Showing recent results 2776 - 2790 of 3705 products found.
-
Noisecom
The Noisecom 60 GHz Noise Figure test set has 4 separate systems designed to perform Y-factor noise figure measurements using a high performance Spectrum Analyzer or a dedicated receiver. Each system contains a highly stable V-band noise source, isolator(s), optional waveguide to coaxial transitions and an optional pre-amplifier for use with a spectrum analyzer. The two standard calibration tables have ENR data points at 1 GHz intervals.* System ENR is measured before the DUT connector and at the final output stage allowing for pre-test calibration of the system.
-
CSW Series - AMETEK VTI
The CSW Series represents a new generation of AC/DC power sources that address the increasing demands on test equipment to perform additional functions at a lower cost. By combining a flexible AC/DC power source with a high performance power analyzer, the Compact CSW Series is capable of handling complex applications that have traditionally required multiple systems. The sleek integrated approach of the CSW avoids cable clutter that is commonly found in test systems. All connections are made internally and the need for digital multimeters, power harmonics analyzers, and current shunts or clamps is eliminated.
-
CSW Series - AMETEK Programmable Power, Inc.
The CSW Series represents a new generation of AC/DC power sources that address the increasing demands on test equipment to perform additional functions at a lower cost. By combining a flexible AC/DC power source with a high performance power analyzer, the Compact CSW Series is capable of handling complex applications that have traditionally required multiple systems. The sleek integrated approach of the CSW avoids cable clutter that is commonly found in test systems. All connections are made internally and the need for digital multimeters, power harmonics analyzers, and current shunts or clamps is eliminated.
-
Cpci301 MIL-STD-1553 - Andor Design Corp.
MIL-STD-1553 A, B & McAir MULTI PROTOCOLS Simulator / Analyzer / Tester CPCI BUS Interface Card - The CPCI301 can be used for Validation Testing, Production Testing, full bus simulation and monitoring, as a general purpose 1553 interface or a stand alone bus Analyzer. For precise message scheduling and measurements, the Major and minor frame times are independent of message sequences or retransmissions on errors and the start of all command messages are independent of message length, response time or length of response. Message timing is calibrated and RT responses have low jitter.
-
Keysight Technologies
Accurate DC/CV (and RF) statistical modeling of semiconductor devices requires collecting a significant amount of measured data from different wafers across several temperatures. Keysight Technologies recommends IC-CAP WaferPro as a turn-key DC/CV and RF automated characterization solution to help modeling and device engineers achieve more efficient on-wafer measurements across temperature. This new breakthrough solution is based on IC-CAP modeling software and efficiently controls DC/CV analyzers, network analyzers, probers, switching matrixes, and temperature chucks, as well as the powerful 407x and 408x Series of Keysight parametric testers.
-
Chongqing Dodem Communication Technology Co., Ltd
DP-500 2M data transmission quality analyzer is our Dodem self-developed handheld tester. It is widely used in BER test and line fault analysis, suit for the maintenance and measurement of 2M system and Nx64k signal channel.
-
AMX 270 - Guide Technology, Inc.
The AMX 270 "CTIA" architecture improves accuracy by bringing 32 channels of critical front-end input circuitry of GuideTech's Femto Continuous Time Interval Analyzer (CTIA) systems up close to the device under test.
-
CGM-101 - Syscomp Electronic Design Ltd.
A 2Ms/s 11-bit digital storage oscilloscope, arbitrary waveform generator, digital I/O and more! Sotware features include vector network analyzer, spectrum analysis, strip chart recording, and more! USB cable included.
-
MVX & MV-120 - ACOEM
The MVX and MV-120 are powerful and intelligent, real-time, multi-channel data analyzers. The MVX and MV-120 gather multiple data-types, including vibration, IEPE, and voltage, in real-time, giving you the power to stop machine failures before they happen.
-
1500series - Telemann Corp.
The optimal signal analyzers to test and measure both analog/digital signals. Especially, these models give users the capacity to measure 'C/N' very easily and correctly, which are very important measurement factors for the TV broadcasting signal.
-
Intellitech Corp.
The Eclipse Test Development Environment automatically creates tests that are used to bring up new products in the lab. Failures can be quickly debugged using software tools such as the Eclipse Timing Diagram Analyzer and the Schematic Logic Probe.
-
Signal Generator - ZETLAB Company
Signal Generator is used for forming signals of various shapes, amplitude, and frequency at the output channels of ADC and DAC modules and FFT spectrum analyzers. Functionally, the Signal Generator software replaces stationary generators used in laboratories.
-
EM720 eXpertmeter - SATEC Ltd.
The eXpertmeter™ is a unique and cost-effective combination of several Intelligent Electronic Devices (IED) in one. It incorporates a multifunctional power meter, high performance revenue meter, cutting-edge power quality analyzer and a unique transient recorder.
-
MLED4 - ZOLIX
Photocatalysis, ultraviolet analyzer biological genetic engineering, molecular genetics, medical and health, biological products, pharmaceutical research, health and epidemic prevention, dye chemical industry, petroleum chemical industry, textile industry, etc.
-
PPM100 - Stanford Research Systems, Inc.
The PPM100 is a stand-alone controller/monitor for SRS residual gas analyzers. It measures partial pressures from SRS RGAs and total pressure from up to four capacitance manometers. Graphical output is available on a touchscreen LCD display.