-
product
Image Sensor Test System
IP750
Teradyne's IP750 series dominates the image sensor tester market with its superior performance and low cost of test. The IP750 delivers high throughput and high parallel test efficiency, broad device test coverage from CCD and CIS, analog and digital capture, and concurrent image sensor and logic testing. In addition, Teradyne's IG-XL software environment provides easy, shorter test program development and easy maintenance.
-
-
-
product
FTL Test Block
FTL testblock with dust cover and current disconnect pinThe FTL is a test block for interfacing substation devices (protection relays, fault recorders, revenue meters, ... ) to the voltage and current transformers and to other equipment on the system side of a power grid. The FTL test block uses disconnect pins to isolate the substation devices from the system side equipment. Once isolated, secondary injection can be performed using banana jacks on the front side of the test block.
-
product
Oil Test Equipment
KV Hipot Power Test Equipment Co.,Ltd
oil analysis program is to verify that a lubricated machine is operating according to expectations. When an abnormal condition or parameter is identified through oil analysis, immediate actions can be taken to correct the root cause or to mitigate a developing failure.
-
product
Walk-In Test Chamber
Sanwood Environmental Chambers Co ., Ltd.
Energy-saving design: Adopting PID + PWM principle of VRF (refrigerant flow control) technology to achieve low-temperature energy-saving operation (electronic expansion valve according to thermal energy conditions refrigerant flow servo control technology) low temperature working state, the heater does not participate in the work, through PID + The PWM regulates the flow rate and flow direction of the refrigerant, and regulates the three-way flow of the refrigerant pipe, the cold bypass pipe, an...show more -
product
IP Code Test Equipment
Weice Testing Instrument Co.,Ltd.
IP Code, International Protection Marking, sometimes interpreted as Ingress Protection Marking, classifies and rates the degree of protection provided against intrusion (body parts such as hands and fingers), dust, accidental contact, and water by mechanical casings and electrical enclosures.
-
product
EFI Test Light-GEO TBI
3413
Peaceful Thriving Enterprise Co Ltd
*Simply for testing: Disconnect the fuel injectors, plug in a Noid.*Quickly determines if the electrical signal present at the fuel injectors.*Light and crank the engine, a flashing Noid light indicates normal pulsing voltage.
-
-
product
Nanomechanical Test Systems
Bruker’s nanomechanical test systems deliver the highest degree of performance, accuracy, reliability, and versatility for quantitative mechanical and tribological characterization at the nanoscale and microscale. Utilizing multiple patented and proprietary technologies, the Hysitron product line of standalone nanomechanical test systems enable quantitative characterization at length scales unreachable by others.
-
product
Telcom Test Sets
T62 Recon
The RECON is the first true 21st century telecommunication line analyzer setting a new standard for POTS butt sets. It is a field instrument that delivers more information of online conditions & status than any other test set on the market, anywhere in the world!!
-
product
Ionic Contamination Test Equipment
For manufacturers driven to deliver quality products, SCS Ionic Contamination Test Systems are the industry standard, delivering accuracy and performance in a range of configurations.
-
-
product
Protocol Test Family
The VIAVI Protocol Test product family provides scalable end to end protocol analysis of multiple mobile technologies for issues that occur at any time (including in the past) for multiple users in a fraction of the time. The product family also supports Virtual Ethernet lifecycle management solution for test, service activation, performance monitoring and troubleshooting on all network layers.
-
product
Test adapter MR-LR
MA-ML01
Hachmann Innovative Elektronik
Our Test adapter MA-ML01 connects LR measuring devices to standardized MR string parts. Due to small dimensions and skid-proof design it's easy for him to catch up with everything.
-
product
Test Fixture
OCP NIC 3.0
These test fixtures are necessary for testing within the OCP NIC subgroup (found under the OCP Server Work Group). These fixtures will arrive meeting the OCP NIC 3.0 Specification with a characterization of the boards. These fixtures mate with the OCP form factor connector, and will allow an electrical break out of each signaling lane.
-
product
160MHz Test System
IQxel-MW 7G
Platform solution for 802.11 a/b/g/n/ 802.11ac, 802.11ax, and 802.11be testing in the 2.4 and 5 GHz and 6 GHz bands and the most popular wireless connectivity standards (Bluetooth®, Bluetooth® 5, Bluetooth® 5.1, Bluetooth® 5.2, Zigbee, Z-Wave) as well as LPWAN technologies (Sigfox, LoRa).
-
product
Analog Test Solutions
ATX series
The ATX series of instruments are designed for applications that require an analog performance that is not achievable with industry standard platforms like PXI(e).
-
product
MIPI Receiver Test Solution
M8085A
The M8085A is a software plug-in for M8070A Bit Error Ratio Test system software within the M8000 series of BER test solutions. The M8085A software plug-in controls either the M8190A or the M8195A Arbitrary Waveform Generators to create C-PHY or D-PHY standard compliant test signals. In addition it provides routines for calibration of all signal parameters and for all tests specified in the applicable Conformance Test Suite. Together with the additional available DUT control interface it is possible to read the BER of the receiver under test from the M8070A software and display the BER dependency from test parameters within the M8070A user interface.
-
product
Standard Test Systems
WaveCore™ Products
Textron Systems’ WaveCore family offers a variety of standard test systems with a primary application of satellite payload lab testing. Our systems can be deployed affordably for both production and engineering applications, providing industry-leading levels of data correlation with high system mean time between failures and low mean time to repair.
-
product
USB Type A Test Connector
Test connector for USB 2.0 Type A (4 pole) for contacting USB interfaces. Application in USB devices like hard disks, data carriers, power supplies, etc.
-
product
Wafer-Level Parametric Test
Wafer-level reliability engineers need to reduce test time without sacrificing measurement quality and accuracy.
-
product
Manual Test Stands
AMETEK Sensors, Test & Calibration
This manual test stand is ideal for tensile testing, compression testing, peel, and flexural testing. It may be equipped with a quick-action lever or precision hand wheel for controlling crosshead speed and travel.
-
product
Parrot Test Leads
2x Test Leads ( 600V Cat II, 10 A ) with 1m Silicone Cable with Banana plug.
-
product
Photoelectrochemical Test System
SolarLab XM
SolarLab XM is an application specific XM (Xtreme Measurement) product that is primarily focused on solar cell / photovoltaic research, developed in conjunction with Professor Laurie Peter of the University of Bath, UK.
-
product
Vacuum Interrupter Test Set
HTZK-IV / 385
Wuhan Huatian Electric Power Automation Co., Ltd.
Quantitative measurement, suitable for vacuum switch vacuum measurement, vacuum switch preventive detection special instrument.
-
product
Universal Test Machine Stands
FTUS
Portable, adjustable height, stands are available for all FTU chamber models. They support the chamber without transferring weight to your testing machine. Standard Universal Test Machine stands are furnished with an 18 inch, electrically actuated, lift system, four swivel casters with locks, and an all welded frame. Four types of stands are available
-
product
Test System
UltraFLEX
The UltraFLEX test system delivers the power and precision you need for complex SoC devices built for mobile applications, networking, storage or high-end processing. Choose UltraFLEX when your device mix and throughput goals demand the highest speed, precision, coverage and site count.
-
product
Automotive Ethernet Test Fixture
AE6941A
The AE6941A automotive Ethernet electrical test fixture provides easy access to automotive Ethernet electrical signals so you can perform conformance testing and device characterization quickly and easily.
-
product
Inclination (Cyclic Motion) Test
This test simulates cyclic motions such as encountered by equipment on marine applications, e.g, pitch, yaw, and roll.
