Sensors
detect a physical event then translate to a representative analog signal.
See Also: Measurement, Detectors, Meters, Transducers
-
product
Position Sensors
ams offers a broad range of high-performance position sensors which are suitable for use in industrial, medical, robotics, automotive and consumer applications. Patented technology gives all ams position sensors inherent immunity to external stray magnetic fields, making them highly robust, and lowering system cost because no shielding is needed. ams position sensors are available for use in applications governed by the most stringent safety regulations.
-
product
PXI/PXIe High Density Precision Resistor Module, 18-Channel
40-297A-011
The 40-297A-011 (PXI) and the 42-297A-011 (PXIe) are 18-channel programmable resistors with a range of 1 Ω to 61 Ω. They are part of the 40/42-297A series of high density precision resistor modules and provide a simple solution for applications requiring accurate simulation of resistive sensors.
-
product
Low Input Bias Current Op Amps (≤100 pA)
Low input bias current op amps are required whenever the difference of currents or voltage is small and needs to be measured accurately. These op amps are used so that the signal is not loaded down by the input of the op amps. Low input bias current op amps are critical for interfacing sensors in applications from photodiodes, pH meters, or other electrometer related functions to downstream electronics. Analog Devices has many precision op amps that fit the definition and range of these applications.
-
product
PXI Programmable Resistor Card 2-Channel 3 Ohm to 16.3k Ohm
40-294-031
These PXI Programmable Resistor modules are available with either two channels of 16-bit, two channels of 12-bit or four channels of 8-bit resistor chains in a single 3U PXI module. The module is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Wide-range Programmable DC Power Supply
IT6900A Series
IT6900A series wide range programmable power supply have built-in standard RS232, USB, GPIB, RS485 and analog interface (RS485 and analog interface are just for IT6900B), support SCPI protocol, facilitate remote control, industrial PLC control and the formation of intelligent test platform. Remote compensation terminals avoid the problem of inaccurate testing caused by voltage drop on the wire.Low ripple, low noise and built-in digital voltmeter make IT6900A easy to do external measurement.IT6900A can be widely applied in DC-DC power supply module, battery charging and sensors and other test areas.
-
product
Power Sensors
KRYTAR's Power Sensors simplify your measurement equipment requirement when used in conjunction with KRYTAR's Model 9000B Power Meter for accurate and repeatable power measurements. The 9000B power meter with a 9500A Series power sensor offers the user exceptional measurement speed and accuracy at an affordable price.
-
product
Sensors And Cables
Sensors provide the vital link between the material under test and the instrument that measures its properties. Lambient Technologies LLC has developed a variety of disposable and reusable sensors for different applications. Click on the images below to learn more.
-
product
PCI High Density Pecision Resistor Card
50-298-054
The 50-298-054 is a high density programmable resistor card with 6 channels which can be set between 4Ω and 22.3MΩ with 2Ω resolution The 50-298 range provides a simple solution for applications requiring accurate simulation of resistive sensors. The 40-298 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems.
-
product
Fixed Infrared Temperature Sensors
This fixed infrared sensors selection is vast with many different features without any lack in quality. These infrared sensors are designed for fixed continuous non-contact temperature measurement.
-
product
CANdo Module
Auto
The CANdo AUTO Module is a rugged, multi-purpose CAN bus module with a USB port, two precision analogue inputs & a DC power supply input. The module is capable of operating either connected to a PC, or in a standalone mode powered from a 12 or 24V DC supply, such as a vehicle battery. The module maybe used as an interface between a PC & a CAN bus, or between analogue sensors & a CAN bus, in standalone mode. In addition, the module maybe programmed to transmit fixed, periodic CAN messages automatically on power up.
-
product
Radar solutions for mechanical engineering
With OndoSense radar sensors you will increase the productivity of your industrial systems, reduce unplanned maintenance times for your machines and automate the work processes in the Industry 4.0.
-
product
Silo Weighing System
Silo Hawk
Silo Hawk is the market-leading non-intrusive real time weighing solution for Silos and other weighing apparatus, using the high accuracy measurement solutions from our bolt on sensors range.
-
product
PXI/PXIe High Density Precision Resistor Module
42-297A-122
The 40-297A-122 (PXI) and the 42-297A-122 (PXIe) are 4-channel programmable resistors with a range of 1.5 Ω to 1.81 kΩ. They are part of the 40/42-297A series of high density precision resistor modules and provide a simple solution for applications requiring accurate simulation of resistive sensors.
-
product
Voltage Input0 to 2.5/10/25V
TGPR-0704
Voltage input data logger that is housed in a robust, waterproof (IP68) rated case.The TGPR-0704 can be used to record the output from a number of industry standard sensors. Common applications include pressure and windspeed monitoring.
-
product
Hall Effect Sensor
The hall effect sensor products are manufactured according to international standards. Being an ISO 9001:2008, ISO 14001 and OHSAS 18001 certified company, DER EE is capable of designing and producing superior products to the highest standards of customers' requirements. Hall effect sensors we provided are a device containing both the sensor which produces a very low signal level and contains the vacuum tube amplifier and a high gain integrated circuit (IC) amplifier in a single package. hall effect sensor offer many applications to sense position and motion, to control electric motor control, to sense wheel rotation and so on.
-
product
PXI High Density Precision Resistor Module, 3-Channel, 4Ω to 22.3MΩ
40-298-154
The 40-298-154 is a high density programmable resistor module with 3 channels which can be set between 4Ω and 22.3MΩ with 2Ω resolution The 40-298 range provides a simple solution for applications requiring accurate simulation of resistive sensors. The 40-298 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems.
-
product
4-20mA Converters
4026
SPECTEC Innovative Sensor Solutions
Model 4026 Freq to Voltage or Freq to Current Converter accepts frequency input from any magnetic speed sensor, digital magnetic pickup or Hall effect zero speed sensors. Input and output configurations are field selectable. Input range is adjustable between 1100 Hz - 10 kHz or 75Hz to 1100 Hz. Output selection can be configured as 4-20mA converter, 10-50mA converter, 0-5 V FTV converter or 0-10 V FTV converter. ZERO and SPAN adjustments easily calibrate to almost any measurement range, with little interaction between the adjustments.
-
product
Power Distribution Unit with Switchable Outputs, Soft Start & Integrated Ethernet Switch
PDU-200
The PDU-200 is a power distribution unit for automatic tests equipment (ATE). Its outputs are software controlled to allow power on sequencing and direct interaction form the test sequence. The integrated 24V power supply provides power for additional equipment like relays and sensors. The PDU-200 is intended to use with an external remote-control panel which provides On & Off buttons as well as an E-Stop and acknowledge button. It’s integrated eight port switch simplifies wiring as no additional components are required.
-
product
RH+T+Tdp Cable Probe
T3111-2
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
product
Flow Sensors
Accuracy±0.75% of full scale Measuring pipe size range DN 15 to DN 600(0.5 to 24 inch) Measuring flow rate range 0.15 to 8 M/s(0.5 to 26 Ft/s) Field-rangable supply voltage from DC 5 to 24 VS Field-rangable operting temperature from -20 to 90°C(-4 to 194°F) Protection class NEMA4(IP65) or NEMA6,6P(IP68) CE EMC certification
-
product
SCADACore Cloud-Connect
SCADACore’s Cloud-Connect products bridges your sensors and field operations to our fully-managed Web SCADA solution. SCADACore delivers complete end-to-end solution to bring field data to you anytime, anywhere.
-
product
High Frequency Current Transformer Clamps
HFCT-20HD & HFCT-60HD™
The HFCT-20HD™ and HFCT-60HD™ are high frequency current transformer sensors designed for partial discharge detection on electric apparatus’ ground returns. Made from superior quality materials, it is designed for any environment.
-
product
Gas Detectors
CO2, Humidity And Temperature Sensors, Dual Wavelength NDIR CO2 Sensor (Non-Dispersive Infrared) For Superior Stability, User Operated CO2 Calibration, Data Hold & Max/Min/STEL/TWA Function
-
product
10-CH Pneumatics CAN
YAV90PNE
The YAV90PNE is a complete “plug & play” pneumatics subsystem controlled by CAN, for ATEs with Virginia Panel receiver. Thanks to this module, pneumatics actuators that are commonly used in the fixture side of an ATE, can be controlled. 10 3-way micro-valves are able to contorl 10 simple effect actuators or else 5 double effect ones. The module includes input for the position sensors. A pressure sensor is also included, so that the system air mains working pressure can be set between a minimum and a maximum.
-
product
PXI/PXIe High Density Precision Resistor Module
42-297A-050
The 40-297A-050 (PXI) and the 42-297A-050 (PXIe) are 6-channel programmable resistors with a range of 3 Ω to 1.51 MΩ. They are part of the 40/42-297A series of high density precision resistor modules and provide a simple solution for applications requiring accurate simulation of resistive sensors.
-
product
ISC-1783, 5 MP, 1.58 GHz Processor, Monochrome/Color Smart Camera
785154-01
The ISC‑1783 is a high-performance smart camera for machine vision and is powered by a 1.58 GHz dual-core Intel Celeron processor. The combination of the onboard processor with a CMOS image sensor provides an easily distributed all-in-one system. In addition to high-performance image acquisition and processing, you can use built-in digital I/O and industrial communication options for dynamic, real-time communication and integration with industrial automation devices including programmable logic ...show more -
product
PXI 10W Programmable Resistor Module, 2-Channel, 1Ω to 62.1Ω
40-253-011
The 40-253-011 is a programmable resistor module with 2 channels which can be set between 1Ω and 62.1Ω with 0.25Ω resolution The 40-253 range provides a simple solution for applications requiring up to 10W of power handling per channel. The 40-253 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems. Each channel is able to simulate short or open circuit conditions that can be experienced in a system caused by faulty wiring or sensors.
-
product
Scienlab Measurement And Control Module
SL1068B
The Measurement & Control Module SL1068B is a rack-mount measurement module which provides voltage outputs for analog signaling – useful e.g. for the emulation of temperature sensors or the controlling of regulation vents with voltage input with 8 channels. The module can be used either as a stand-alone device or as extension for a Scienlab Battery Test System.
-
product
Wireless Sensors
Designed to measure specific parameters about their physical surroundings and produce outputs, often electrical signal
-
product
Optical Sensors: Fluorometers
Sea-Bird Scientific offers a wide variety of fluorometer configurations and measurement capabilities. ECO fluorometers are available in single, dual, and three-measurement combinations. Fluorometers measure chlorophyll-a, FDOM, rhodamine, phycocyanin, and phycoerythrin.