-
product
Low Voltage High Current DC Electronic Load
N62400 Series
Next Generation Instrumental (Shanghai) T&C Tech. Co., Ltd.
N62400 series is developed based on NGI's years of experience in testing for fuel cell. It is with high accuracy, high reliability and high cost-effective. N62400 series is with high power density and elegant appearance, which is available for benchtop use or installation in 19 inch cabinet.
-
product
On-Off Controllers
The STM6600 and STM6601 smart push-button on/off controller chips offer protection for battery-operated devices in many ways. These include minimizing the risk of powering up without sufficient battery energy to complete the sequence, which can damage the system. It can also prevent power-up if it detects a fault in the power supply.
-
product
PXI Hex 4:1 High Voltage Power MUX
40-331-004
The Pickering Interfaces 40-331/332 High Voltage Power Multiplexer and Matrix Modules are suitable for applications requiring high voltage power relay switching with high density. They feature current handling up to 5A, 1000VDC/1000VDC peak cold switching and 110VDC/250VAC hot switching. The 40-331 is available as a single 24:1, dual 12:1, quad 6:1, hex 4:1, octal 3:1 or twelve 2:1 multiplexer, and the 40-332 is available in 12x2 or 6x4 matrix configurations. Connections are made via a front panel mounted 37 pin high voltage D-Type connector.
-
product
*Pulse Characterization Sensors
Pulse Characterization Sensors provide the ability to see and measure the temporal characteristics of pulsed and CW laser beams. Ophir Fast Photodiode Detectors are designed to convert optical signals into electrical signals which are then measured with third-party instrumentation such as oscilloscopes and spectrum analyzers. Accessories are available to connect to IS6 integrating spheres or fiber optic cables. Attenuating filter accessories are also available to increase their dynamic range. Di...show more -
product
Three Phase Power Meter
929A
Model 929A Three Phase Power Meter is an economical alternative to both the Model 931A Power System Analyzer and the Model 930A Three Phase Power Analyzer when serial communication, dc voltage measurement, transducer calibration and timer features are not required. The Model 929A has the same ac accuracy as the Model 931A with PowerDSA™ Digital Signal Analysis, and is a complete diagnostic tool for use in the substation and industrial power environment.
-
product
Pico-ITX Embedded Board
The Pico-ITX board is the world’s smallest x86 embedded board, measured at the size of 100 mm x 72 mm only. The Pico-ITX SBC provides system developers and OEMs with an ultra compact yet highly integrated platforms that deliver excellent computing performance at remarkably low power consumption. For car PCs, in-flight entertainment systems, industrial automation systems and even portable devices, the Pico-ITX SBC meets customer's demands in compact-size, fanless operation, low power consumption and versatile I/O.
-
product
Hi-Speed Discrete Test System
QT-6000
QT-6000 Test System, with built-in capacitance test (DC+CAP) and Scanbox etc, is applicable to devices like medium & small power transistors, MOS-FET, diodes and Wafer.
-
product
Mini Power, ITA, 36", 50u Gold (22 Amps), 16 AWG White Teflon (19 Amps), Single-Ended
7-243916000-036
Mini Power, ITA, 36", 50u Gold (22 Amps), 16 AWG White Teflon (19 Amps), Single-Ended
-
product
Digital Power Meter
2406B
‧Simultaneous display of W, A, V (PF or Hz)‧True RMS V, A, W‧Auto calibration via computer‧Data Hold∕Range Hold function‧Hight immunity to external noise‧CT ratio (1～99)‧REF function (0.800 ～ 1.200)‧Aux. power is AC 90 ～ 260V, 50/60Hz‧RS-232 interface (option)
-
product
Industrial UPS Systems
Our static uninterruptible power supply systems (UPS systems) correspond to the VFI-SS-11 classification according to IEC 62040-3.
-
product
Coupler And Decoupler Used With Lightning Impulse Simulation Tester
All electric equipments & systems is required Impulse Simulation Test to the to be tested under the condition where the power source is applied to the product-under-test.At this test condition, the decoupler is needed to reduce the impulse flowing through the power line while testing. And the coupler which is inserted between tester and product, to simulate the actual condition, so the electric circuit of decoupler is prescribet by IEC rules.
-
product
AC/DC Current Clamp Probe,DC~1MHz(-3db)
CP-07B
●Connect to Oscilloscope.●AC/DC current Measurement.●4A ,2us, 40A,2us test range.●Bandwidth: DC~1MHz(-3db). ●Rise time:0.35μs●Noise level: 5mA●Jaw size: 5mm max.●Auto zero at power on.●Relative zero correction.
-
product
Low Voltage Power Supplies
We offer low-voltage power supplies in the power range up to 100,000W (customer-specifically even higher). , They are designed for maximum output voltages of 6.5V to 350V and are continuously adjustable from zero to maximum. Our low-voltage power supplies can be operated in constant voltage mode as well as in constant current mode. This enables unlimited operation at any time with the maximum current that can be supplied (even in the event of a short circuit). They are suitable for ohmic loads as well as inductive or capacitive loads and are characterized by a service-friendly design,
-
product
RX Family Of 32-bit High Power Efficiency MCUs
The RX family consists of four product series: the flagship RX700 series, with the fastest performance and most advanced functions; the standard RX600 series; the RX200 series, which delivers an optimal balance of power efficiency and high performance; and the entry-level RX100 series, with extremely low power consumption. These four series encompass a range of products that provide seamless scalability from small-scale to large-scale applications.
-
product
SpikeSafe DC Current Sources
The Vektrex SpikeSafe DC Current Sources provide reliable drive for LED/laser diode reliability, IESNA LM-80 test, and other current-driven test applications. Models support currents from 500mA to 60A and compliance voltages from 50V to 400V. All models feature individual channel control, precise current, and high power density — typically 6.4kW-8kW.
-
product
Industrial Mini-ITX Motherboard With 14/13/12th Gen Intel® Core™ I9/i7/i5/i3 Processors
AmITX-RL-I
- 14/13/12th Gen Intel® Core™ i9/i7/i5/i3 processors and Q670 chipset, up to 65W- Dual-channel DDR5 4800 MHz memory up to 64 GB- Quad. independent display: HDMI 2.0b, HDMI 1.4b, DP 1.4a, LVDS or eDP- Dual GbE ports: 1x 1GbE, 1x 2.5GbE- Expansion slots: 1x PCIe x16, 4x USB 3.2 Gen2, 2x USB 3.2 Gen1, 4x USB 2.0, 1x M.2 B-key, 1x M.2 E-key, 2x M.2 M-key- Support ATX (24+4 pin) or 12V DC-in power input
-
product
External Frontend
FE44S
The R&S®FE44S external frontend can extend the frequency range up to 44 GHz for Rohde&Schwarz signal and spectrum analyzers as well as signal generators. The R&S®FE44S enables signal up and downconversion directly at the device under test (DUT), lowering cable losses, increasing sensitivity and delivering more power at the antenna in an OTA environment. The R&S®FE44S uses a single RF connector to further reduce the number of antennas in over the air testing.
-
product
Portable Power Source - Power Transformer and Charger Manufacturer
JYUE LII INTERNATIONAL CO., LTD.
A&V power transformer supplies and manufactures certified portable power source and charger with industrial UL / cULus / CB / CE / TUV & ISO 9001:14001 certified electrical products and manufacturing facilities based in Taiwan. Portable Power Source Includes C Series, H Series, J Series, L Series, M Series, P Series, Q Series, W Series, Power Bank Series Portable Power Source
-
product
PMA Suite For The PSL-3424: 802.3at And 802.3bt PSE's
*Tests 802.3 at/bt PSE’s with Any Combination of 2-Pair and 4-Pair PSE ports up to 90W per port*Automatically assess PSE PM Stability and Capacity Management*Tests PSE’s that grant power with Multi-Event, LLDP, or Both Multi-Event and LLDP*Automatically Adapts to PSE maximum assigned class (MAC) and power demotions on 2-Pair and 4-Pair ports*Tests PSE’s with up to 96 PoE Ports*Emulated PD’s are 802.3 specification compliant including built-in support for multi-event classification, power demotion, and 802.3at/802.3bt LLDP*Highly Informative Reports cover dozens of parameters using Colorful Graphics*Available to PSL-3424A and PSL-3424L as optional license feature
-
product
dB Meter
The dB meter is used to determine the stability or fluctuations of the optical power over a large dynamic range with high accuracy and measurement speed. A fiber-coupled, power-stabilized 1.55µm laser diode is built into the device to enable simple and quick testing of passive fiber optic components or local fiber loops. Alternatively, light from external light sources in the wavelength range 780nm-1650nm can also be used.
-
product
Resistors
SemiGen builds high power tantalum nitride resistor chips to customer specifications. We can manufacture chip resistors using a variety of substrates in various thicknesses to meet your specific needs. Resistors can be produced with element features under 0.002 inch for high density or high value resistor applications. Low noise stable TCR and chip sizes under 0.010 inch x 0.020 inch are routinely processed in production quantities. SemiGen’s series of Thin Film Resistors offer proven stability,...show more -
product
Bench Power Supply, DC, Single, Adjustable, 1 Output, 1 V, 36 V, 0 A, 3 A
72-8345A
Switch Mode Laboratory DC Power Supplies Precision adjustable supply provides adjustable 1~36VDC output with adjustable current limiting from 0~3A. It is ideal for test, measurement and service applications where tight voltage and current regulation are critical. Highly efficient switch mode design delivers outstanding performance from an extremely compact footprint. Unique separate output ON/OFF control allows voltage and current setting, with the supply output turned off. Part of a Complete Series, this slim supply occupies little bench space while providing very high precision and 90W of continuous output.
-
product
4-Pin Power D-Type Female to Unterminated With Tinned Ends
A008PF4-T-6A100
The 4-Pin Power D-Type Connector to Unterminated Cable Assy is constructed from PVC insulated 56/0.3 (12AWG) Copper wire. The connector can be secured to the product by screwlocks and the unterminated connections are coded to match the connector pin designation.
-
product
Heat Stress WBGT Meter
Heat Stress Index measures how hot it feels when humidity iscombined with temperature, air movement, and radiant heat Black Globe Temperature (TG) monitors the effectsof direct solarradiation on an exposed surface Air Temperature (TA) plus Relative Humidity (RH) Selectable units of F and C In/Out Function displays the WGBT value withor without direct sun exposure Auto Power Off with override Built-in RS-232 interface with optional Windowscompatible software Complete with two AAA batteries
-
product
Power Management Devices
We support your upcoming designs with our comprehensive portfolio and innovative solutions. Our low-power-consumption solutions allow battery-powered systems to operate for a longer time, while our digitally enhanced products provide industry-leading flexibilities in both development and production environments.
-
product
Solid State Relays
As well as being slim and thus saving panel space, The relays are very strong, have a large contact area and non-bendable pins. Connection to a PLC is easy and achieved faultlessly in a few seconds via click connectors. In addition, power switching in G3RV relays with DC outputs is managed by a MOSFET in the output, which has ideal heat dissipation characteristics.
-
product
AE Valve Leakage Detector
SVLD1
Through acquisition, processing, and calculation of acoustic emission signal of the valves, SVLD1 could generated root-mean-square voltage (RMS), average signal level (ASL) and power (P) parameters as which could judge the leakage. Meantime, you can pre-calibrate the leakage quantity for the specified valve, and calibration curve of parameters and leakage could be calculated by SVLD1, so as to give the valve leakage reference value during the test.
-
product
Real Time Power Sensors
Providing the highest video bandwidth and fastest rise times, RTP5000 peak power sensors with Boonton’s Real-Time Power ProcessingTM deliver 100,000 measurements per second, no gaps in signal acquisition and zero measurement latency.
-
product
Power Discretes
Our power discrete products are high-quality solutions for a wide range of high-voltage and high-power applications. They include a variety of high-voltage Switch Mode Power Supply (SMPS) transistors—Insulated-Gate Bipolar Transistors (IGBTs) Silicon Carbide (SiC) MOSFETs and Silicon MOSFETs—Diodes and Radio Frequency (RF) MOSFETs. Many of our products are offered in single- and combi-packaged options across a variety of voltage ratings, currents, and package styles.
-
product
Fiber Optic Power Meters
FOD 1202
The FOD 1202 & FOD 1202Si triple wavelength power meters are reliable, rugged and hand-held test product. InGaAs & Si Version with triple wavelength calibration
