-
product
15-meter (49 feet) Sensor Cable
E1739C
The E1739C 15-meter (49 feet) Sensor Cable is used to connect the E1736A USB Sensor Hub to either the E1737A Material Temperature Sensor or the E1738A Air Sensor. The connectors at either end of a sensor cable are identical. It is part of the 5530 Laser Calibration System. Other cable lengths available: E1739A 5-meter (16 feet), E1739B 10-meter (33 feet) and E1739D 25-meter (82 feet).
-
product
OM Thermal Stress System
Conductor Analysis Technologies, Inc
The OM Thermal Stress System is a cost-effective performance based reliability test methodology which performs convection reflow assembly simulation and air-to-air thermal cycling. The methodology is utilized by both the IPC PCQR and the IPC 6012-QLM programs. OM systems are available for sale or lease, and test services are provided from both CAT and our service partners.
-
product
High Frequency Standard Capacitor
GenRad 1403 Series
The GenRad 1403 Standard Air Capacitors are stable, three-terminal standards in decimal values from 0.001 pF to 1000 pF. For measurement at 100 pF and below, a three terminal connection increases the accuracy by eliminating the uncertainty in the measurement introduced by the capacitances between the capacitor terminals and ground.
-
product
Vacuum Pressure Gauge
EEPV511
Test vacuum accessories and emission control devices such as EGR valves canister purge systems, air switching and divert valves, vacuum delay and check valves, heater and A/C controls and cruise control systemsMulticolor gauge face with scales of inch, Hg, psi, negative kPa and positive kPa
-
product
Automatic AC High Voltage Test Set
Used in testing of air conditioners, this is available to clients in different specifications.
-
product
Wireless HDMI Video Transport
1B-HDMI-W-TX/RX
QuestTel''s long range wireless HDMI Transmitter/Receiver kit fully compliant with HDCP, extends high definition audio and video to any HDTV display up to 650 feet (up to 200 meters). It supports HD resolutions up to 1080p. Wirelessly transmit the HDMI signal to any HDTV over the AIR, it also supports IR remote control function to control source device content from long distance.
-
product
Standard VXI Module Shield Kits With Address Switch Opening
* Single-slot kit fits all VXI-1 Revision 1.0 to Revision 3.0 chassis.* Clamshell design fits C-size modules with 96-pin connectors.* Side shields include connector shrouds for maximum shielding.* RFI limiting, air vent slots along top and bottom edges for good air circulation thru the module.* Extruded front panel is bend resistant.* Address switch opening on component side shield.* Complimentary layout support includes PCB design template and CAD layout files.
-
product
Wireless Air Quality Sensors
AQW Series
AQW series was designed for air quality measure, such as PM2.5, Ch20, CO2, temperature and humidity. Use high-precision sensor to ensure long-term stability and reliability of the instrument.Panel with large LCD display, easy to read the measuring value.And also have 4 LED indicator to indicate air quality status and device running.AQW series communication port is WiFi, it’s convenient for data collect, support Modbus TCP protocol, and others cloud protocol.
-
product
Self-contained Pressure Sensor
AP-30 Series
AP-30 series digital air pressure sensor with unique 2-color digital display replaces conventional mechanical gauges. Choose from four different pressure units. Self-contained Pressure Sensor
-
product
SparkFun Environmental Sensor Breakout
BME680 (Qwiic)
The SparkFun BME680 Environmental Sensor is a breakout that combines a gas sensor with temperature, humidity and barometric pressure sensing for a complete environmental sensor in a single package. The gas sensor on the BME680 can detect a wide variety of volatile organic compounds (or VOC for short) to monitor indoor air quality. Combine that with precise temperature, humidity, and barometric pressure and the BME680 can work as a completely standalone environmental sensor all in a 1in. x 1in. breakout!
-
product
Towing Dynamometer
RS-110K
RS-110K towing dynamometer is designed for testing Class A trucks and is the most full-featured, reliable and accurate towing dynamometer in the industry. The RS-110K is built with a heavy-duty steel frame, heavy-duty industrial axles and rides on an air ride suspension. The RS-110K is designed to maintain 110,000 Newtons of constant drawbar pull and the ability to simulate an uphill slope of 25%. The towing dyno uses absorbers with special high temperature coils powered by an industrial generator so there are no lead-acid batteries to charge and testing is unlimited at low speeds.
-
product
RF POWER AMPLIFIERS
BSA Series
RF Input: N-f, standard on rear panelRF Output: standard on rear panel<1 kW N-f<3 kW 7-16-f<5 kW EIA 1 5/8Mains Supply: Line Power:<1000 VA 100 ... 240 V AC ±10% / 47 ... 63 Hz1000 ... 3000 VA 200 ... 240 V AC ±10% / 47 ... 63 Hz>3000 VA 3x 400 V AC ±10% / 47 ... 63 HzElapsed Time Meter: via status displayAmbient Temperature: 0 ... +45 °CStorage Temperature: -20 ... +85 °CRelative Humidity: up to 95% (non-condensing)Operating Altitude: up to 2000 m above sea levelVibration and Shock: MIL-STD-810 GCooling: forced air with integral blowerair intake from front, air exhaust at rear
-
product
Power Supplies
CP-500T
Delivering essential power at highest efficiency for its users, with a single 120mm fan, this power supply remains extremely cool. The honeycomb structure offers great air ventilation and air flow that increases the efficiency of the 120mm fan and dramatically lowers the noise level. Cost effective without losing power efficiency.
-
product
CX4015
Gasmet CX4015 is designed for continuous monitoring applications in ambient conditions, such as workplace air monitoring and quality control applications. It can be used to measure up to 50 components simultaneously, and additional gases can be easily added without any hardware changes. The sample cell can be heated up to 50 °C, which allows measurements to be done in conditions where high humidity is expected and provides temperature stability in changing conditions.
-
product
Temperature & Humidity Monitor
A humidity sensor (or hygrometer) senses, measures and reports the relative humidity in the air. It therefore measures both moisture and air temperature. The warmer the air temperature is, the more moisture it can hold.
-
product
Power Detector Laser Power Meters
11PMK-H5
Fast, Small Size, Flat Spectral Response, Full NIST-Traceability, High Damage Threshold: 36 kW/cm² to 45 kW/cm², Personal Wavelength Correction™, Low profile, Air and Water cooled, Energy mode, Effective aperture diameter 19 mm (area 2.84 cm²)
-
-
product
1100 HP Water Brake Chassis Dynamometer
TD-24
AC power, air and water required at one side wallas applicable.• Room length, and pit location within length,must be determined by user to fit maximumtruck length and rear overhang.• Provide at least one man door for fire escapenear rear of room, but not in rear wall becausesomeone entering during a test could be struckby a stone flung from a tire. Provide ample fireextinguishers at each door and near driver.• “Back-on, Drive-off” installation configurationpreferred
-
product
Spectrum Analyzer & Sat TV Instrument
Satlook Color HD
Spectrum-analyzer 950-2150MHz. DVB/S S/2 -receiver 920-2150MHz. Super bright 5" 16:9 TFT-LCD color display. Automatic Satellite identification. Readout of NIT - gives SAT ID and TV/Radio-channel info. Digital BER and S/N-ratio (DVB-S, S/2). QPSK and 8PSK constellation diagram. DVB-S (Free to Air) and SAT-analog TV-picture. LNB voltage 13/18V, 22KHz tone switch. DiSEqC according to level 1.0, 1.1 and 1.2. SatCr-control (UniCable). Favourite channel list (100 channels) for FTA DVB-S. Lots of memory positions for spectrum pictures. RS232 for PC-connection (up/download). Rechargeable Li-Ion battery.
-
product
Bluetooth® Enabled Dissolved Oxygen (DO) & Temperature Pen
UltrapenX2™ PTBT5
*Industry Leading Accuracy*Display DO in Concentration, % Saturation, or Both*Adjustable for Altitude and Salinity*3 Calibration Methods: Air, Water and 0 ppm DO*Dynamic Membrane Temperature Correction*Measurement Storage with Time, Date and Location*Export Stored Measurement Data Via Email*Live or Hold Mode – User Selectable*Proprietary Sensor Design*Rugged Design with Aircraft Aluminum Body*Durable, Epoxy Encapsulated ElectronicsWaterproofPowered by One N Type Battery (Included)
-
product
Tabletop Ionizing Transport System
90610-03610
The Model IT-7000 Ion Transport System is a self contained, compact table top ionizer capable of producing copious amounts of both positive and negative ions. The variable speed fan permits a gentle flow of ionized air, reaching a distance of up to 4 feet. A charged object, when passed through the ionization field, becomes neutral instantaneously. Inherently balanced, the Ion Transport System has a fail safe balance indicator to assure proper ionization output for ESD static control applications.
-
product
Temperature, Humidity, CO2 Transmitter
H6320
The regulators are designed for online measurement of temperature (C or F), relative humidity and carbon dioxide concentration of air without aggressive ingredients. Measured temperature andrelative humidity are recomputed to following humidity expression: dew point temperature, absolutehumidity, specific humidity, mixing ratio and specific enthalpy.
-
product
Control Valve Characteristics Trainer (ULP-23)
Unitech Scales And Measurements Pvt. Ltd
Control Valve trainer comprises of globe type control valve (½”) with diaphragm type Pneumatic actuator. The control valve is of linear / Equal% type. The setup comprises of water pump with necessary flexibal piping, Water tank, I to P converter, Air regulator fitted on a table top powder coated metal frame.
-
product
Moisture Meter and Thermal Imager with MSX®
FLIR MR265
The FLIR MR265 is a professional pin and pinless moisture meter with thermal imaging designed to show you exactly where to investigate issues related to moisture, air leaks, and insulation voids. Featuring IGM™ (Infrared Guided Measurement) and MSX® (Multi-Spectral Dynamic Imaging enhancement) technology, the MR265 helps you quickly scan and target problem areas, visually guiding you to the spot where you can confidently take measurements, analyze readings, and ensure that problems are fixed. Using FLIR Thermal Studio™, you can then create and share professional reports that include findings and proof of repairs – giving your clients peace of mind that mold, rot, or moisture challenges have been resolved.
-
product
Wind Sensors
FT742
The FT742 measures wind speeds up to 75 m/s. Its innovative design incorporates a series of “turbulators” which condition the air flow to deliver our highest levels of accuracy yet. Available in four mounting options, the Flat Front (FF) and Pipe Mount (PM) are typically used in wind turbine control and the Direct Mount (DM) in meteorological applications. The Surface Mount (SM) has been specifically designed for OEM integration and for use on UAVs/drones.
-
product
Air Flow
UEi Test & Measurement Instruments
Designed with 6 HVAC/R must have parameters in one instrument. These are included in a portable battery operated instrument for measuring humidity, air temperature, dew point and calculating wet bulb, air velocity and air volume.
-
product
Electronical Load Board 6U VME64x (air cooled)
056-301
The 6U load boards are designed to simulate the power consumption of a single board computer and other boards on the backplane.
-
product
Control Room Oxygen Monitor
Model 3350
Teledyne Analytical Instruments
The Model 3350 accurately measures the concentration of oxygen in control rooms, closed atmospheres, critical breathing circuits and other applications that require the fail-safe monitoring of breathable, ambient air. It is a microprocessor-based oxygen alarm monitor for real-time measurement of the oxygen content of the atmosphere surrounding the sensor as well as shoulders the burden of personal safety with the quality and reliability offered by the Teledyne name.
-
product
Over-the-Air Radio Waveform Analyzers
Monitors and measures all radios on a network over-the-air (OTA) in real-time without user interventionProactively helps you manage all of your radios in your networkMultiple receivers may be networked to provide system wide coverage
-
product
Versatile AFM Optical Coupling
TRIOS
The TRIOS platform is an advanced research instrument that provides the entry path for researchers in materials science, biology, spectroscopy and photonics. TRIOS is the most versatile optical coupling platform providing three ports for optical spectroscopy measurements with top-down, side (oblique) and inverted accesses to the AFM tip and sample.If you work with opaque and/or transparent samples, either in air or in liquid looking at nanoscale structures and near-field optical properties investigation, the TRIOS platform is the right solution for you. It perfectly combines upright optical, inverted optical, and atomic force microscopies, and unleash all the power of both techniques providing instrument adjustment and measurement automation, high resolution and integration flexibility. Such performance is only available from HORIBA.
