Showing recent results 2026 - 2040 of 3287 products found.
-
KHA3000 - Kikusui Electronics Corp.
KHA3000, in addition to the complied standards and features of the KHA1000 (dedicated for single phase), is equipped for the harmonic and flicker compliance test exceeding 16A of the single-phase and three-phase equipment. With this unit alone, you can take highly accurate simultaneous three-phase measurements up to 40A/phase*. Furthermore, the KHA series is compliant with two measurement technique standards, the existing and the latest versions, so you can simply select to take measurements for the latest standard including interharmonics and for the conventional integral multiple harmonics without using any other device. In addition to the real-time display that can be used like an oscilloscope and FFT analyzer, the unit offers the real-time judgment of compliance with standards. Using this unit alone, you can judge test results and prepare result reports without the use of a PC. On top of that, you can easily set up a test system by combining KHA3000 with an AC power supply (PCR-LA Series) and a line impedance network (LIN40MA-PCR-L).
-
GRL-USB-PD-C2 (GRL-C2) - Granite River Labs Inc.
GRL-USB-PD-C2 (GRL-C2) is the only solution available that supports all compliance test specifications for USB Power Delivery 3.0 and USB Type-C Alternate Mode designs, and enables product developers to quickly run full compliance and validation test suites at the push of a button. GRL-C2 provides an automated, efficient, and fully-integrated way perform all required USB Power Delivery version 3.0 and 2.0 and related tests over the USB Type-C connector, as well as PHY test automation for USB Type-C Alternate Modes. GRL-C2 automates all required USB PD compliance tests for power providers (chargers), consumers, dual-role ports, and cable and adapter E-Markers; and is the only solution available that integrates Qualcomm Quick Charge 4+ and Intel Thunderbolt-specific test items. GRL-C2 also incorporates analyzer capability to sniff PD traffic. GRL-C2 integrates all required USB PD tests into a single 2-port tester, including all tests supported on GRL’s USB-IF approved first generation solution introduced in 2015. Each port can be configured independently as a PD Provider or Consumer. All other PD Protocol and Power tests are fully integrated, removing the need for external electronic loads.
-
GT667 - Guide Technology, Inc.
GT667 PXI & PXIe cards can be expanded up to 34 Channels Single EndedInput in a single 3U GT8000 PXI and/or PXIe chassis.
-
M9393A - Keysight Technologies
9 kHz to 8.4 GHz, 14 GHz, 18 GHz, or 27 GHzFrequency extension to 50 GHz (minimum frequency of 3.6 GHz) with Option FRX40 MHz (standard), 100 MHz, or 160 MHz analysis bandwidth, and optional wideband IF output with Option WB1Up to 4 time-synchronous channels
-
390PT - PulseTech Products Corp.
The 390PT Battery and System Tester lets you quickly, safely and accurately test both 6-Volt and 12-Volt lead-acid flooded, AGM (flat and spiral plate) and gel cell batteries in or out of the vehicle and test 12-Volt and 24-Volt charging systems for proper operation. Combined singe load, dynamic resistance technology and algorithms display battery voltage and capacity in easy to understand results in seconds. The handy "QUICK START" instruction guide is printed on the back of the tester.
-
8100 C - KUSAM-MECO
INPUT :• Input Voltage Range :Voltage: 55 ~ 300V AC, or 300 ~ 600V AC, 45 ~ 65Hz.P.T. Ratio Programmable upto 9999 / KV.• Input Voltage Over Range :Voltage : 200 % Continuous, 300 % of rating for 10 sec.• Input Current Range :Current : 110 % of rating. 0-1A or 0 - 5AC.T. Ratio programmable upto 9999 / 5A.Input Current Over Range:Current : 400 % Continuous, 2000 % of rating for 10 Sec.• Input Frequency : 45 Hz ~ 70 Hz.• Input Burden :Voltage 0.25 VA / Unit, Current 0.25VA / Unit, at 50 / 60HzOUTPUTDC Current: 0 20 m A DCLoad resistance drive: output drive 10 V DC maximum.DC Voltage: 0 -10 V DCLoad resistance drive: output drive 5mA maximumOutput Protection: No damage even if output is Open or Short Circuit.Output Response Time : £ 1 Sec.Digital Output : RS485 Output, Isolate Type with MODBUS RTU mode., 4800, 9600,19200Baud Rate, User Selectable.
-
Chroma ATE Inc.
The 3250/3252 provide 20Hz-200kHz tes t frequencies, and 3302 provides 20Hz-1MHz test frequencies. In addition to transformer scanning test function, the 3252/3302 have LCR Meter function. In test items, The 3250/3252/3302 cover most of transformer's low-voltage test parameters which include primar y test parameters as Inductance, Leakage Inductance, Turns-Ratio, DC resistance, Impedance, and Capacitance (between windings) etc.; secondary test parameters as Quality Factor and ESR etc.; and pin-short test function. High-speed digital sampling measurement technology combined wi th scanning test fixture (A132501) design, improve low-efficiency transformer inspection to be more accurate and faster.
-
DV3100 - TechTools
Our popular DV1-100 has been replaced with the new DV3100. If you have experienced the DV1-100 or a colleage has recommended it, then DV3100 will surprise you. DV3100 sells for the same price as the DV1-100 did, but has many new features.
-
N9340B - Keysight Technologies
Obtain field-ready performance: portable, rugged, fanless design, clear viewing both day and night, maximum 4-hour batteryGet benchtop performance with 144 dBm DANL, 1.5 dB amplitude accuracy, and < 0.1 s full span sweep timeAchieve powerful measurements: spectrogram, AM/FM/ASK/FSK modulation analysis, AM/FM IBOC measurement, xDSL measurement, and more
-
BATTSCAN - FutureTech
BATTSCAN provides a fast and thorough, yet simple analysis of a hybrid vehicle's high voltage battery pack by interfacing with the vehicle while a rechnician performs a voice guided road test. When finished, BATTSCAN will provide the technician an overview of the highvoltage battery's state-of-health (SOH) and vehicle service recommendations.
-
72-190 - Tenma
A compact and lightweight probe for the analysis and troubleshooting of logic circuits. The probe will recognise high, intermediate and low level pulses in DTL, TTL, HTL and CMOS logic circuits. Works as a pulse detector, pulse stretcher and a pulse memory.
-
72-500 - Tenma
A compact logic detector and pulser probe for the analysis and troubleshooting of logic circuits. The probe will recognise high, intermediate and low level pulses in DTL, TTL, HTL and CMOS logic circuits. In addition the probe contains a logic pulser that can directly inject a signal into a logic circuit without the need to remove components.
-
Keysight Technologies
Choose between three PNA Series to get the right mix of speed, performance and priceIn R&D, obtain a higher level of measurement integrity that helps you transform deeper understanding into better designsOn the production line, attain the throughput and repeatability you need to transform great designs into competitive productsGet the ultimate expression of Keysight expertise in linear and nonlinear device characterization
-
31900 Series - RTW GmbH & Co. KG
The revised version 4 includes a new DSP board and allows loudness measurements according to the relevant loudness standards: EBU R128, ITU-R BS.1770-2/1771, ATSC A/85 and ARIB.The new LRA instrument combines the measurement and visualization of two critical loudness parameters (program loudness, loudness variances within short time periods) in a straightforward and intuitive way.
-
31960 Series - RTW GmbH & Co. KG
SurroundControl is our flagship product line for controlling, analyzing and monitoring stereo, surround sound and multichannel programs. It combines the metering functions of the RTW surround display devices and the control functions of an eight-channel monitoring controller - a true high performance system.