Test Systems
group of interoperable devices whose integration perform a common test purpose.
See Also: Systems, Equipment, System Integrators, System Test, System Integration
-
product
MIL-STD-1553 USB & LAN Test & Simulation Module
UXI-1553
Avionics Interface Technologies
Dual redundant, single, dual, or quad stream configurationsConcurrent BC, 31 RTs, and BM operations - Physical Bus ReplayFull error injection/detection capabilities - Programmable trigger and capture - Programmable Bus Coupling and Output Voltage Levels - Onboard IRIG-B time code encoder/decoder for Synchronization - Time Synchronization to IEEE 1588 via Ethernet LAN port - 10 Discrete I/O Interfaces (5 Outputs / 5 Inputs) - Operates from a single USB or Ethernet LAN connection - Supports SAE AS4112/4114 protocol testing requirements- Flight Simulyzer™ GUI Analyzer software
-
product
Bus Differential System
B30
The B30 features integrated protection, control and metering for MV, HV and EHV busbars, providing cost effective, feature-focused busbar protection. Use the B30 to protect busbars with up to 6 feeders with up to two three phase differential zones. The B30 is a cost effective alternative to high impedance schemes, ideal for breaker-and-half bus schemes, with integrated feeder backup protection and metering
-
product
Measurement of Dew Point in Compressed Air Systems
HP480 – HP481
Compressed air is used for several purposes, many of which require compressed air with a low humidity level, and so comes the need to know the dew point (DP) of water vapour in the compressed air that circulates in the system.
-
product
Automated Corrosion Test Chamber
Thermotron's Automated Corrosion Test chambers combine the capabilities of a temperature-humidity test chamber and a salt-spray cabinet. Corrosion chambers eliminate the need to manually transfer products from one environment to another.
-
product
Current Transformer Test Set
Vanguard Instruments Company, Inc.
The EZCT-2000C is Vanguard’s third-generation microprocessor-based current transformer test set. Designed specifically for CT testing, the EZCT-2000C has the following outstanding features that can greatly increase productivity and save time during the commissioning stage:
-
product
MiniPCI Express System Timer (PCIe Interface)
SKU-032-06
This MiniPCIe Timer uses a PCIe interface for synchronization of IP signals. This hardware-based solution provides accurate clock timing for Asterisk® open-source PBX software.
-
-
product
Ground Tactical Data Link System
Curtiss-Wright Defense Solutions
Fulfilling the increasing need for secure, reliable, and efficient communication systems in the battlefield, TCG GTS is an affordable and combat proven TDL solution with comprehensive situational awareness (SA), command and control (C2) and non-C2 data link capabilities.
-
product
Acoustic Test Chamber
For the development of small devices and components. Reliable measuring environment for noise tests and quality assurance.
-
product
Test & Measurement Accessories
Designed to work with various Klein Test and Measurement tools, these replacement parts and accessories guarantee the tools continue to work their best and diversify the functions of several products.
-
product
Environmental Test Chambers
Angelantoni Test Technologies Srl
We supply a wide range of climatic chambers capable of reproducing a very large number of simulated environmental conditions, which can be combined in some cases. Select the type of test and the area of application and you will find the right solution for your needs!
-
product
Vibration Control, Monitoring and Diagnostics System for Hydraulic Units
Stationary system for vibration control, monitoring and diagnostics of hydraulic units is used for constant technological and safety control, diagnostics of vibrational and mechanical parameters of hydraulic units and auxiliary equipment of hydroelectric power stations in accordance with the applicable requirements.
-
product
Terminal Test Kit (92 Pcs)
3601C
Peaceful Thriving Enterprise Co Ltd
*Total: 92 pcs*Alligator clip x 2 pcs*Testing probe x 2 pcs*Flat terminal x 48 pcs*Testing needle x 4 pcs*1 to 2 connector x 2 pcs*Round terminal x 24 pcs*5K variable resistor x 2 pcs*Polarity tester/stroboscope x 2 pcs*SRS air bag replacement connector x 2 pcs*Male / Female to Male / Female Extension Wire x 4 pcs
-
product
Universal Imaging System
Laboratory 29 megapixel full spectrum imaging camera package for fingerprint work. A complete digital imaging system providing image capture, image enhancement, and image comparison.
-
product
Automatic Sonic Nozzle Gas Meter Test Bench G1.6-4
Bofa Instrument & Equipment Co., Ltd
Automatic sonic nozzle gas meter test bench G1.6-4 is an equipment to test domestic gas meter, the flow range 0.016m3/h～6m3/h, adopting series-connection compare method. It is an ideal testing equipment for gas meter factory and R&D institute.
-
product
optical liquid leak detection system
LEAKLEARN®
The LEAKLEARN OPT liquid leak detection system incorporates fluoropolymer optical fiber sensors and detectors, emitting light when fluoropolymer optical fiber sensors contact liquid. T
-
product
RDM Responder Tests
The RDM Responder Tests are an automated testing suite for RDM Responders. Testing RDM Responses previously involved connecting an RDM Controller and sending commands to the responder, verifying the behavior matched what was expected. This can be a time consuming process and many of the corner cases aren't exercised.
-
product
Java Apps Test Software
JRebel
Supports Wildfly and TomEE 1.6.0 Supports EJBs on WebSphere 8.5.5 and JBoss 6EAP, 7.1, 7.2 Supports Spring 4 and PrettyFaces Adds remoting for standalone applications And many more improvements
-
product
Test Probe
MP21
Ideal for hipotting transformers, PCBs and other small assemblies. Four-finger-trigger must extend probe tip before the test can begin. The tester will shut down if the trigger is released
-
-
product
Power System Recorder with CDR , PMU and IEC 61850 station bus protocol
TESLA 4000
ERLPhase Power Technologies Ltd
The new TESLA 4000 is an intelligent, state of the art, user-friendly multi-timeframe dynamic power system recorder with advanced Phasor Measurement Unit (PMU) and Continuous Disturbance Recording (CDR) capabilities. Wide area swing recording accomodates system performance analysis in minutes Meets NERC continuous disturbance recording standards with non-volatile on board flash memory No mechanical moving parts – flash drive eliminates most common mode of failure in recorders. Each flash drive holds 1000 records. IEEE C37.118-2005 SynchroPhasor Standard
-
product
Vibration Test Chamber
Series TV / CV
During transportation, or when used under heavy mechanical loads your products vibrations or oscillations can be exposed, which may negatively affect the quality and longevity. To simulate these effects can be personalized with the modular standardized versions of the corresponding CTS installations, the requirements such as vertical and horizontal meet vibration and this in conjunction with very high rates of temperature change.
-
product
System Controls
Exar Corporation offers a broad range of USB VBUS power distribution switches supporting both the USB 2.0 and latest USB 3.0 specifications. These devices, the SP/XRP252x series, are offered in single and dual channels configuration for maximum design flexibility. The XRP2527 and XRP2528 are generic single and dual channels power distribution switches capable of operating at input voltage as low as 1.8V supporting the typical 1.8V, 2.5V, 3.3V and 5V power rails. Current limit for each channel is programmable from 300mA up to 1A through an external resistor and achieves better than 8% accuracy.
-
product
Scanning Electrochemical Systems
The VersaSCAN is a single platform capable of providing spatial resolution to both electrochemical and materials-based measurements. Each VersaSCAN is based on a common high-resolution, long-travel, closed-loop positioning system mounted to a vibration-resistant optical base. Different auxiliary pieces are mounted to the positioning system. These ancillary pieces (e.g., an electrometer, piezo vibration unit, or a laser sensor) provide functionality to the positioning system for different scanning probe experiments. VersaSTAT potentiostats and Signal Recovery Lock-in Amplifiers are integrated via ethernet control to make accurate measurements of these small signals.
-
product
Laser Linewidth Measurement System
A0020A
Laser Linewidth Measurement System is an easy and accurate measurement system for measuring the linewidth of the laser diode. The evaluation of the linewidth of lasers is essential for development, manufacturing and quality control of lasers for optical communications.
-
product
Simulation Systems
GSIM
The GSIM avionics IO platform builds on The Goebel Companyʼs long historyin computer architecture and realtime simulation. Weather your IOrequirements are simply driving a cluster of displays, or driving a fullcomplement of avionics IO, GSIM has the solution for you. GSIM providesthe highest IO count in single chassis rack mount or desktop configurations.GSIM configurations are delivered with Linux Real-time systems.
-
product
Automated Fibre Loss Test Set
LTS-1500
The LTS-1500 is a small, rugged automated fiber optic loss test set that characterises singlemode fiber links at wavelengths of 1310, 1490 and 1550 nm. It is comprised of a sensitive InGaAs based optical power meter calibrated at six wavelengths with better than -75 dBm noise level plus a stabilised laser light source with up to three selectable wavelengths.
-
product
Software Test Framework for LabVIEW
VI Tester
VI Tester is a software test framework for LabVIEW that allows software developers to test their LabVIEW code (VIs). Software testing is a critical component of agile development and test driven development processes and is also critical for validating software functionality. VI Tester is based on the industry standard xUnit software test architecture that is used in many other programming languages. This architecture is very flexible and powerful, but also very easy for beginners to learn.
-
product
Modular Breakout System 8-Pin Power D-type Plugin Module
95-191-002
The 95-191-002 Plugin Breakout Module is designed to be fitted to a PXI 40-191 Fault Insertion Switch as part of the Pickering MBoS. The Modular Breakout System is designed to Simplify HILS (Hardware In the Loop Simulation) Applications.
-
product
Datapaq Oven Tracker Systems
The Datapaq Oven Tracker Systems from Fluke Process Instruments are designed to provide comprehensive thermal profiles for applications such as powder coating, paint curing, component supply and general paint, powder and e-coat OEM applications up to 400°C. With our thermal profiling solutions, you can monitor your whole process from within the oven and gain meaningful information through automatic reporting, which turns raw data into meaningful analytics that showcase if optimal temperatures are met to ensure high-quality results.
