Product

Low Noise Amplifier

DLNA8-0.1-18G-2223

-

COM-MW Co., Ltd.

DLNA8-0.1-18G-2223 - COM-MW Co., Ltd.

Low Noise Amplifier, Frequency 1~18GHz, Gain 24dB, Noise figure 3.2dB, P-1dB 22dBm, SMA Female

Product

High Density, Low Noise, Floating Low Voltage Power Supply System

PL500 Series

-

W-IE-NE-R, Plein & Baus GmbH

PL500 Series - W-IE-NE-R, Plein & Baus GmbH

The WIENER PL500 is a high density, low noise, floating low voltage power supply system. The PL500-Series has been designed  to power lowest noise electronics with medium to high currents (10A to 500A current/channel range) over long distances in voltage or current controlled mode. Operating in either un-sensed or sensed mode the dynamic behavior can be set internally or by software for short, medium or long distances.

Product

Two Channel Phase and Amplitude Noise Analyzer

DCNTS -190

-

Eastern-Optx

DCNTS -190 - Eastern-Optx

The DCNTS is a two channel Phase and Amplitude noise analyzer. Its dual demodulator architecture allows the system to use cross-correlation to cancel its internal noise and limitation; it is like comparing the outputs of 2 systems and only display the similarities while rejecting differences. Its main extension is the Residual Noise measurement front-end which includes all necessary hardware to automatically measure residual noise on 2-ports devices either in RF frequencies or microwave. It could be a frequency multiplier or divider, an amplifier or any other phase coherent input to output device.

Product

Low Phase Noise Frequency Synthesizer

-

Corech Microwave Limited

Corech Microwave Limited

Corech’s low phase noise frequency synthesizer series generates precise and stable frequency signals across a wide frequency range, available in SPI serial interface. These cost competitive, rugged and compact module are the ideal choice for RF & Microwave systems such as communication systems, test and measurement equipment, radar systems etc.

Product

Waveguide Low Noise Amplifiers

-

Pasternack Enterprises, Inc.

Pasternack Enterprises, Inc.

Waveguide Low Noise Amplifiers by Pasternack

Product

High Power White Light LED Light Sources

LS-HP1

-

lightsource.tech GmbH

LS-HP1 - lightsource.tech GmbH

The LS-HP1 is a series of high-power, high brightness light sources for liquid light guides (LLG). It is characterized by its outstanding luminance and thus delivers very high light output from liquid light guides.The LS-HP1 works with the latest generation of high-power LEDs with up to 100W power from an area of less than 15mm² and is significantly brighter than a conventional halogen light bulb with 150W. The LS-HP1 is available for liquid light guides with core diameters of 3 or 5mm.

Product

Noise Activated Warning Signs

-

Castle Group Ltd.

Castle Group Ltd.

Signs within the workplace that warn of high noise levels are common place as they help ensure that employees, visitors and the public are aware and, if required, wearing ear protectors. This type of signage is ideal when noise levels are stable and consistent.

Product

Precise Measurement of Airborne Noise Insulation

Isokell

-

Autoneum Holding AG

Isokell - Autoneum Holding AG

Isokell offers a flexible method geared specifically to the needs of the automotive industry for measuring airborne noise insulation and the transmission loss of vehicle components. The system is easier to use and less costly than traditional acoustic measurement systems.

Product

Portable 4-channel Noise & Vibration Analysis System

WCAmini AD-3661

-

A&D Company, Ltd.

WCAmini AD-3661 - A&D Company, Ltd.

* USB bus power unit * 24 bit, 4-channel measurement * A channel exclusively for tacho pulse measurements * WCAPRO (multi analysis software) * FFT analysis and real-time octave analysis * Tracking analysis and throughput recording/playback * Equipped with WCA Lite (easy-to-use analysis software)

Product

Multi-Channel Automotive Noise Finder

7633A

-

Peaceful Thriving Enterprise Co Ltd

7633A - Peaceful Thriving Enterprise Co Ltd

Multi-Channel automotive noise finder is a portable equipment to diagnose the defect of the vehicle. When the generator is running, it can detect the impact and vibration due to the defect and failure of bearing, gear, valve, crank, cylinder, gear box, and vehicle body…etc. With this equipment, the repairer can clearly locate which part of the machine cause the noise and how serious is it; even though the repairer operates the equipment in a very noisy environment.

Product

Ultra Low Noise Preamp

J2180A

-

PICOTEST Corp.

J2180A - PICOTEST Corp.

The J2180A low noise preamplifier provides a fixed, AC coupled 20dB gain while converting a 1 MOhm input impedance to a 50 Ohm output impedance. With a 3dB bandwidth of 0.1Hz to 100MHz, the preamplifier improves the sensitivity of oscilloscopes, network analyzers and spectrum analyzers while reducing the effective noise floor and spurious response. The preamplifier can also serve as a low frequency DC blocker for a spectrum analyzer or you can use it to connect a high input impedance oscilloscope probe to 50 Ohm equipment.

Product

Durability, Noise & Vibration Test Platform

LMS Test.Lab

-

Siemens Digital Industries Software

LMS Test.Lab - Siemens Digital Industries Software

LMS Test.Lab with faster, more accessible and more complete test-based engineering for noise, vibration and durability. From multichannel data acquisition to a full suite of testing, analysis and reporting solutions, LMS Test.Lab 15 provides you with a versatile and rigorous problem-solving toolkit.

Product

Low Noise Amplifier

1010

-

Dexter Research Center, Inc.

1010 - Dexter Research Center, Inc.

A low noise, DC-coupled amplifier is packaged in a rugged, die-cast aluminum case with BNC connectors enabling input and output. Provides very low voltage noise and current noise in the critical region of 0.1 Hz to 10 Hz making this the ideal amplifier for thermopile detectors in sensitive systems design and laboratory experiments.

Product

Noise and Vibrations Meters

Vibrating Hand Arm

-

PASI srl

Vibrating Hand Arm - PASI srl

Monitoring / Noise and vibrations meters

Product

Abnormal Noise Detection System In-Line Tester

MV-6000B

-

Cosmo Instruments Co., Ltd.

MV-6000B - Cosmo Instruments Co., Ltd.

This product sets criteria found with waveform analysis software, and runs automatic judgment in-line.

Product

Phase Noise Analyzer

NXA-50

-

Eastern-Optx

NXA-50 - Eastern-Optx

This new NXA-50 is a sea-change in Phase Noise Test Systems. Making both residual and absolute noise measurements out to 50 GHz, this self-contained instrument uses either internal or external references with cross correlation for maximum dynamic range.

Product

Noise Figure Measurements With Vector Correction

S93029B

-

Keysight Technologies

S93029B - Keysight Technologies

The S93029B noise figure application enables high-accuracy noise figure and noise-power measurements of amplifiers, frequency converters, and mixers, utilizing Keysight’s unique vector-source-correction technique

Product

Araid 2.5"X2 SATAIII RAID 0/1 (White)

96RACK5-ST-R1-AR8

-

Advantech Co. Ltd.

96RACK5-ST-R1-AR8 - Advantech Co. Ltd.

Fits 2 x 2.5" SATA SSD/HDD in a 5.25" drive baySupport RAID 0/1Support up to SATA 6Gb/sSupport hot swap and auto-rebuildFront LED indicator lights