Filter Results By:

Products

Applications

Manufacturers

Instruments

read precision values.

See Also: Instrument Cables, Modular Instruments, Instrumentation Amplifiers


Showing product results. 3301 - 3315 of 5053 products found.

  • Portable Hipot Tester

    HTNY-H - Wuhan Huatian Electric Power Automation Co., Ltd.

    All kinds of motor、electric appliance、instruments and apparatus、Test the safety withstand voltage and leakage current of high power system.

  • Engine Performance/Endurance Test System

    Ono Sokki

    Various types of test system as follows can be built up in combination with measurement control equipment and peripheral instruments (fuel flow meters, actuators, temperature control device, combustion analysis system, ECU monitor, OBD, sound and vibration measurement instruments, emission analyzer, smoke meter etc.)·Traveling fuel economy test·Gas emission test·Output performance test·Deterioration/endurance test·Combustion analysis·Sound source probing

  • Digital Anemometer w/ Humidity Tester

    DAFM3B - UEi Test & Measurement Instruments

    The DAFM3B Anemometer/ Psychrometer meter is designed with 6 HVAC/R must have parameters in one instrument. These are included in a portable battery operated instrument for measuring humidity, air temperature, dew point and calculating wet bulb, air velocity and air volume. The sensor is built into the remote fan and is specially protected by a twist cap. While in operation, open the cap for accurate temperature and humidity readings.

  • Digital RF Power Monitor

    3024 - LBA Group, Inc

    The COMM-connect 3024 RF Power Monitor from LBA Technology can control up to 8 external RF Measuring heads. The high dynamic range with external couplers and RF measuring heads cover from 1W to 1MW. The Power conversion algorithms handles multi carrier, multi mode, peak, average and RMS signals. The power readout is auto scaled and VSWR can be calculated between any probes. Also the measured and calculated results along with alarms can be shown in the local LCD. The instrument has SNMP support to allow network management. The instrument can be configured for VSWR and Power limits to give alarms. The alarms can be configured to operate relay drivers or isolated Optcouplers. The alarms can also be configured as SNMP traps sending relevant information to the network control center. The COMM-connect 3024 WEB enabled RF Power Monitor gives an unlimited number of applications to monitor and control the last part of your RF network installation from transmitters to the antenna.

  • High Flux Beam Concentrator Simulator

    High Flux Solar Simulator - TS Space Systems

    TS-Space Systems is now proud to announce its world leading solar simulator technology is now available for concentrator high flux beam simulator applications. Class A Concentrator Solar Simulators Our ''Class A'' high flux beam systems are available with the following specifications: 600 suns @ 10mmx10mm area 1200 suns @ 10mmx10mm area Close Match Concentrator Solar Simulators Modifications can be made to our close match ''Unisim'' solar simulators to provide a concentrator solar simulator. This provides the world leading AM1.5 spectral close-match of TS-Space systems in a high flux beam concentrator solar simulator of 40-50 suns. Product support is very important to us. Training is provided at our premises where customers can take advantage of one-on-one tuition with the instrument designers and learn how to operate and maintain their tools. Extensive support via phone and email for the full lifetime of the instrument is included with every TS-Space Systems product.

  • Isotopic Water Analyzer (Liquid+Vapor) - Enhanced Performance

    Los Gatos Research, Inc.

    LGR’s Isotopic Water Analyzer (model IWA-45EP) is the world’s most advanced instrument for measurements of both isotopic liquid water (including wines) and water vapor. The IWA-45EP combines the features of LGR’s Liquid Water Isotope Analyzer and Water Vapor Isotope Analyzer (Enhanced Performance model) in a single instrument. For liquid water samples, the IWA-45EP reports measurements at a rate of over 800 injections per day. With the typical operating procedure (6 injections per sample), this measurement rate yields over 130 total samples per day. For continuous measurements of water vapor, the IWA-45EP reports δ17O , δ18O and δ2H and water vapor mole fraction over a range of mole fractions greater than 60000 ppm H2O in air. Changing between operational modes could not be simpler - with only a simple switch, the user can switch from measuring liquid water to measuring water vapor, or vice versa.

  • Motor/Generator Test Equipment

    IBEKO Power AB

    Winding ohmmeters RMO-M series measure winding resistance of inductive test objects such as electrical motors and generators. Motor test or generator test of winding resistance is especially important for early-stage failure detection.RMO-M series instruments generate true DC ripple-free current with automatically regulated measurement and discharge process. Even more, test instruments are portable and enclosed in a metal casing.Applications supported by DV Power motor/generator test equipment include:Winding resistance measurement of generators and electrical motorsResistance measurement of high-current bus bar jointsResistance measurement of cable splicesAll of the above-mentioned measurements are performed with the highest accuracy. The advanced DV-Win PC software enables collecting both numerical and graphical results. These features provide an easier and more efficient analysis. After the test, a DV-Win software generates a test report a single click. Finally, a user can easily customize the report and save it in different formats, such as XLS and PDF.

  • Partial discharge measuring systems

    PRESCO AG

    Partial discharge (PD) is a electrical discharge that only partially overbridges the insulation between conductors. Generally PD appear as pulses of duration of much less than 1s. The significance of PD in the lifetime of insulations has long been recognised. Every discharge event causes a deterioration of the material by the energy impact of high energy electrons and causing chemical transformations of many kinds. PD-4 Professional partial discharge measuring instrument PD-5 Industry partial discharge measuring instrument Battery Calibrator Calibration standard according IEC 60270 -2000 PD-MUX x-channel PD multiplexer Capacitors Presco AG provides different series of: coupling-, standard air-, solid state- and compressed gas standard capacitors for different applications in high precision high voltage measurements. Technical Information about PD- Measurement Technical Information about PD- Calibrators Technical Information about background Noise

  • Scanning Electron Microscopy

    SEM - Materials Evaluation and Engineering

    JEOL JSM-6610 LV LaboratoryScanning electron  microscopy (SEM) uses electrons for imaging to obtain higher magnifications and greater depth of field than light microscopes. The instruments at MEE are capable of variable-pressure, or low vacuum, SEM (VPSEM), as well as traditional high-vacuum conditions for sample observation. VPSEM is a specialized method using a variable-pressure sample chamber that allows direct evaluation of samples that are not readily examined with a traditional high-vacuum SEM. Nonconductive or vacuum sensitive samples that would typically require additional sample preparation can be directly analyzed in VPSEM without the need for additional sample preparation, such as carbon or metallic conductive coatings. This reduces both sample preparation time and distractions in microanalysis. Our laboratory also has a field emission SEM (FESEM) for critical high-magnification work and low-voltage (LVSEM) applications. Each instrument has a spacious sample chamber that can accommodate large and irregularly-shaped specimens and accessories for feature dimensional analysis and chemical microanalysis.

  • Signal Level Meter

    XR-3 - Applied Instruments, Inc.

    From satellite dish alignment, to UHF off-air antenna pointing, to cable TV MER measurements, the XR-3 is the meter for you! The XR-3 is the most capable meter offered by Applied Instruments. It's more durable than the popular Super Buddy meter, and has added features and performance. The XR-3's modular design with field swappable modules provides wide versatility to fit different measurement applications, including DBS satellite (i.e. Dish Network, DIRECTV, Bell TV, Shaw Direct), VSAT satellite (i.e. iDirect, Hughes Ku band, and more), VHF/UHF off-air (analog and ATSC digital), and CATV (QAM and analog). The XR-3 is great for installing and troubleshooting DISH SmartBox, Blonder Tongue, and other SMATV headend systems often used in hotels, multi-dwelling units, and institutional facilities. Modular Test Instrument. Satellite Finder. Installer Signal Meters. CATV Analyzer. Modules.

  • Universal Tensile Testing Machines

    Dongguan Amade Instruments Technology Co., Ltd

    Universal tensile testing machines are testing equipment that are used to conduct mechanical testings of static load, tensile, compression, bending, shearing, tearing, stripping, applied to plastic sheets, pipes, tapes, rubbers, electric wires, springs, sponges, fibers etc. Tensile test is performed to measure and analyze the physical performances of different types of materials and finial products, playing an important role in developing new materials and controlling products quality. From the perspective of function, universal tensile testing(UTM) machine is an omnipotent instrument Just as the name implies. Clamps or fixtures are interchangeable on the basis of different test pieces, enabling various testings to be carried out on one tensile testing instrument. Options of single-column stand or twin-column stand can be available based on the specimen’s tensile/compressive force and dimension. Computerized tensile tester is preferred rather than microprocessor version If users want testing results including curve graphics between time, force and displacement.

  • 5KV Digital Insulation Resistance Tester

    Neutronics Manufacturing Co.

    The high voltage insulation resistance tester is a handheld instrument designed primarily to measure AC DC voltage. Resistance, Continuity test/Insulation resistance.

  • 10A DIGITAL MICRO-OHMMETER

    MPK-2000e - MEGABRAS srl

    The MPK-2000e digital very low resistance ohmmeter is a portable, microprocessor controlled instrument used to accurately measure resistances of switches and circuit breaker contacts, transformer and motor windings, wire and cable samples, joints in busbars, etc., using test currents from 1mA up to 10A. It uses the Kelvin-type, four-terminals measurement principle, thus eliminating errors caused by lead and contact resistances.

  • 24-Channel Seismograph

    GEA24 - PASI srl

    GEA24 is a compact 24-channel seismograph (serializable up to 48 channels) with 24-bit acquisition card and USB interface for external PC (not included in the supply). Suitable for all applications ( masw, refraction, hvsr, downhole and crosshole), GEA-24 is the reliable and economical solution for all professional uses; connected to your laptop or tablet PC, GEA24 transforms itself into an easy-to-use seismic instrument with maximum performance.

  • 2-in-1 Laser Engine

    iFLEX-Gemini - Qioptiq SAS

    This compact laser engine has 2 lasers and 1 combined output. Each laser is independently controlled and both wavelengths are combined in one co-axial output beam. Originally designed to replace bulky gas lasers, it is small and portable, yet delivers a highly stable performance. The robust opto-mechanical design means no laser re-alignment is required. The iFLEX-Gemini is easy to integrate in instruments and easy to use in a laboratory.

Get Help