Showing results: 151 - 165 of 418 items found.
-
J7201A -
Keysight Technologies
Designed for WLAN and WiMAX™ device manufacturing test and mobile handset base transceiver station (BTS) handover test.
-
IOD-144 -
Acces I/O Products, Inc.
This is a 144-bit full-size card. A Programmable Peripheral Interface chip, type 8255-5 provides three 8-bit ports (A, B, and C) for each 24-bit group. Each port can be independently programmed for either input or output. Port C can also be configured as two 4-bit ports. These cards fully implement Mode 0 of the 8255 PPI chip. (Consult the factory if you desire to operate in Mode 1.) Type LS245 bi-directional transceivers sink 24 mA (optionally 64 mA) and source 15 mA. These transceiver buffers provide hysteresis correction on inputs and added drive capability on outputs. The direction of the transceivers is set by software.
-
Omega Engineering, Inc
Omega offers a full range of wireless reciever options. Form RS232-to-USB transceivers to long-range repeater/receiver systems, and connector/transmitter receivers.
-
Omega Engineering, Inc
Omega offers a full range of wireless reciever options. Form RS232-to-USB transceivers to long-range repeater/receiver systems, and connector/transmitter receivers.
-
XMC-1553-x -
ALPHI Technology Corporation
1 or 2 UTMC SUMMIT• UT69151DX-GPC• BC / RT / BM• On-chip Transceivers• On-board Transformers• Long stub / Short stub
-
PCIe-1553-x -
ALPHI Technology Corporation
1 or 2 UTMC SUMMIT• UT69151DX-GPC• BC / RT / BM• On-chip Transceivers• On-board Transformers• Long stub / Short stub
-
Renesas Electronics Corp.
Renesas offers industry-leading devices to enable efficient and reliable communication for industrial control, networking and computing applications. Dual protocol transceivers, voltage level translators, I2C Buffers, wide operating voltage range RS-232 transceivers, and RS-485/422 devices with the highest noise immunity and ESD protection in small packages are available to support high-speed data transfer and a variety of configurations to fit your applications.
-
Analog Devices Inc.
ADI nonisolated controller area network (CAN) transceivers provide the differential physical layer interface between the data layer link, hardware protocol (for example, embedded in some of ADI's Blackfin® processors), and the physical wiring of the CAN bus. ADI's portfolio includes transceivers with integrated iCoupler® and isoPower® isolation, providing, fully isolated off-the-shelf CAN PHY's.
-
Analog Devices Inc.
ADI isolated controller area network (CAN) transceivers provide the differential physical layer interface between the data layer link, hardware protocol (for example, embedded in some of ADI's Blackfin® processors), and the physical wiring of the CAN bus. ADI's portfolio includes transceivers with integrated iCoupler® and isoPower® isolation, providing, fully isolated off-the-shelf CAN PHY's.
-
STMicroelectronics
The low-power, high-speed transceivers of this family are designed for RS-485, RS-422 and RS-423 communication applications. They usually contain one driver and one receiver in half duplex configuration. Each driver output and receiver input is protected against electrostatic discharge up to ± 15 kV and has no latch-up. These transceivers operate with a 5 V supply and draw a very low supply current when unloaded or fully loaded but with disabled drivers.
-
ON Semiconductor
A product portfolio for advanced WiFi solutions that support 802.11ax/ac/n/a/g/b standard and wireless RF transceivers that operate in the sub-GHz and 2.4 GHz bands.
-
iW-RainboW-G47V® -
iWave Systems Technologies
AMD Xilinx’s KU19P, KU095, KU115 Kintex UltraScale+ FPGADual 64 bit, 4GB FPGA-DDR4 with ECC (Upgradable)31 channels of FPGA GTY transceivers up to 32.75Gbps1Dual ARM Cortex-A7 core processor of 1.2GHz speed32bit 2GB DDR4 for CPU with ECC128MB QSPI Flash & 256MB NOR Flash3U VPX Connector (P0+P1A & P1B+P2A)8 Optical transceivers through MT Ferrule Connector (P2B)
-
Y1800A -
Keysight Technologies
The RF transceiver kit consists of a transmitter unit and a receiver unit in superheterodyne architecture. The transceiver units are made up of various RF building-block modules such as filter, low noise amplifier, power amplifier, mixer and oscillator. The RF transceiver kit is controlled by a Windows-based Control Panel software via USB. A Measurement Automation Program is provided to demonstrate automated characterization and test of RF circuits. A signal generator and a spectrum analyzer are required to run this program.
-
CAES
CAES offers a comprehensive SpaceWire product family that includes our physical layer transceiver, node interface IP, 4-port router and FPGA-based SpaceWire router.
-
Objective Solutions, Inc.
Objective Solutions' Easy E23/E84 product line is designed to simplify the integration of SEMI E84 and E23 into Process Equipment and Factory Vehicle systems. The models provide a standard E23/E84 infrared interface to AGV/OHV and process equipment, utilizing Hokuyo transceivers. The Easy E23/E84 units have been developed to work as-is with Hokuyo IR transceivers and as an option, with opti-isolation as required by direct-connect applications. They enable simple integration to process equipment or AGV application programs.