Filter Results By:

Products

Applications

Manufacturers

Control

Known value


Showing results: 5686 - 5700 of 6931 items found.

  • PCI High Density Resistor Card 10-Channel, 16-Bit, 0 To 65k Ohm

    50-295A-121-10/16 - Pickering Interfaces Ltd.

    The 50-295A is a Programmable Resistor card with up to 18-channels of 8-bit resolution resistor chains in a single PCI slot. The flexible architecture allows the card to also be supplied as 12-bit, 16-bit or 24-bit resolution versions for applications requiring finer resolution, greater resistance range or higher channel count. The card is ideal for simulating the sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.

  • PCI High Density Resistor Card 10-Channel, 12-Bit, 0 To 4k Ohm

    50-295A-121-10/12 - Pickering Interfaces Ltd.

    The 50-295A is a Programmable Resistor card with up to 18-channels of 8-bit resolution resistor chains in a single PCI slot. The flexible architecture allows the card to also be supplied as 12-bit, 16-bit or 24-bit resolution versions for applications requiring finer resolution, greater resistance range or higher channel count. The card is ideal for simulating the sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.

  • Digital Stimulus Response PXI Card

    GX5152 - Terotest Systems Ltd.

    The GX5152 Series are high speed, 6U PXI, digital I/O instruments. The GX5152 master controller has 32 I/O channels that supports test rates up to 50 MHz and vector depths up to 128 Mb per pin. The GX5153 slave offers the same timing characteristics and multiple I/O level configurations when used in conjunction with the GX5152. The GX5152 can control up to 15 GX5153 boards using the same timing and sequencer.

  • Sealed Beam Bulb Testing System

    H710019SSL - 6TL Engineering

    EOL test for manufacturing of bulbs with LED for applications requiring to ensure watertightness: vehicles, marine, swimming pools, operating rooms, classified areas (Ex Zone), etc. The test system checks in a short time all the light and electrical characteristics of the bulb. A high precision Micro Leakage Meter also checks that there are no leaks between the environment and the inside of the bulb. The test results are recorded on the PC and can be printed on a quality control label attached to each unit.

  • Air Data Calibrator

    ADC-2555 - TestVonics, Inc.

    TestVonics ADC-2555 Air Data Calibrator is a high accuracy pitot static calibrator. The ADC-2555 is capable of controlling and measuring Altitude and Airspeed pressures with the highest degree of accuracy. The control and measurement range of the test system can meets or exceed requirements for both commercial and military applications. The ADC-2555 is a derivative of the ADC-2500 Series. It features a touchscreen interface, a mid range 23PSIA sensor and features TestVonics automated calibration software for the TTu-205J Pressure-Temperature Test Set.

  • Digital Panel Meter

    DPM - Bee Instruments

    Digital panel meters are digital displays intended to be mounted in a panel, such as a control panel. They typically read some type of input, be it a voltage, current, or resistance, and display its value digitally. Often this input is a measurement from a sensor which is converted and displayed as a temperature, pressure, or other system variable. These meters may also act as simple controllers which trip a switch or perform a simple function when the reading reaches a preset measurement.

  • Robotic Intelligent Laboratory System

    CHANGSHA KAIYUAN INSTRUMENTS CO., LTD.

    Is able to determine calorific value, total sulfur, internal moisture, ash, volatile matter, CHN content and other indicators by robot technology. The main components include intelligent robot, automatic analytical instruments (calorimeter, sulfur analyzer, proximate analyzer, and elemental analyzer), automatic bottle opener and sampling device, automatic weighing device, oxygen vessel loading and cleaning device, electrical control system, and laboratory analysis and data management software.

  • Tone Generator

    ComTekk Engineering, LLC.

    Control and test 2-way radio systems, repeaters, ANI, Paging and more. Activate 2-tone or 5/6-tone pagers. Operate or test EIA tone-remote systems. Record generated signals to a WAV file Accomplish MORE, by carrying LESS hardware in the field. Monitor inputs and outputs with our FREE built-in audio scope and spectrum analyzer. No external hardware required. Output may be fed directly into radio, twisted pair, or service monitor.*

  • Multimedia Test Systems

    Alfamation S.p.A

    Consumers demand innovative electronic devices with advanced features, and manufacturers need to deliver products that stand out from a growing field of competitors. At the same time, they are challenged to get their products to market quickly, at a lower cost, while operating in a complex global environment. Alfamation's turnkey solution can automatically run a wide range of tests, including power up, video (RF, CVBS, S-Video, HDMI), audio (analog, digital, HDMI), remote controls.

  • Modular Video and RF Switches and Matrix Switching Systems

    VDM Series - Cytec Corp.

    Cytec's VDM Series of video and RF switching systems are based on a solid state switch fabric and are available in non-blocking, full fan-out configurations of 8x8 to 32x32, with a small signal bandpass of 400MHz. Input and output buffers can be modified for different impedance or signal levels. Both the switch modules and control modules are modular for ease of expansion and low MTTR. Start with an 8x8 matrix and expand to a 32x32 simply by adding additional input and output modules.

  • Modular Spectrometers

    B&W Tek, Inc.

    B&W Tek boasts one of the most comprehensive lines of UV, Vis and NIR spectrometer modules on the market. Combined with our wide selection of spectroscopy accessories, we offer you nearly limitless utility. Due to their small form factor and customizable software control systems, fiber optic spectrometers are the ideal choice for both integration into your OEM system and for the laboratory, where you can combine modular products to form a complete solution.

  • Switcher

    1154B - Audio Authority Corp.

    The 1154B is a completely redesigned 4-input, 1-output AutoSelecting switcher with infrared remote control. It switches high definition component video up to 1080p, and audio signals including stereo (analog), digital coaxial, and digital optical audio. The 1154B is a useful companion to any component video-based entertainment system, enabling higher performance video switching than most A/V receivers, and a step up in quality over passive switchers with limited bandwidth.

  • Total Flux Measurement Systems

    Gamma Scientific Inc.

    LED’s and Luminaires must be characterized and tested for brightness and color, for production quality control and also for R&D. The Gamma Scientific Total Flux Measurement System combines our accurate Radoma Spectrometer and an integrating sphere for total flux (total power) and color measurements of LED, micro LED and Luminaires. Measurement parameters include spectrum, lumens, total power, peak and dominant wavelength, CRI, CCT, FWHM and other optical properties.

  • 2-CH MIL-STD-1553A/B Bus Simulator Module

    1553 WA73A-455 - Western Avionics Ltd.

    The WA73A-455 MIL-STD-1553A/B Bus Simulator Module allows a system controller in an ATE system to communicate with and test devices that conform to the MIL-STD1553A/B data bus used in military aircraft and communications systems. Each of the WA73A-455's two channels operate as two separate and independent channels with their own VXIbus logical address, interrupts, and complete set of controls and indicators. As a result, each channel of the WA73A-455 is truly an independent instrument, and, therefore, individually programmable.

  • Automated Distortion Characterization and Information System

    ADCS - Matrix Test Equipment Incorporated

    The Automated Distortion Characterization and Information System (ADCS) is an extension of the Matrix equipment control software that automatically makes RF measurements selected from the following: Cross Modulation (XMOD), Composite Triple Beat (CTB), Composite Second Order (CSO), Carrier to Noise (C/N), Discrete Second Order, Discrete Third Order Distortion. Measurements are made, and the test results and a profile describing the test conditions are saved in a database for later retrieval or reporting.

Get Help