Showing product results. 406 - 420 of 679 products found.
-
DCS-120 MP - Becker & Hickl GmbH
*Multiphoton FLIM Upgrade for Existing Conventional Microscope*Two Fully Parallel TCSPC FLIM Channels*Compact bh Simple-Tau or Power-Tau System*Scanning by Fast Galvanometer Mirrors*Channel Seperation by Dichroic or Polarising Beamsplitters*Individually Selectable Pinholes and Filters*Excitation by Ti:Sa Laser*Two Non-Descanned Detection Channels*Two HPM-100-40 GaAsP Hybrid Detectors*Optional: Two HPM-100-06 Hybrid Detectors, IRF Width < 20 ps FWHM*Optional: HPM-100-50 Hybrid Detectors for NIR FLIM*Optional: Multi-Wavelength FLIM*Excellent Time Resolution: Electrical IRF Width 6.5 ps FWHM*Time Channel Width Down to 813 fs*Megapixel FLIM, Up to 2048 x 2048 Pixels at 256 Time Channels*Simultaneous FLIM/PLIM*Electronic Pinhole Alignment*Z-Stack FLIM Acquisition with Zeiss Axio Observer Z1*Optional: Spatial Mosaic FLIM via Motorized Sample Stage*Laser Control via SPCM Software
-
Solo C3 - Detectortesters
Many multi-sensor fire detectors detect carbon monoxide (CO) as well as smoke and / or heat. Under international codes and standards the CO cell needs to be functionally tested with a CO stimulus from the protected area through the detector vents to the sensor.
-
Laser Components IG, Inc.
Detector modules, into which the entire drive electronics have been integrated, were developed to facilitate the application of detectors. PIN modules and APD modules are available along with intelligent sensors which are – thanks to their interfaces – ready for application in Industry 4.0.
-
LT Laser Tools GmbH
Detector modules, into which the entire drive electronics have been integrated, were developed to facilitate the application of detectors. PIN modules and APD modules are available along with intelligent sensors which are – thanks to their interfaces – ready for application in Industry 4.0.
-
IN042 - MSA
The IN042 is a four zone input module designed for use with two-wire field devices such as smoke or heat detectors, pull switches and manual callpoints. It is designed to monitor these devices and provide both status indication and fault / alarm outputs for each zone.
-
El-Mul Technologies
Systems utilizing multiple electron beams are an emerging semiconductor metrology technology that aims to increase throughput. El-Mul is a pioneer in developing detection solutions for such metrology systems and has designed and manufactured prototype detectors that can simultaneously detect 144 beams at 35MHz.
-
LC-4000 Series - Jasco Analytical Instruments
The LC-4000 Series UHPLC system offers high performance separations at up to 130MPa (around 20,000psi) for use with the smallest particle sizes and longest column lengths. The pump, autosampler and detectors are optimized for the smallest band broadening and fastest cycle times.
-
Boltek Corp.
Check out all of our accessories for a perfect compliment to any of our lightning detectors. They are designed fora wide range of applications and installation setups, and even for a more personalized custom setup, or simply tohave on hand for spare replacement parts.
-
BoilerSpection MB - Advanced Energy
Advanced Energy's BoilerSpection MB imaging system utilizes special mid-wave infrared detectors to see through flames. This unique feature means BoilerSpection MB can provide the clearest and most stable through-flame images in boilers, furnaces, kilns, or incinerators.
-
IR-518/301 - Infrared Systems Development Corp.
The IR-518 Radiation Source provides an accurate, stable source of infrared radiation of known flux and spectral distribution. It can be used as a standard radiation source for the calibration of other laboratory sources, detectors, or other infrared devices requiring calibration against a standard.
-
PGS Series - Carl Zeiss AG
ZEISS PGS modules with a spectral coverage of 960 - 2200 nm are among the market leading NIR spectrometers, providing a small footprint, highest throughput and excellent SNR. Special TE-cooled/uncooled InGaAs detectors ensure lowest noise conditions.
-
MT - Sunpower Inc.
The MT cooler has been in production since 2003 and is based on the CT cooler design. It was developed for the customer who did not need the lift of the CT cryocooler and wanted size and weight reduction for their application. The MT has been used successfully in applications such as High Temperature Superconductivity (HTS) filters, high altitude balloons, refrigeration, germanium detectors, IR detectors, radio telescopes, laser diode cooling, and research among others. We believe the customer will agree that the CryoTel® MT is the smallest 5W @77K cooler available at an attractive price point with a Mean Time to Failure of over 200,000 hours.
-
SDi
estifire is the world's first multi-stimulus detector tester for smoke, heat and CO fire detectors. It enables faster and more efficient testing of both single and multi-sensor detectors. There are two models available Testifire 1000 for testing smoke and heat and Testifire 2000 for testing smoke, heat and CO. Testifire is the result of several years of technological development and as a result is by far the most advanced tester available. Testifire is UL certified and is approved by leading detector manufacturers from around the world.Read more at the dedicated Testifire website or select from the products below alternatively view our wider range of kits including access poles and removal tools.
-
Bunkoukeiki Co., Ltd
It is a spectrometer that reduces the aberration of the optical system to the utmost limit because it measures effectively using multichannel detectors such as CCD, CMOS, InGaAs etc. Since the spatial resolution is high on the whole surface of the light receiving surface of the detector, it can be used for the following applications.
-
12-550 Mark III - Infrared Systems Development Corp.
The Spectral Master 12-550 Mark III Radiometer system provides versatility for almost any IR measurement task. The system allows simple field installation of various types of detectors, filters and optics, including Spectral CVF Filters for spectral measurements.