High Voltage Scanners

Guideline 66001 Lead Compensator is useful for performing 4-Terminal measurements in High-Ohms or 2-terminal modes of the 6675A and the 9975 Current Comparator Bridges. The compensator is placed between the high voltage terminal, either external or internal, and the terminals on the high sides of the resistors to be measured or the output lead ...more

The PDS allows online partial discharge detection on underground cable accessories and equipment for security/maintenance purposes. This equipment is perfect for a high voltage predictive maintenance program. The PDS is very accurate to detect partial discharge on cable joints (XLPE/EPR type), switchgear, elbows, Cable Terminations, and more. ...more

Hipot Tester. In all cases, both high and low limits are operator programmable for quick, and easy pass/fail testing. These dual limits are essential to ensure that the device under test is actually making contact with the tester. For consistent testing, up to 50 setups can be stored in instrument memory for later recall. An optional high volt ...more

The APCON Lazer Link IV SCSI Fiber Optic Bus Extender lets you surpass the distance limitation of the ultra wide single-ended, low voltage or high voltage differential SCSI bus. With the APCON Lazer Link IV, SCSI peripherals such as disk drives, CD-ROM arrays, RAID arrays, tape backup peripherals, and scanners can be located up to 500 m from t ...more

The Model 6522 Voltage/Low Current Scanner Card can provide up to ten channels of low-level current, high impedance voltage, high resistance, or charge switching. Although it is similar to the Model 6521 in many ways, the Model 6522's input connectors are 3-lug triax.  ...more

The Model 7154 switches voltages to 1100V peak or currents to 0.5A. The current carry capacity of each relay contact is 1A. Two-pole relays switch both circuit High and Low for full floating measurements and each input line is fuse protected against current overload.  ...more