Showing product results. 3196 - 3210 of 3915 products found.
-
Rosenberger Hochfrequenztechnik GmbH & Co. KG
Rosenberger has expanded its wide range of compact calibration kits and provides a series of kits in common coaxial connector interfaces: RPC-2.92, RPC-3.50, RPC-N (50 O), RPC-N (75 O), 7-16, N, 4.3-10, and 4.1-9.5, each male and female. Compact calibration kits of Rosenberger combine all necessary calibration standards in one compact unit – small, easy to handle and light weight. The 3-in-1 calibration kits can be applied for complete MSO calibrations (open – short – load) of single port vector network analyzers, the 4-in-1 calibration kits can be used for complete MSOT calibrations (open – short – load - thru) of two or more port vector network analyzers. Rosenberger runs its own calibration laboratory accredited and controlled by the German accreditation body DAkkS (Deutsche Akkreditierungsstelle) – according to DIN EN 17025.
-
LNA Series - Teseq AG
Low noise amplifier with 12.5 dB of gain covering the nominal frequency range 1 MHz to 3 GHz and can be used in the range from 200 kHz to 4 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments. All measuring instruments have a 'noise figure', which is a measure of how good the instrument is at measuring low level signals, the lower this figure, the better, although the lowest signal level will still be governed by the measurement bandwidth. A typical spectrum analyzer may have a noise figure of 20 dB or more, whereas a typical receiver may have a noise figure of 10 dB. The preamplifier has a noise figure of typically 4 dB, significantly enhancing the low level performance of such instruments, enabling signals that were previously masked by noise to be seen.
-
Model T703U - Teledyne Advanced Pollution Instrumentation
The Model T703U is a microprocessor controlled ozone calibrator for precision gas analyzers. Expanded ozone audit levels have created a need for precise ozone calibration well below the capabilities of standard calibrators. The Model T703U is designed to meet the requirements of ultra-low ozone production.In addition to a high range with similar performance to the Model T703, the Model T703U has the capability to generate ozone in a low range, or "fractional" mode, for producing ozone levels down to 3 ppb, with exceptional accuracy. Flow rate and lamp intensity are adjusted to deliver a specified ozone concentration by volume. The temperature and pressure compensated photometer, identical to that of the Model T400 ozone analyzer, provides feedback control of the UV lamp intensity, assuring stable ozone output. A nearly unlimited number of calibration sequences may be programmed into the non-volatile memory of the T703U, covering time periods up to a year.
-
AOIP
AOIP has two combustion analyzer ranges from 2 to 9 gas sensors according to the models (oxygen O2, carbon monoxide CO, hydrocarbons CxHy, Sulfur Oxides SOx or NOx Nitrogen ...). The instruments meet the requirements of applications in domestic boilers (HVAC market) and industrial facilities (process furnaces, incinerators, power plants, gas turbines ...).
-
PK3564-PRO - Summit Technology, Inc.
PK3564-PRO complete Power Analysis System includes PS3550 Power Analyzer, AC charger, Quick-Start manual, deluxe voltage leads, four eFX6000 flexible current probes, SD memory card, CAS3 hard-shell carrying case, PSM-A Software, Mini Line-to-DC Converter, Bluetooth Adapter, USB Communications Cable, and 1-year deluxe warranty.
-
PK3564-PRO+ - Summit Technology, Inc.
PK3564-PRO+ complete Power Analysis System includes PS3550 Power Analyzer, AC charger, Quick-Start manual, deluxe voltage leads, four eFX6000 flexible current probes, SD memory card, PSM-A Software, Mini Line-to-DC Converter, Bluetooth Adapter, USB Communications Cable, CASW Weather-Resistant Carrying/Operating Case, and 2-year deluxe warranty.
-
OP-FW10G - LINEEYE Co., Ltd.
OP-FW10G is an expansion firmware to upgrade LE-3500 measuring Bit-Synch (HDLC/SDLC/X.25/CC-Link) and SPI communications up to 10Mbps. Hardware processing by FPGA built in the analyzer makes it possible to capture data with time stamp at micro second. It is useful to analyze SPI communications and High-speed HDLC communications such as RS-485 multi-drop CC-LINK and TTL signal level on the printed-circuit board.
-
Fiberinthebox
Fluke Test Equipment includes electrical test equipment, environmental test equipment, mechanical test equipment and more. Fiberinthebox supply a large range of Fluke Test Equipment, such as Fluke Fluke NetTool Inline Network Service Kit, Fluke Networks AirCheck Wi-Fi Tester, Fluke Networks Cable Strippers, Fluke Power Meter, Fluke Power Analyzers.
-
Ametek Land
Insight is a Windows based data acquisition software program, used for logging stack emissions measurement data directly from a LANCOM portable gas analyzer. Emissions data can be analyzed either as it is collected in real time, or during review of logged data. A range of statistical and graphical tools allow the user to perform measurements, manipulate, report, present and print data.
-
LiFli - Fauser Elektrotechnik
The LiFli light flicker meter enables fast evaluation of light sources on the flickering part (flicker / flicker). Especially in the case of LED lamps, the flicker portion can be determined only by one measurement, since it is in the range of 0% to 100% for these luminous means.Audio features enable the flicker to be reproduced acoustically. A voltage output for further analysis by means of oscilloscope or voltage analyzer is available.
-
IMV Corporation
A compact Signal Amplifier to make optimal signal processing being connected with the Servo type Accelerometers. It is used for Vibration Acceleration Measurement, Waveform Observation, for various Analysis in combination with the AC Voltage Meter, Oscilloscope, FFT Analyzer respectively. Furthermore, Voltage signals from the Microphones or Sound Level Meters can be output to the instruments like Recorders along with the Vibration Signals.
-
dS-LPF - Prism Sound Ltd.
The dS-LPF is a passive 20kHz low-pass filter in 2 or 4-channel configurations designed primarily for measuring digital power amplifiers. The Passive Low-pass Filter is intended to aid measurement of switching ('Class D', or 'PWM') power amplifiers where the presence of shaped and switching noise outside the audio band can adversely affect the Analogue Inputs of the dScope or other audio analyzer.
-
Toray Engineering Co., Ltd.
Quality management for semiconductor manufacturing processes and liquid crystal panel manufacturing processes, which require nano-order precision. Oxygen analyzers used in firing furnaces and N2 reflow ovens.Water quality meters used to monitor the water quality of plant discharge and the pure water used in semiconductor manufacturing processes.Our measuring and analysis equipment is used in a wide range of fields.
-
DS-85 - Ceibo Inc.
* Real-Time and Transparent In-Circuit Emulator * Windows Debugger - Update 2009 * Symbolic Debugger compatible with Intel Object Files * 64K Hardware Breakpoints * 64K of Internal Memory * 32K x 32 Bit Trace Memory and Logic Analyzer with External Probes * Serially linked to IBM PC or Compatible Hosts * On-line Assembler and Disassembler * Source and Listing Windows
-
FreqAnalyst Multi - Blue Cat Audio
FreqAnalyst Multi is a unique multiple tracks real time spectrum analyzer: it lets you visualize the spectral content of several audio tracks on the same screen with extreme smoothness and high resolution for both time and frequency. It is the ideal solution for mixing: you can use it as a frequency overlap detector and actually see which part of the spectrum every single instrument uses.