Sensors
detect a physical event then translate to a representative analog signal.
See Also: Measurement, Detectors, Meters, Transducers
-
product
Detector Testing
CI Systems' Optical Test benches are especially built to test many types of detector arrays used as the sensors of a camera, from visible to far infrared ranges. With CI Systems' expert know-how, these test benches can be tailored to a customer's design requirements. MTF, spectral response, crosstalk, NETD and sensitivity are some of the basic parameters that can be tested with CI's Optical Test benches during the design, manufacturing and integration of detector arrays.
-
product
Water Quality Sensors
Omega offers combination and differential probes for accurate measurement of pH, conductivity, ORP, and disolved oxygen. Submersible sensors for use in drums, open tanks and streams are available.
-
product
NI-9219, 100 S/s/channel, 4-Channel C Series Universal Analog Input Module
785994-01
100 S/s/channel, 4-Channel C Series Universal Analog Input Module - The NI‑9219 is designed for multipurpose testing. With the NI‑9219, you can measure signals from sensors such as strain gages, resistance temperature detectors (RTDs), thermocouples, load cells, and other powered sensors, as well as make quarter-bridge, half-bridge, and full-bridge current measurements, with built-in voltage and current excitation. Each channel is individually selectable, so you can perform a different measurement type on each channel.
-
product
Low Power Wireless Gas Detector
CX
Teledyne Gas & Flame Detection
Model CX sensors are equipped with standard analog 4-20mA, and Modbus™ RTU RS-485 outputs and can be used with SmartWireless Site Sentinel CX/CXT controllers. The CX is a very low power device making it an ideal choice for a battery powered detector (optional) in applications where power is unavailable or not economically feasible.CX gas detection sensors are easily and economically deployable in both permanent and temporary installations. These low power sensor assemblies utilize electrochemical technology for a long list of toxic gases.
-
product
Voltage Input0 to 2.5/10/25V
TGPR-0704
Voltage input data logger that is housed in a robust, waterproof (IP68) rated case.The TGPR-0704 can be used to record the output from a number of industry standard sensors. Common applications include pressure and windspeed monitoring.
-
product
Standard C23 20x30 Mm Photoelectric Sensors
Contrinex Standard C23 20x30 Mm Photoelectric Sensors
-
product
Sensors
SuessCo Sensors is one of the leading specialists and pioneers in magnetic field sensor technology. About Univ. Prof. Dr. DI Dieter Süss, we can find excellent university graduates as new employees with excellent knowledge of the latest basic research and sensor technology, which form the basis for our ongoing development work.
-
product
Electromagnet System
Dr. Brockhaus Messtechnik GmbH & Co. KG
Electromagnet systems with different power levels to produce homogeneous magnetic fields. Usable for calibration of sensors, testing of magnet systems and Hysteresis measurement. Adjustable air gap from 0 up to 60 mm. Field strength in the air gap up to 3 Tesla. Software program for control and evaluation.
-
product
MultiFunction Calibration
Omega offers a large selection of configurable Multi-Channel Meters that accept a wide variety of input signals for scanning, displaying, and logging measured data from multiple sensors.
-
product
Tactile Pressure and Force Measurement
I-Scan® System
This versatile tactile pressure measurement system is tailor-made by choosing from over 200 pressure sensors to meet your specific application requirements.
-
product
UV-VIS-NIR Spectrometer
OES-Star
Horiba’s OEM division, a major supplier of OES solutions, has developed a high end OES Spectrometer with a proprietary optical configuration for broad coverage (185-1050 nm) and high resolution. The OES-Star is available with a selection of three UV-VIS-NIR Back-Illuminated (B.I.) sensors, one TE-Cooled and two uncooled CCD detectors. This unique OES system features an optical design that provides a high peak symmetry across a very broad spectral range combined with high spectral resolution better than 1 nm, at an unmatched aperture of F/2.3.
-
product
Accelerometer
BC 201
The BC 201 acceleration meters are capacitive acceleration meters and can be used as linear acceleration and position sensors since they measure not only the variable component of the acceleration signal, but the direct component as well.
-
product
Static Control/UV Curing Devices
Panasonic Industrial Devices Sales Company of America
Static Controls (Ionizers)Panasonic offers static elimination tools and Sensors in various form factors, to fit specific application requirements.UV Curing DevicesPanasonic offers LED and lamp spot-type UV Curing Systems. These systems can be controlled manually or integrated into automated applications and configured with replaceable heads, cables and lenses to best fit application requirements.
-
product
Latching Relays
A latching relay is a two-position electrically-actuated switch. It maintains either contact position indefinitely without power applied to the coil. It is controlled by two momentary-acting switches or sensors, one that 'sets' the relay, and the other 'resets' the relay. The latching relay maintains its position after the actuating switch has been released, so it performs a basic memory function.
-
product
Continuous Surface Current Mapping & Wave Monitoring System
SeaSonde
The SeaSonde HF radar system by CODAR Ocean Sensors is your solution for making continuous, wide-area ocean observations. The SeaSonde will provide you with years of real-time data over large coverage areas, with ranges up to 200 km — This is not possible with any other technology!
-
product
Security/Detection
If your design challenge is to create the best motion sensor or motion detector - fire sensor or fire detector, smoke sensor or smoke detector - you've come to the right company. Dexter's sensor technologies are at multiple fronts today, reducing the threat of combat on land, sea and air. Yet the industry leading advantages of Dexter sensors - low cost, high sensitivity, low energy consumption and long life - make them the perfect motion sensor for home, office and facility applicati...show more -
product
Gauge Type T Thermocouple Wire
W-TW-36
Most thermocouple wire used in the manufacture of sensors is "Special Limits" wire which, to meet NIST standards, must be accurate to 0.5°C in the range 0-50°C. This means that even with most sophisticated electronics, the best possible accuracy for the system is 0.5°C.
-
product
PCI Resistor Card 2-Channel 2 Ohm To 16.3k Ohm
50-293-031
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Soil Water Potential Sensors
Campbell Scientific offers soil water potential sensors that measure soil water potential via two methods: heat dissipation or electrical resistance. The sensors determine the energy status of the water in the soil, which describes the force that holds the water in the soil.
-
product
Flat Panel Detectors
Are a class of solid-state x-ray digital radiography devices similar in principle to the image sensors used in digital photography and video.
-
product
Torque Instruments
Advanced Force & Torque Indicator
Used with a range of 'plug and play' torque and force sensors - ideal for 'static' or 'dynamic' (rotary) torque measurementCan be used as part of a Mecmesin test system or mounted to one of your own test rigs
-
product
MPS™ Refrigerant Gas Sensor
NevadaNano’s Molecular Property Spectrometer™ (MPS™) MPS Refrigerant Gas Sensor provide accurate and reliable detection of mildly flammable (A2L) R-32, R-454b blends, R-1234yf and other low global warming refrigerant gases such as (A1) R744 as well as (A3) R290 and R600 common in HVAC applications. With a 15+ year calibration interval and lifetime, the MPS A2L Refrigerant Sensors deliver industry-leading performance and the lowest total cost of ownership.
-
product
Magnetostrictive Sensors
Linear position sensors with a profile design are contact-free and absolute measurement systems for the precise detection of one or more positions. They deliver convincing performance in harsh environments, for example in presses, injection molding machines or gantry robots, because they are made of an hermetically sealed IP67 aluminum housing. The magnets of the position encoder act on the measurement element through the wall of the profile.
-
product
Current logger0 to 20mA
TK-4802
Supplied with an input cable, this logger can measure current between 0 and 20mA DC and can be connected to many industry standard devices, such as CO2 sensors and current clamps, enabling the logging of a wide range of process parameters.
-
product
Light Sensor Logger
LI-1500
The LI-1500 connects up to three light sensors with BNC terminals. Package includes four AA batteries, USB cable, AC power supply adapter, carabiner clip, carrying case, Windows® file viewer software, and instruction manual. Sensors sold separately.
-
product
PXI/PXIe High Density Precision Resistor Module
42-297A-111
The 40-297A-111 (PXI) and the 42-297A-111 (PXIe) are 9-channel programmable resistors with a range of 1 Ω to 61 Ω. They are part of the 40/42-297A series of high density precision resistor modules and provide a simple solution for applications requiring accurate simulation of resistive sensors.
-
product
Torque Sensors
In universities and industry, for basic research or quality assurance: Kistler torque sensors guarantee precise definition of the power and friction values of drives, transmissions and pumps. Strain gage technology (DMS) is a powerful solution for measurements on rotating shafts, and also for long-term dynamic and static measurements. Maximum precision, the most rigid structure possible and high temperature stability: thanks to these assets, DMS sensors can accomplish the most demanding tasks. P...show more -
product
CATx Surge Protector
SP-CAT5-6V
Protects sensors running on CATx unshielded twisted pair (UTP) cable against the effects of electrostatic discharge, faulty wiring and lightning. The use of two protectors on each end of the line will provide increased protection for each end against surges. Protected pins: (1,2) (3,6) (4,7) and (7,8) pass through. Impedance: 85 to 115 Ohms. Surge suppression: 22Vpeak @ 100A 10/1000µs. Maximum continuous voltage: 6Vpeak. Dimensions WxDxH: 1x3.6x0.9 in (25x91x23 mm). Regulatory approvals: GR 1089, NEC 800.100 and 830.100, ITU 703, UL94 V0 Flame Rated.
-
product
PXI Programmable Resistor Card 2-Channel 2.5 Ohm to 2.04k Ohm
40-294-022
These PXI Programmable Resistor modules are available with either two channels of 16-bit, two channels of 12-bit or four channels of 8-bit resistor chains in a single 3U PXI module. The module is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.