Rotameters
measure gas or a fluid's flow rate through a tube.
-
Product
Temperature Loop Control Setup
ULP-27
-
Unitech Scales And Measurements Pvt. Ltd
Unitech’s Temperature Control Loop Setup is basically a PC based PID controller setup used for closed loop and open loop analysis of temperature process system. The setup comprises of RTD temperature Sensor. The water flows through the Rotameter and Process tank to which a heating coil is fitted. The heater is controlled by a Thirstier drive. The Thirstier drive is connected to PID controller. The manual control valve can control the water flow. The system is mounted on a tabletop model with all necessary Piping. Water at approx. 100 LPH has to be supplied to a system externally. The electronic panel comprises of ADC/DAC card with RS-232 interfaces.
-
Product
Flow Control Set Up Using PID Controller
ULP-25O & ULP-25T
-
Unitech Scales And Measurements Pvt. Ltd
Flow Control Setup Comprises of a Orifice with DPT to measure flow Rate. The flow of water is controlled by Control Valve with pneumatic actuator. I to P converter is provided to control the actuator. Rotameter is provided to measure actual flow rate. The system is mounted on a table top model with all necessary piping.
-
Product
Flow Measurement Trainer Using Orifice Meter
-
Unitech Scales And Measurements Pvt. Ltd
This setup is a table top model, it comprises of source and measuring tank. The measuring tank is of acrylic with liters graduated. A small FHP pump is fitted to circulate the water. A orifice meter with U-tube manometer is provided to measure the flow rate. A rotameter is provided to measure the exact flow rate. Control valve is provided to control the water flow rate. Digital timer is provided to notedown the duration of flow.
-
Product
Lake Variable Area Flow Meters
-
Lake Variable Area flow meters, often referred to as rotameters, measure flow rate of a liquid or gas by relating linear displacement of an internal “float” or sharp-edged orifice plate (Lake) to a corresponding flow rate. As flow rate increases, the orifice area that the flow moves through also increases – thus, the term “Variable Area.” Variable Area meters either allow flow through a peripheral orifice formed between a tapered wall and a float as in the traditional rotameter, or an annular orifice and an internal tapered metering pin in the Lake Monitor.
-
Product
EZ-View Flow Meters
-
Hedland EZ-View flow meters provide a lower cost alternative to standard Hedland flow meters. Made from high-impact thermoplastics like polysulfone and Radel, these variable area meters (rotameters) contain a minimum number of moving parts, offering a reliable, trouble-free flow rate indicator. Fittings, available in brass, stainless steel and PVC, with NPT or BSP ports, allow the meter to be installed in a wide variety of applications. Meters can be used in oil and water processes, with the ability to add a flow switch, which can be used to trigger alarms.
-
Product
Rotameter Measurement Trainer Module
-
Unitech Scales And Measurements Pvt. Ltd
The setup is a table top module, it comprises of source and measuring tank. The measuring tank is made of acrylic material with gradation marked in liters. A small FHP pump is fitted to circulate the water. A rotameter with control valve is used to measure the flow rate. Digital timer is provided to note down the duration of flow and the volume of water is measured by the markings on the measuring tank to calculate the actual flow rate
-
Product
YOKOGAWA Meter
-
Wuxi IMHOO Technology Co., Ltd.
They are widely used for monitoring electrical power, flow rates (rotameters), pressure, and temperature in demanding industrial environments.
