Power Diagnostix Systems GmbH

Power Diagnostix provides instruments and engineering services for high-voltage environments and especially for partial discharge (PD) testing, research, and monitoring.

  • 49 241 74927
  • 49 241 79521
  • support@pdix.com
  • Vaalser Strasse 250
    Aachen, 52074
    Germany

Filter Results By:

Products

Applications

Showing recent results 1 - 8 of 8 products found.

  • Mobile HV AC Test System

    Power Diagnostix Systems GmbH

    The system stays within the load and size limitations for permission-free road use. Additionally, the matching transformer and the reactor are filled with ester instead mineral oil. Thus, it can be easily transported to a substation, power plant, or other high voltage areas for testing HV components after installation or repair. Additionally, it is applicable for condition assessment and fault investigations. PD measurements can be performed in non-shielded environments as part of the on-site acceptance test on a power transformer, or as a method to locate PD failures acoustically, or by electrical measurement.

  • Fiber Optic Transmission Systems

    Power Diagnostix Systems GmbH

    Although differential and isolation amplifiers can eliminate some of the many possible sources of error and at least reduce their effects, only fiber-optic isolation amplifiers bring definite relief. Optical isolation of measuring circuits eliminates long measuring cables prone to electromagnetic interference, and potential differences of several hundred kilovolts become possible between measuring and recording circuits.Applying fiber optic isolation with high impulse-current applications allows the ground potential to have dramatically transient changes without affecting the integrity of the signals captured and transmitted.

  • ICMseries Accessories: Calibrators

    Power Diagnostix Systems GmbH

    Partial discharge measurement is a useful tool to analyze the insulation of high voltage components. However, partial discharges can usually not be measured directly, just the apparent charge of such signals are captured by the measuring instrument. Therefore a calibration of the whole measuring system is required in principle. Hereby short-duration current pulses of known charge magnitude are injected into the system, and by this a scale factor can be calculated for later PD measurements.

  • Instruments for Acoustic PD Location

    Power Diagnostix Systems GmbH

    The latest family member of Power Diagnostix' fiber optic transmission systems offers high speed data acquisition via optical fibers on multiple channels in parallel. Each channel acts as an independent transient recorder with its own storage and settable acquisition speed. The sampling rate is 20 Msample/sec.

  • PD Measurement Devices

    Power Diagnostix Systems GmbH

    The ICMsystem is a digital partial discharge detection system. The instrument is completely controlled by software using a GPIB, USB, TCP/IP, GSM Modem, fiber optic or direct serial link. It can be expanded to up to 10  true-parallel acquisition channels, while offering all features of the single channel  ICMsystem. It is designed for acceptance tests on large power transformers and other application requiring parallel acquisition.

  • PD Monitoring Systems

    Power Diagnostix Systems GmbH

    The ICMmonitor is an instrument for continuous on-line monitoring of partial discharge activity in high voltage equipment. The instrument tracks changes in key discharge quantities for storage in trending diagrams and for triggering user-settable alarms. TCP/IP, Modem, fiber optic or direct serial links enable remote access and full remote control. The latest version of the ICMmonitor comes with spectrum analysis function (formerly know as SPECmonitor), acoustic signal detection, and a conventional partial discharge measurement circuit.

  • RIV Measurement Devices

    Power Diagnostix Systems GmbH

    The multi-channel ICMsystem is a true-parallel multi-channel acquisition system, while offering all features of the single channel  ICMsystem. It is designed for acceptance tests on large power transformers and other application requiring parallel acquisition.

  • Tan Delta Measurement Devices

    Power Diagnostix Systems GmbH

    The ICMflex instrument family, introduced in 2008, bases on the latest concept where the entire acquisition hardware is placed on high voltage potential. The instruments are fully remote controlled via high speed Bluetooth or fiber optic communication.