurled to allow measurements to be taken on slippery coatings or on fast moving substrates.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List

Topics

Family

Wet Film & Powder Thickness

Elcometer Limited

When applying a liquid coating, by measuring the uncured film thickness, it is possible to determine the eventual dry film thickness. Applying too much coating wastes time and materials. It can also affect the performance and finish of the product. Too much wet film can cause the coating to crack as it cures; too little coating increases the risk that the substrate will not be sufficiently protected, leading to rust spots.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Punched Wet Film Combs (Aluminium)

112AL - Elcometer Limited

The Elcometer 112AL, being punched from aluminium, is not as accurate as precision formed stainless steel wet film combs and has a shorter lifespan.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Plastic Wet Film Combs

154 - Elcometer Limited

Metric and Imperial values are on the same comb, 50 to 800μm on one side, 2 to 32mils on the other.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Wet Film Wheels

3230 - Elcometer Limited

By rolling the gauge through a wet coating, the centre wheel eventually touches the film. This point on the scale indicates the thickness.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Uncured Powder Film Comb

155 - Elcometer Limited

This enables the application system to be set up and fine tuned prior to the curing process. In turn, this will reduce the amount of scrap and over-spray.Place the comb into the powder and slide the comb along the surface. The measurement points (or teeth) are pointed and allow the powder to flow around them.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Pfund Thickness Gauge

3233 - Elcometer Limited

Available in aluminium or stainless steel this instrument consists of two concentric cylinders, one sliding inside the other. A spherical glass lens, which has engraved measurements, is fitted to the end of the central cylinder and when pressed into the wet film, leaves a circular trace.The diameter of the mark on the lens is measured and, using the supplied conversion table, the thickness of the coating can be easily assessed.Ideal for measuring the thickness of wet translucent products such as varnishes, oils etc.Measurement range of 2.25 - 360μm (0.09 - 14.17mils)

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Long Edge Wet Film Combs (Stainless Steel)

3238 - Elcometer Limited

Each comb has 24 measurement steps (teeth) providing a more accurate wet film thickness value.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Wet Film Combs (Stainless Steel)

Elcometer 115 - Elcometer Limited

Four separate thickness ranges are available up to a maximum of 1,250μm or 50mils and are manufactured to an accuracy of ±5% of marked value or ±3µm (0.12mil), whichever is greater.

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List
Hexagonal Wet Film Combs (Stainless Steel)

112 & 3236 - Elcometer Limited

These hexagonal precision formed stainless steel wet film combs are long lasting, reusable and supplied in a range of thicknesses measuring up to 3,000μm (120mils).

Product Home Contact/Sales Distributors/Reps Company Catalog Share Add To List