Product

Beagle USB 5000 v2 SuperSpeed Protocol Analyzer - Standard Edition

TP322510

-

Total Phase Inc.

TP322510 - Total Phase Inc.

The Beagle™ USB 5000 v2 SuperSpeed Protocol Analyzer - Standard Edition is our lowest priced USB 3.0 model, and one of the most advanced USB 3.0 protocol analyzers available. Individually selectable options allow you to configure the analyzer to your specific needs today, while the fully field upgradeable design ensures this tool can evolve with your growing needs. Free Data Center Software and cross-platform support for Windows, Linux, and Mac OS X make the Beagle USB 5000 v2 SuperSpeed Protocol Analyzer - Standard Edition a user-friendly and versatile tool for any engineer working with USB 3.0 or USB 2.0.

Product

European Standard for Remote Reading of Measuring Devices

M-Bus

-

HMS Networks

M-Bus - HMS Networks

M-Bus (Meter-Bus) is a European standard for remote reading of measuring devices. M-Bus is predominantly used in buildings, for example in electricity meters, gas meters, water meters or other types of consumption meters. It is also used for various sensors and actuators.

Product

Calibration Standards

-

Bentham Instruments Ltd

Bentham Instruments Ltd

The accuracy of any spectroradiometric measurement can only be as good as that of the standard source used to calibrate the system.

Product

Disciplined Frequency Standards

2960AR and 2965AR

-

Novatech Instruments , Inc.

2960AR and 2965AR - Novatech Instruments , Inc.

The 2960AR has a rubidium timebase and provides two 10MHz and one 5MHz sine wave outputs. The 2965AR has a rubidium timebase and provides one 10MHz, one 5MHz and one signal generator output. The signal generator output uses Direct Digital Synthesizer (DDS) technology and is programmable from 100Hz to 50MHz via an RS232 serial interface. Both models can be disciplined by a 1pps input signal and provide a 1pps output. The 1pps input is typically provided by the GPS Frequency output from a device like a smart GPS receiver or antenna. The Novatech GPS1 Smart Antenna is available as an accessory to provide a complete turnkey solution.

Product

Standard 1.53 (43.00) - 4.00 (113.00) High Performance Lead Free Probe

LFRE-72T20-4

-

ECT

LFRE-72T20-4 - ECT

Current Rating (Amps): 3Average Probe Resistance (mOhm): 15Test Center (mil): 50Test Center (mm): 1.27Full Travel (mil): 250Full Travel (mm): 6.35Recommended Travel (mil): 167Recommended Travel (mm): 4.24Mechanical Life (no of cycles): 500,000Overall Length (mil): 1,700Overall Length (mm): 43.18

Product

DC Standard Source

SPS-31

-

Kongter Test & Measurement Co., Limited

SPS-31 - Kongter Test & Measurement Co., Limited

SPS-31 is specially designed to test analog and digital DC/AC Voltage meter, Current meter energy meter, DC voltage transducer and Current transducer. It is widely applied for test, production and inspection in research institution, national measurement institution at all levels, and meter manufacturer.

Product

Standard Voltage 9 Pin D-Type Cables - Connector to Unterminated for Pickering Products

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connector to unterminated cable assemblies below are suitable to use with Pickering cards and modules that utilize a standard voltage 9-pin D-type connector.

Product

Automated Temperature Resistance Standard

-

Measurements International Ltd.

Measurements International Ltd.

Exceptional Stability, Cost-effectiveness, Performance-based Results, 10 Ω, 25 Ω, 100 Ω, 200 Ω, 400 Ω and 1000 Ω Internal Standards, Built-in Temperature Chamber for Optimal Performance.

Product

Dynamic Primary Transfer Standard

RD-22

-

Radian Research, Inc.

RD-22 - Radian Research, Inc.

The RD-22 Dytronic Primary Transfer Standard represents the state-of-the-art technology in a commercially available true DC to AC accuracy transfer reference. The RD-22 has typical AC measurement accuracies within the limits of traceability. Repeatability of 1 ppm can be attained at 120 V and 5 A inputs of specific models.

Product

NF-Series Standard Models

-

Mountz Inc.

Mountz Inc.

The E-DRIV® NF-Series standard models feature an adjustable RPM setting on the tool and a selectable Soft Start mode. Engineered for high volume manufacturing applications the brushless motor design ensures durability and reduces the standard maintenance costs associated with brush type electric screwdrivers. The NF power tool is ESD certified, ensuring less than 1 Ohm at the bit tip. ESD management assures product quality, cost savings and a reduction in overall ESD failures.

Product

Rubidium/GPS Frequency Standard

PXIe-3352

-

Astronics Corporation

PXIe-3352 - Astronics Corporation

The Astronics Test Systems PXIe-3352 frequency standard module sets a new standard for high density functionality in a PXI module by combining a Rubidium oscillator with a GPS receiver into a single, compact instrument.

Product

Standard Air Capacitor Set, 1pF To 1000pF

16380A

-

Keysight Technologies

16380A - Keysight Technologies

The 16380A is a standard capacitor set consisting of four precision capacitors - 1pF (16381A), 10pF (16382A) 100pF (16383A), 1000pF (16384A). These capacitors are primarily used for performance tests of Keysight's 4-terminal pair LCR meters and impedance analyzers. Refer to the instrument's operation/service manual for the method of using these standards.