Accumulators
accumulate energy, typically under pressure.
-
Product
Radiation Microdosimeters
-
Teledyne e2v HiRel Microdosimeter is a compact hybrid microcircuit which directly measures total ionizing dose (TID) absorbed by an internal silicon test mass. The test mass simulates silicon die of integrated circuits on-board a host spacecraft in critical mission payloads and subsystems. By accurately measuring the energy absorbed from electrons, protons, and gamma rays, an estimate of the dose absorbed by other electronic devices on the same vehicle can be made. The Microdosimeter can operate from a wide range of input voltages. The accumulated dose is presented to three dc linear outputs and one pseudo-logarithmic output giving a dose resolution of 14 µrads and a measurement range up to 40 krads. These outputs are intended to be directly connected to most analog-to-digital converters (ADCs) or spacecraft housekeeping analog inputs (0-5 V range), which makes minimal demands on the host vehicle. The Microdosimeter incorporates a test function to allow electrical testing of the hybrid without the need for a radiation source.
-
Product
Test Systems
-
This measurement system is the state-of-the-art acoustical analyser from Norsonic. Using the experiences and accumulated know-how from the previous generations of analysers, Norsonic is offering a multi-channel system with focus on user friendliness, high efficiency, and accurate reporting. The system has been designed for field testing as well as demanding accredited lab measurements.
-
Product
Instrument Software for SPC- and DPC Modules
SPCM
-
*Multifunctional 64 bit Data Acquisition Software*Recording of Multi-Dimensional TCSPC Results and Time-Tag Data*Control of Multi-Dimensional Recording Features*Configurable User Interface*Acquisition of Decay Curves, FCS, MCS Traces, FLIM and PLIM Images*Online Calculation and Display of FLIM, PLIM, FCS, PCH, MCS Traces and Fit of FCS Curves*Different Operation Modes Available*Measurement Control of Up to 4 Modules*Configurable for Different Instrument Configurations*Accumulation and Autosave Functions*Integrated Scanner Control*Saving, Loading and Conversion of Photon Distributions, Images and Time-Tag Data*Saving and Loading of Results and System Parameters*Integrated Control of Ti:Sa Lasers*Integrated Control of Motor Stages
-
Product
Universal Counters
SC-7217A / SC-7215A
-
The SC-7217A / SC-7215A universal counters provide full capabilities including frequency, period, time interval, pulse width, phase, frequency ratio, duty cycle, event accumulation and peak voltage measuring, with simple operation. They are suitable for R&D and technical training as a basic measuring instrument as well as for production/inspection lines.
-
Product
Side Scan Sonar for Gavia AUV
-
Several brands of Side Scan Sonars (SSS) can be installed on the Gavia in the control and communication module. Available frequencies range from 600 kHz to 1.8 MHz in both single and dual frequencies The SSS accumulates data at a rate of up to 40 megabytes per 1000 meters. A 16-gigabyte flash disk is provided standard for storage of SSS data, with larger disks available optionally.
-
Product
Footspacing Kit
10759A
Accessory Kit
The Keysight 10759A Foots pacing Kit, included in the Keysight 55282A Flatness Accessory Kit, provides three precision baseplates with 50.8 mm (2 in), 101.6 mm (4 in) and 152.4 mm (6 in) pad spacing. As an accessory to the Keysight 5530Laser Calibration System, the kit simplifies the mounting of the flatness mirror used in flatness measurement applications. The Keysight 10759A minimizes the grid setup and data accumulation time required for plate calibration.
-
Product
Dosimeter-Radiometer
MKS-05 Terra
-
Measurement of gamma and X-ray radiation ambient dose equivalent rate.Measurement of gamma and X-ray radiation ambient dose equivalent.Measurement of surface beta-particles flux density.Measurement of dose equivalent accumulation time.Real time measurement (clock).
-
Product
Gaussmeter
H1 - 4
-
The Field Strength Meter H1 - 4 is a competitive digital display hand-held instrument fed by power supply, battery or accumulator. Switchable between AC and DC measurement.
-
Product
Regeneration Station
-
This equipment is a stand-alone device that enables to coherently regenerate an optical signal allowing long-haul dissemination of an ultra-stable optical frequency reference. Its architecture is based on the heterodyne phase-locking of a narrow spectral width laser diode on the reference signal. The station is equipped with low phase noise optical interferometer that perform a thorough characterization of the phase noise accumulated by the incoming signal, and a compensation system of this phase noise.
-
Product
UV Aging System
-
King Design Industrial Co., Ltd.
*Comply with IEC 61215, IEC 61646 UV Preconditioning Test Specification *Radiation intensity is linear adjustable; the intensity deviation is guaranteed within ±15% on the testing surface *Test cabinet is equipped with timer controller in a time range of 0～9999 hr, as well as time accumulating and power-shutdown data-saving ability * Using the standard PT-100 membrane thermo-transmitter to accurately control temperature in testing process
-
Product
Flatness Accessory Kit
55282A
Accessory Kit
The 55282A Flatness Accessory Kit is composed of an 10759A Footspacing Kit and two 10773A Flatness Mirrors. The footspacing kit provides three precision baseplates, with 50.8 mm (2 in), 101.6 mm (4 in), and 152.4 mm (6 in) pad spacing respectively, that minimize the grid setup and data accumulation time required for plate calibration. The flatness mirrors provide 100 percent reflectance and turn the direction of an incoming laser beam 90 degrees.
-
Product
Power Meters M3M Series
-
*Frequency range 10 MHz to 18 GHz*Wide Dynamic range −60 dBm to +20 dBm*High Accuracy up to ±0.33 dB*Lightweight and rugged*Simple set-up and usage*Up to 16 hours with built-in accumulator battery
-
Product
FFT Comparator
CF-4700
-
The CF-4700 FFT comparator is a pass/fail judgment machine used on production lines that is highly effective in accurate quality inspection by analyzing sound or vibration from products. As being incorporated our accumulated FFT technology over the years, the CF-4700 enables pass/fail judgment by extracting the amount of fluctuation of signal size focusing on a specific frequency band.
-
Product
Multifunctional Meter
CPM-20
-
CPM-20 multifunction power meter provide high accuracy single phase and three-phase measuring and displaying, energy accumulating, power quality analysis, and data communication.It provides maximum/minimum records for power usage and power demand parameters.Hardware standard built in a RS485 Modbus communication port.FCC and CE Approved
-
Product
Signal Analysis
Synchronous Accumulation (Order Analysis)
-
Order analysis is one of the most convenient and efficient methods for diagnostics and balancing of rotating mechanisms and transmission gears. With an RPM sensor and a vibration sensor, it is possible to study the time characteristics of gear vibration signals. It is a well-known fact that a signal from a vibration sensor is affected by signals from other sources. To tune out from the disturbing signals, the synchronous signal accumulation method is used. For each shaft rotation, the RPM sensor provides a rotation mark. This signal serves as a triggering strobe for the vibration sensor signal sweeping. The obtained signal sweeps are combined. All the sources of the signals related to the shaft frequency (frequency of rotation) are accumulated and increased in the accumulator linearly proportionally to the N number of rotations. All other signals that are not correlated with the shaft frequency are accumulated proportionally to N1/2 and in case of a greater number of averagings, the useful signal exceeds the interference level.
-
Product
Building Vibration Measurement
-
Metra Meß- und Frequenztechnik Radebeul GmbH & Co. KG
Contains a highly sensitive triaxial acceleration sensor, measurement, evaluation and recording electronics as well as an accumulator
-
Product
Weather Meter
Kestrel 3500
-
The Kestrel 3500 Weather Meter has the most functions of any Kestrel Meter in the 3000 series. The Kestrel 3500 measures temperature, wind speeds, barometric phenomena, pressure trends of up to 3 hours, and more. The Kestrel 3500 provides a complete range of weather measurements, but does not log accumulated data like the more high-tech weather meters of the Kestrel 4000 series.
-
Product
Optical Transmitter
STR1310
-
Hangzhou Softel Optic Co., Ltd.
STR1310 outdoor laser transmitter (Relay station) is our featured product. With years accumulated HFC network engineering practice and equipment development experiences, specifically developed for 1310nm outdoor optical emission or optical relay transmission. The successful development of this product provides an economical and practical solution for the 1310nm outdoor optical emission or optical relay transmission in CATV engineering practice.
-
Product
Airborne Tactical Advantage Company
ATAC
-
Our sister company, ATAC operates a live-air training business focused on real-world combat situations and is the world’s largest outsourced civilian, tactical airborne training organization. ATAC has trained Navy, Air Force, Marine and Army air-crews, ship-crews and combat controllers in the air-to-ship, air-to-air and air-to-ground arenas. Over the last 20 years, ATAC has accumulated over 60,000 training flight hours and has pioneered much of what is now standard in the growing tactical airborne training services industry.
-
Product
Outdoor AGC Optical Node
SR814WB
-
Hangzhou Softel Optic Co., Ltd.
*SR814WB series of 1310nm optical relay station is a two-way optical connector with HFC network engineering experience and equipment development experience accumulate for many years by ourselves only for HFC two-way Broadband Network. This product is designed with full consideration of network topological structure.The building block system modularized structure is adopted in SR814 Series *Field Optical Work station. It has flexible configuration and convenient debugging, and solves engineering and technical problems of collecting noise with two-way return path network. And it meets the requirements of modern CATV business network security transmission with high reliability of FTTB (Fiber to the Building).*SR814W Band SR814WB Optical Workstation are four way independent output models; WR-8604HB and WR-7504HB Optical Workstation are two way independent output models.*SR814W BOptical Workstation is our latest flagship product. Advanced optical AGC control circuit adds to the part of optical receiving to ensure the input optical power as low as -9dBm.
-
Product
Embedded Vision
-
In the industrial environment, especially in digitalized, automated production scenarios, more and more so-called embedded systems are being used. Embedded devices are small, with compact dimensions, highly efficient, and generate little waste heat. Therefore, they are also suitable for limited space conditions. Due to often harsh environmental conditions, they must be particularly robust and resistant to external influences like massive dust accumulation, strong vibrations, and high humidity or even direct contact with water. Typically, embedded devices are handhelds, smartphones, tablets, vision sensors, smart cameras, smart sensors and single board computers. If the systems have integrated machine vision software, they can be used for a wide range of image processing applications. This is known as embedded vision.
-
Product
Accumulator Kits
-
For maximum accumulator performance, Parker has designed a wide range of complementary accumulator accessories, which include charging and gauging assemblies, unloading valves, repair tools, port adapters and mounting kits.
-
Product
Metal Tube Float Flow meter
F56
-
Beijing Airport Beiguang Instruments Co., Ltd
F56 Metal Tube Float Flow meter Series are used for measure instantaneous and accumulated flow rate of liquid, gas and steam in closed pipelines. It is suitable for metering flow value on site or electronic remote. The measuring principle is based on the hydrodynamic effects,This makes float moving from bottom to top in vertical Pipe. As the displacement of float is in related to flow rate, which can be read from the indicator by means of the magnetic drive system in non-contact form . Also, flowmeters output electrical signal (4-20)mA / hart communication protocol with high / low limit Warning switches/integrating flow PCB broad can be configured.
-
Product
Silicon Detectors
-
Through the photovoltaic effect, detectors provide a means of transforming light energy to an electrical current. The root of the theory behind this phenomenon is a small energy gap between the valence and conduction bands of the detector. When light, with enough energy to excite an electron from the valence to the conduction band, is incident upon the detector, the resulting accumulation of charge leads to a flow of current in an external circuit. Since light is not the only source of energy that can excite an electron, detectors will have some amount of current that is not representative of incident light. For example, fluctuations in thermal energy can easily be mistaken for light intensity changes. A variety of these "non-light" contributions are present and, when summed up, make up the total noise within the detector.
