Product

Extendible Test Leads

-

Probe Master Inc.

Probe Master Inc.

The Extendable Tip Probe permits testing in those hard to reach areas. The tips are fully insulated with durable Kynar. This prevents accidental shorting of adjacent components. The tip is stainless steel and is very sharp, allowing for penetration of conformal coatings. The rubber lead is 18 gauge, 48" long.

Product

Pogo Ground Lead for ZS4000 (Qty.4)

PK-ZS-020

-

Teledyne LeCroy

PK-ZS-020 - Teledyne LeCroy

Pogo Ground Lead - ZS4000 (Qty.4)

Product

Oscilloscope Module, AC/DC, Clamp Meter Lead, Digital Multimeter

72-9180

-

Tenma

72-9180 - Tenma

The 72-9180 is an AC/DC Clamp Meter Leads, use almost any DMM as a clamp meter for current testing up to 400A and current displays as an easily translated voltage reading.

Product

Beam Lead Capacitors

-

Naprotek, LLC.

Naprotek, LLC.

Beam lead capacitors have high insulation resistance, low dissipation factor, and low temperature coefficient, which allow for use in military and aerospace designs. Their robust performance and small form factor provide repeatable performance.

Product

Flying Lead Probes

FLP850

-

Silicon Control Inc.

FLP850 - Silicon Control Inc.

The PCIE850 provides a complete test and debug solution for PCI Express Bus. Interposers and probes connect to the PCIE850 providing access to PCI Card, AMX, XMC and VPX systems.

Product

Lead Acid Intelligent Battery Tester

612

-

ACT Meters International Ltd

612 - ACT Meters International Ltd

This digital battery tester is designed for testing 6V and 12V standby SLA, cyclic GEL and car FLOODED batteries. Simple in operation, the ACT 612 simulates a full 20 hour (C20) discharge test in seconds and displays the DC Voltage results and Ah capacity available.

Product

Test Leads and Breakouts

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

Test Leads and Breakouts by Pasternack

Product

The Leading Measurement System for the Analysis of Porous Materials

ELWIS

-

Autoneum Holding AG

ELWIS - Autoneum Holding AG

ELWIS (Evaluation of Light Weight Impedance System) offers a full and rapid characterization of porous materials based on the analysis of a single sample. The ELWIS system consists of the ELWIS-A and ELWIS-S components which can be used independently from each other although both applications are needed for a complete material simulation.ELWIS-A measures acoustic parameters that are needed to evaluate the acoustic performance of sound insulation and sound-absorbing multi-layer materials. An additional impedance tube for absorption measurements at higher frequencies is available for ELWIS-A.ELWIS-S measures structural parameters that are needed to simulate the dynamic and acoustic behavior of sound packages in the medium to low frequency range (including the "Poisson Ratio" for foam materials).ELWIS is very easy to operate: Thanks to its user-friendly software, the system can also be used to obtain reliable results by users with only limited experience in the characterization of porous materials.

Product

Probe Ground Lead (short sp probe tip)

PP005-GLPT

-

Teledyne LeCroy

PP005-GLPT - Teledyne LeCroy

Probe Ground Lead (short sp probe tip).

Product

Ultra High 1.77 (50.00) - 10.00 (283.00) High Performance Lead Free Probe

LFRE-25Z-10

-

ECT

LFRE-25Z-10 - ECT

Current Rating (Amps): 8Average Probe Resistance (mOhm): 8Test Center (mil): 100Test Center (mm): 2.54Full Travel (mil): 250Full Travel (mm): 6.35Recommended Travel (mil): 167Recommended Travel (mm): 4.24Mechanical Life (no of cycles): 1,000,000Overall Length (mil): 1,300Overall Length (mm): 33.02