Showing results: 856 - 870 of 1132 items found.
-
Deltapi N Series -
ABB Ltd.
Deltapi N series includes a range of pneumatic transmitters suitable for reliable measurements of pressure, differential pressure, flow or level of liquids, steam and gas. Deltapi N transmitters provides a wide selection of measuring elements to match required working pressure ratings and calibrated spans.
-
TR5001 SII QDI SERIES -
Equip-Test Kft.
• Flexible Multi-Core Parallel / Merged-Core Tester• Serial Test Controller with up to 8 ports on any pin• Light - Curtain Protected Press - Down Platform• PXI Ready• Built-in Self Diagnostics and Auto-Calibration function• High-Accuracy Measurement• Flow - based Easy Program Development
-
Extech SDL350 -
Extech Instruments Corporation
The SDL350 records data on an SD card in Excel format. Air Velocity/Air Flow meter with telescoping probe designed to fit into HVAC ducts and other small openings. Telescoping probe extends up to 7.05ft (215cm) maximum length with cable. Adjustable data sampling rate. Stores 99 readings manually and 20M readings via 2G SD card. Type K/J Thermocouple input for high temperature measurements. Large (9999 count) LCD displays Air Velocity or Air Flow and Temperature simultaneously. Record/Recall MIN, MAX, Data Hold and Auto power off. Complete with 6 x AA batteries, SD card, telescoping probe with cable, and hard carrying case.
-
SY024 -
Synectic Electronics
The SY024 Frequency Scaler/Multiplier can be linked to most frequency generating devices. It can be set to multiply or divide the frequency by a simple set up. When a frequency output device like a flow meter gives insufficient pulses to give the accuracy you need, or too many pulses for your Programmable logic controller or frequency counter to handle, or if you have more than one frequency output device and the rates are different you can match them by multiplying or dividing and re-transmitting to match the outputs to one another or the capabilities of your PLC etc.
-
Laserlux® G7 -
RoadVista
The Laserlux® G7 is the safe, smart and simple solution to meet this challenge. The Laserlux® G7 provides continuous pavement marking assessment and evaluation within the flow of traffic. It is the only commercially available instrument that does not require a dedicated vehicle or vehicle modifications to operate. Not only does the Laserlux® G7 measure pavement marking retroreflectivity, but it is able to provide additional key metrics like stripe width, location on the road, coverage, and presence, performance and location of raised retroreflective pavement markers (RPM’s, cateyes, road studs).
-
06-01 Series -
HÜBNER Photonics
*Plug and play ultra-compact diode lasers (MLD) and diode pumped lasers (DPL)*405 nm, 445 nm, 473 nm, 488 nm, 515 nm, 532 nm, 553 nm, 561 nm, 633 nm, 638 nm, 647 nm & 660 nm*Up to 250 mW, integrated electronics*Fiber pigtailed option*Optional integrated clean up filter*Fast and high aspect ratio option, modulation up to 150 MHz*Perfect for fluorescence microscopy, flow cytometry
-
SPECTEC Innovative Sensor Solutions
SPECTEC's frequency to current and frequency to voltage converters for passive and active magnetic speed sensors and all digital speed sensors fit in a variety of explosion-proof elbow enclosures or can be DIN rail mounted via special adapters. These signal conditioners change the sinusoidal input to a linear current or voltage output respectively. The 4-20 mA and 10-50 mA signal converter has many applications in the flow industry. The frequency to voltage converters provides either a 0 to 5 V (TTL) or 0 to 10 V output.
-
Meriam Process Technologies
Meriam's flagship products, the MFC5150 HART Communicator which enables direct communication from any HART transmitter wirelessly and the MFT 4010 Modular Calibrator, which delivers the versatility of a calibrator and the convenience of HART Communications afford Meriam the advantage of providing products with the highest level of innovation for commissioning, configuring and maintaining devices to allow for efficient process operations. These smart devices were designed to optimize process automation via HART Communication by offering analytic support for flow, level, pressure, temperature and valve applications.
-
aTCA-3710 -
ADLINK Technology Inc.
The aTCA-3710 is a high performance, high bandwidth, 40G Fabric switch blade for AdvancedTCA® platforms. This product is ideal for bandwidth intensive telecom applications such as wireless access controller, DPI/security network, IPTV, IP multimedia subsystem, RNC/BSC, broadband access/bearer network, data center, and LTE/4G network applications. The aTCA-3710 provides 40GbE hub-to-node connectivity and integrated switch silicon that supports load balancing, priority queues, packet classification, and flow control to enable strict bandwidth management for implemented applications.
-
SICK Sensor Intelligence
Easy setup, accurate measurement, rapid resultsGravimetric dust measurement devices extract a partial gas flow from the duct under predefined conditions and use a filter to separate out the dust particles. The amount of dust is ascertained by weighing the filter. The differential pressure is measured to determine the extracted volume. These two values are then used to calculate the concentration of dust in the duct with a high level of accuracy. Gravimetric dust measurement is ideal for calibrating other dust measuring devices and for taking the kinds of comparative measurements that are required by the relevant authorities.
-
Parker Hannifin Corp.
Parker high performance flowmeters provide a consistent line of accurate and efficient measurement solutions that can work with a wide range of industrial media. Choose from our many different types of flowmeter, each adaptable to meet the needs of your application. We also supply PFA and PTFE flowmeters for leak-free, precise control of ultra-high purity liquids and a diverse range of gas mass flowmeters. These enable us to meet demands for expanded flow ranges and high operating pressures, making them suitable for use in extreme environments.
-
GLE-20 -
Lisun Electronics Inc.
GLE-20 is an oil-salt two-in-one Face Masks Particulate Filtration Efficiency PFE Tester. According to ASTM F1862-17, ASTM F2299-03 (2017), ASTM F2100-2019, BS EN14683-2019, BS EN 14387-2004+A1 2008, BS EN 136-1998, BS EN 140-1999, BS EN 143-2000 +C1-A1, BS EN 149-2001+A1, etc. It is used to test the particulate filtering efficiency of daily protective masks and medical masks, and to determine the obstruction performance of ordinary fabrics and medical protective masks against a constant flow of airflow.
-
CMC -
Power Electronic Measurments Ltd
Variable Frequency Drives (VSDs) used to control AC motors can produce large high frequency voltages that may appear on the machine shaft. These voltages are the result of capacitive coupling of the PWM voltage. The voltages on the shaft can be sufficient to cause arcing currents to flow through the motor bearings to ground.
-
Keysight Technologies
Shorten design cycles to achieve first-pass design success. Our next-generation integrated electronic design automation (EDA) software provides engineers with new tools and enhancements to bring efficiencies into their printed circuit board (PCB), RF and microwave, 5G / 6G, and high-speed digital design flows.
-
500xv -
Teledyne LABS
The 500xv is able to pump higher viscosity material by reducing the restriction within the pump, specially designed with 3/8” ports at a 45 degree angle. Ball valves are used for automating refill and continuous flow which clear easily.The 500xv syringe pump provides precise delivery of high viscosity material up to 204 mL/min. Pulse-less flow is delivered up to 5,000 psi (345 bar) for pumping thick materials. Viscosity can be reduced by heating the pump chamber. A Temperature Control Jacket can be used to raise the temperature above ambient up to 100 ◦C.The High Temperature package allows the ability to heat up to 200 ◦C.The SyriXus controller has backlighted keypad and 4-line LCD display, as well as built-in and optional interfaces for computer control and other devices. Programming is easy and flexible, with instant access to menu screens even when the pump is running. This allows you to change operating parameters on the fly. Control the pump remotely using driver for LabVIEW™ software, in addition to pump controller.The 500xv pump module has a single-ratio drive train with auto-lubricating gears for long life and low maintenance. Special fittings are used to prevent leaks and ensure safety at maximum pressure.
