Showing results: 2011 - 2025 of 3888 items found.
-
Spider-20 -
Crystal instruments
The Spider-20 series of products are compact yet powerful data acquisition and dynamic measurement systems. These units provide four 24-bit precise high-fidelity input channels, and a unique software-selectable tachometer-input/signal-source output channel. Each input is individually programmable to accept AC or DC voltage or output from an IEPE (ICP) sensor with built-in electronics. Input channels can be programmed to sample up to a rate of 256 kHz. The Spider-20E is a small scale (5 ⁵/16 x 4 ⁵/16 x 1 ⁵/16 inch) device weighing only 18 ounces. This handheld unit features three push-button controls and five LED status indicators. This little powerhouse can run over 6 hours on its internal rechargeable battery which can be replaced in the field with a backup battery.
-
ECAD System 2005 -
CM Technologies Inc.
The ECAD System 2005 is a suite of test instruments for both lumped and distributed data for analysis of electrical circuits and/or wiring harnesses. ECAD is completely self contained, and has a built-in multimeter, impedance meter, TDR, and megohmeter.
-
IQFROG -
Quantifi Photonics Inc.
The IQFROG measures pulse intensity and phase in both spectral and temporal domains, yielding a complete pulse characterization. With its long delay arm and high resolution spectrometer, it measures chirped pulses up to 50 ps wide, or up to 10 ps wide if the pulse is transform limited. The IQFROG is available in 1.0 and 1.5 micron wavelengths.
-
SpiceVision PRO -
Concept Engineering GmbH
SpiceVision PRO takes the complex SPICE descriptions produced by many EDA tools and generates clean, easy-to-read transistorlevel schematics and circuit fragments, and design documentation to speed up debugging and project development.
-
72-6706 -
Tenma
The Tenma Multi-Network and Modular Cable Tester easily reads the correct pin configuration of 10Base-T cable (Category 5, 5e and 6), 10Base-2 cable (coax), RJ-45 and RJ-11 modular cables, 356A, TIA-568A/568B and Token Ring cable by comparing transmitting end to the corresponding receiving end
-
72-6290A -
Tenma
The 72-6290A is a multi-modular Cable Tester (LAN Tester) with LED meter display. Requires 9V battery for this modular cable tester. Used with RJ-45, RJ-12, RJ-11 connectors and USOC4, USOC6, USOC8 cables.
-
Extech Instruments Corporation
Circuit and wiring issues can introduce shock hazards (from grounding issues) and can compromise performance of machinery and equipment (from poor ground impedance, lack of sufficient voltage under load and/or high ground-to-neutral voltage).
-
N1060A -
Keysight Technologies
Gain margin with high instrument performance: high BW (50 GHz or 35 GHz) receivers, ultra-low residual jitter (< 50 fs typical); adjustable clock recovery peaking & loop BW Reduce development time through instrument flexibility with integrated clock recovery (data rates 50 Mb/s to 32 Gb/s) & integrated pickoffs & phase matched cables for simple one connection "triggerless" operation Reduce validation time with analysis tools like Jitter Spectrum Analysis & SW Clock Recovery Emulation
-
GT668PXI-40 -
Guide Technology, Inc.
A true breakthrough in high-speed Time Measurement and test technology, GuideTech’s GT668PXI-40 leverages the power of its CTIA continuous time-stamping technology, eliminating the need for supplemental triggers, pattern markers or clock recovery circuits.GuideTech’s CTIAs enables serial interfaces pattern verification and full jitter analysis in milliseconds for fast, automated characterization and high-throughput production test on all ATE platforms, including low-cost and in-house testers.GT668PXI-40 cards can be expanded up to 36 Channels Single Ended Input in a single 3U PXI chassis.
-
ZNrun -
Rohde & Schwarz GmbH & Co. KG
For a facility manager the yardstick for optimization could be maximizing the daily production yield, while for a test-engineer it might mean being able to easily define a test setup and have it loaded on each device in the factory in seconds. A tester might be interested in seeing only the result of the measurements, after having started it by scanning a barcode, while quality managers might find it convenient to be able to download real-time yield statistics on their way to the factory. The R&S®ZNrun software suite was designed with optimization in mind and acknowledges these re-quirements by offering each party the possibility to expedite their workflows as much as possible.
-
BTS8-WA -
MTI Corp.
BTS8-WA is a precision eight channels battery test system for measuring battery capacity at 0.002mA - 1mA up to 5V.. This systems the best tool to study new generation energy storage materials and rechargeable battery.
-
Keysight Technologies
With the Keysight Streamline Series, you can expect a common UI, measurement capabilities, and automated code in all form factors: USB, benchtop, and modular. This allows you to move between product development phases more efficiently and effectively since you can transfer knowledge and data easily among the various platforms.
-
N9910X -
Keysight Technologies
N9910X Rugged phase-stable cable, 3.5 mm(m) to 3.5 mm(f), 26.5 GHz, 3.28 ft or 1 m
-
Satlook Color HD -
Emitor AB
Spectrum-analyzer 950-2150MHz. • DVB/S S/2 -receiver 920-2150MHz. • Super bright 5" 16:9 TFT-LCD color display. • Automatic Satellite identification. • Readout of NIT - gives SAT ID and TV/Radio-channel info. • Digital BER and S/N-ratio (DVB-S, S/2). • QPSK and 8PSK constellation diagram. • DVB-S (Free to Air) and SAT-analog TV-picture. • LNB voltage 13/18V, 22KHz tone switch. • DiSEqC according to level 1.0, 1.1 and 1.2. • SatCr-control (UniCable). • Favourite channel list (100 channels) for FTA DVB-S. • Lots of memory positions for spectrum pictures. • RS232 for PC-connection (up/download). • Rechargeable Li-Ion battery.
-
DVBAnalyzer -
DVBControl
DVBAnalyzer enables powerful analyzing of all aspects of DVB/ATSC/ISDB Transport Streams. This can be done with high level summary overviews, down to bit interpretation.