-
product
3-AXIS DIGITAL AC GAUSSMETER: 1-200 kHz
IDR-200
Integrity Design and Reseach Corp.
Typical Applications include checking the frequencies and magnetic fields (BW: 1 kHz -200 kHz) produced by equipments such as computer monitors, television sets, video display terminals, induction heaters, industrial, Radar, scientific/medical equipment, walk-through/hand-held detectors and ground wave energy network; etc. For more information about VLF magnetic fields and the VLF gaussmeter , see the paper titled "Very-low-frequency electromagnetic field detector with data acquisition," IEEE Trans. Instrum. Meas.,vol. 58, no. 1, pp. 129-140, Dec. 2008. by S. Hanna.
-
product
Leakage Current Tester
Test Voltage : - 1V to 500V DC settableAccuracy : ± 1% of set Value ± 1digitLeakage Current : - Accuracy - ± 0.5% ± 1digitDigital Model – 19.99μA / 199.9 μA / 1.999mA / 19.99mAAnalog Model - 10μA /25μA/100 μA/1mA/2.5mA/10mASeparate Indication for Charge / Measure and Discharge modeAvailable in Digital Version Also
-
product
Automated Pit Identification and Measurement Software
APIMS
Surface pitting processes are ubiquitous in material science and engineering applications. Rigorous analysis of surface pitting features is time-consuming and error-prone whenever manual measurements are employed. Barron Associates’ APIMS software eliminates the need for tedious manual pit measurements. APIMS analyzes digital surface profilometry data and automatically identifies the location and size (width and depth) of surface pits. APIMS provides built-in noise reduction features to enhance performance and reduce both measurement noise and surface tilt.
-
product
3 AXIS DIGITAL AC GAUSSMETER
IDR-fw4180
Integrity Design and Reseach Corp.
This FWBELL 4190 model features three axis sensors which insure that measurements remain accurate regardless of the orientation of the instrument.
-
product
NI-9477, 60 V, 32-Channel (Sinking Output), 8 µs C Series Digital Module
780174-01
60 V, 32-Channel (Sinking Output), 8 µs C Series Digital Module - The NI‑9477 works with industrial logic levels and signals to connect directly to a wide array of industrial relays, solenoids, and motors. Each channel is compatible with signals from 5 V to 60 V and … features isolation from channel‑to‑earth ground. You can wire the NI‑9477 channels in parallel to sink up to 20 A of current per module (1 A per channel maximum).
-
product
Thermometers
Shanghai Beha Electronics Co., Ltd.
*Digital Thermometer with Connection for two Temperature Probes Type k*Simultaneous display for two measurement values*Backlight*Measures Temperature Difference (T1-T2)*Timer functionIntegrated Data Hold*Min/Max and relative value measurement
-
product
Digital Clamp Tester With 80mm X 74mm CT With Bluetooth40mmφCT, ACA
MCL-800DX
MULTI MEASURING INSTRUMENTS Co., Ltd.
Next-generation leakage current clamp meter with connection, via Bluetooth, to a smartphone which displays waveforms and data.
-
product
Digital Vacuum Gauge
605
Range : 0 ~ 12,000 microns (0~1600 Pascals). Units of Measure : Microns, PSI, InHg, mBar, Pascals, Torr, mTorr. Over Pressure : 500PSI
-
product
Digital TTL Control Modules - Programmable Module Accessories
Digital TTL Control Modules - Programmable Module Accessories by Pasternack
-
product
Comprehensive Portfolio of Digital Manufacturing Solutions
Tecnomatix
Siemens Digital Industries Software
Tecnomatix is a comprehensive portfolio of digital manufacturing solutions that help you to digitalize manufacturing and the process of transforming innovative ideas and raw materials into real products. With Tecnomatix software you achieve synchronization between product engineering, manufacturing engineering, production and service operations to maximize your production efficiency and realize innovation.
-
product
Force Gauges
SHIMPO offers a range of digital and mechanical force gauges to suite every application from low capacities (0.5 lbs) to high capacities (1,000 lbs). Our gauge's features range from simple, no output models to highly sophisticated units that provide memory, statistics and data output. Our gauges are known for their strong construction and highly accurate measurements.
-
product
Multimeter Digital
MY64
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
multimeter digital 1999 counts display with holster Frequency temperature MY64 V&A
-
product
Low Cost Microwave Wideband Electro-absorption DFB Transmitter (without RF Amp)
MT60 (40KHz~33GHz)
Hangzhou Huatai Optic Tech. Co., Ltd.
MT60 series microwave DML optical transmitter, are able to transmit 33G microwave RF signal with long distance, wide bandwidth, and flat responsibility. They provide an outstanding linearity fiber optical communication for analogue and digital wideband microwave application. Due to avoidance of using expensive coaxial cable or wave guide, there will be no limitation in transmission distance, which improves the signal quality and reliability of the microwave communication. They can be widely appl...show more -
product
700/800 MHz Band RF Digital Signal Boosters
Bird SBIII Series Digital Signal Boosters address the requirement to tightly control the frequency or frequencies that need to be received and transmitted. The SBIII series uses Digital Technology that can be programmed through software to manage a signal window as narrow as 6.25 kHz and as wide as 15 MHz for the 700-800 MHz bands and as narrow as 6.25 kHz and as wide as 1.5 MHz for the UHF band.
-
-
product
High Speed Digitizers
High performance and high speed digitizers with wide bandwidth and high dynamic range. Featuring high-speed Analog-to-Digital Converters (ADC) with Real-Time Field Programmable Gate Array (FPGA) based digital processors. Long acquisition memory coupled with fast PCIe offload and streaming over optical data interfaces (ODI).
-
product
Digital Viscometer
ndj-5s, ndj-8s
Viscometer is used to measure viscosity resistance and absolute viscosity of fluids, including liquid, oil, food, medicines, adhesive, etc
-
product
Analogue+Digital Multimeter
ST-3502
Standard Electric Works Co., Ltd
● 3½ digit, high contrast LCD, with a maximum display of 1999● Automatic polarity indication, zero adjustment● Low battery (BAT) indication● Over range indication: highest digit of (1) or (-1)● EN 61010-1 CAT III 600V, EN 61326-1
-
product
Signal Generator
SG-1501B
Features :*Programmable up to 110MHz stereo*100 types of programmable steps*Phase-locked loop digital synthesis generator*Output level -200dBu to 100dBu (in 1dB step)*7digit LED frequency display*With auto test function
-
-
product
Cable Tracers
Shanghai Beha Electronics Co., Ltd.
*Trace wires or cables.*Continuity and polarity testing.*Digital Multimeter
-
product
3-Channel 200 MHz A/D and 2-Channel 800 MHz D/A with Virtex-6 FPGA - XMC
Model 71620
- Complete radar and software radio interface solution- Supports Xilinx Virtex-6 LXT and SXT FPGAs- Three 200 MHz 16-bit A/Ds- One digital upconverter- Two 800 MHz 16-bit D/As- Up to 2 GB of DDR3 SDRAM or 32 MB of QDRII+ SRAM- Sample clock synchronization to an external system reference- Front panel clock/sync bus for multimodule synchronization- PCI Express (Gen. 1 & 2) interface up to x8 wide- Optional user configurable gigabit serial interface- Optional LVDS connections to the Virtex-6 FPGA for custom I/O- RoHS Compliant Lead-Free Version Available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
product
Coating Thickness Gauge
CM8855
It meets the standards of both ISO2178 and ISO 2361 as well as DIN, ASTMand BS. It can be used both in the laboratory and in harsh field conditions. The F probes measure the thickness of non-magnetic materials (e.g. paint,plastic, porcelain enamel, copper, zinc, aluminum , chrome etc.) on magneticmaterials (e.g. iron, nickel etc.) . often used to measure the thickness ofgalvanizing layer, lacquer layer,porcelain enamel layer, phosphidelayer, copper tile, aluminum tile, some alloy tile, paper etc...show more -
product
DSP Module
CPCI-QIPC-6U
The CPCI-4pack-6U module provides a high performance flexible I/O scheme, that supports industry standard Industry PacksÔ. For application requiring low cost, high density I/O or unique combinations, the CPCI-4pack-6U is the perfect solution. The Local DSP can be used to simply move data to and from the CPCI bus or provide pre processing functions such as local PID controls, FFT’s, digital filtering, etc. Custom application software can be downloaded to the DSPvia the CPCI bus or the local serial port.
-
product
Digital Tachometers
.Wide measuring range and high resolution.Both photoelectric and contact measuring (DT-6236B).Max. value, Min. value and last value memory.Low battery indication
-
product
Wideband Digital Down Converter
A Digital Down Converter performs channel access functions in digital receivers. It is used for extracting a channel (frequency band) of interest in a wideband signal. Abaco Systems' wideband DDC core employs a quad DDC architecture to achieve ultra high performances. The core accepts up to 16-bit complex data and can process 1GSPS continuously. With a fully programmable architecture at all stages of the processing, this core combines flexibility and speed and can be used in combination with our dual-channel 1GSPS ADC module.
-
product
Isolated Interfaces
Isolate high-speed digital signals with ST's robust, reliable and flexible digital isolated interfaces.
-
product
Oscilloscope - 200 MHz, 2 Analog Channels
DSOX4022A
200 MHz2 analog channels Easily view signals on the large 12.1-inch capacitive touch screen Isolate signals in seconds with exclusive Zone touch triggering Capture more data with 4 Mpts memory with segmented memory standard See more signal detail with the 1,000,000 wfms/s update rate Expand your measurement capabilities with full upgradability: Add bandwidth, digital channels, Dual-ch 20 MHz arbitrary waveform generator, 3-digit DVM, serial trigger and analysis & mask testing at any time
-
product
Digital Circuit Tester 3-49V
28830
Operating range of 3-49 volts DC to work on most vehicle electrical systems. 360° visibility of polarity. The red light indicates positive polarity, green indicates negative polarity. Long, 12ft. coil cord and heavy-duty alligator clamp for secure connections. The probe is insulated to prevent the possibility of shorting the side of the probe to other components.
-
product
PXI-6513, 64-Channel, ±30 VDC, Sink Outputs, Bank-Isolated PXI Digital I/O Module
778971-01
64-Channel, ±30 VDC, Sink Outputs, Bank-Isolated PXI Digital I/O Module—The PXI‑6513 is an industrial digital output interface with eight banks of isolated channels. With programmable power-up states, you can configure the initial output states in software to ensure safe operation when connected to industrial actuators. If a computer or application fault occurs, the PXI‑6513 can use digital I/O watchdogs to switch to a configurable safe output state to ensure detection and safe recovery from fault conditions.
