Product

Twelve-Channel Cable/Terrestrial Receiver for PCIe

DTA-2139C

-

DekTec Digital Video B.V.

DTA-2139C - DekTec Digital Video B.V.

Twelve (!) receivers on one card, supporting a mix of terrestrial (ATSC 3.0, ATSC 1.0, DVB-T/T2, ISDB-T) and cable (DVB-C/C2, ITU J.83) signals. All twelve channels are demodulated simultaneously, allowing you to monitor a complete network in real time.

Product

GPS Antenna Signal Splitter 4 Way, SMA Jack, 1000 - 2000 MHz, 50 Ohm

GPS410

-

INSTOCK Wireless Components, Inc

GPS410 - INSTOCK Wireless Components, Inc

GPS L1 - L5, GLONASS, Galileo SplitterLow Insertion Loss (0.4 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.10 : 1 avg)15 VDC & 75 mA max on DC block portsRoHS Compliant Splitter Construction

Product

ULTRA-SONIC RECEIVER W/PARABOLIC REFLECTOR

MFJ-5008

-

MFJ Enterprises, Inc.

MFJ-5008 - MFJ Enterprises, Inc.

Many times the noise is coming just outside your doorway, from the power lines. Power companies are usually very willing to help out with noise issues, but not all companies in this age of financial limitations will have the necessary equipment or trained personnel to properly locate nearby noise sources.

Product

100Gb/s Coherent Receiver

-

Optoplex Corporation

Optoplex Corporation

The integrated 100-Gb/s DP-QPSK receiver incorporates two 90° optical hybrids with four pairs of balanced photodetector (PD) and four linear TIAs into a single butterfly package. Unlike other technologies in which the polarization beam splitter (PBS) and/or the power splitter (BS) are not included, Optoplex’s receiver includes both of them with the optical hybrids, PDs and the TIAs to offer a fully integrated solution which will benefit users in terms of completely removing fiber routing and the skew management. The integrated receivers work at the symbol rate up to 32GBaud/s.

Product

Mini Receiver

FB7-NX

-

National RF, Inc

FB7-NX - National RF, Inc

In about 1935, the National Radio Company of Malden, Mass., brought out a “hot” high frequency receiver, called the FB7, and the subsequent FB-7X. It featured a super-hetrodyne design with plug-in coils that gave it a broad frequency range. The “X” model also incorporated a crystal filter in the intermediate frequency section, thus giving it additional selectivity. The receiver was viewed by radio amateurs as a technological breakthrough, and it was also used commercially for point to point high frequency communications. As the receiver did not have an internal RF amplifier section, a separately tunable RF amplifier was later provided in a separate enclosure for additional performance capabilities. Now, National RF, Inc., is resurrecting the fabled receiver name with an all solid-state, hot mini receiver, which also utilizes plug-in coils to cover the HF spectrum. The mini-receiver is designed for use by radio amateurs as well as serious short-wave listeners, and allows reception of AM, CW, and SSB signals. It incorporates a super-hetrodyne design with a dual gate FET built-in RF preamplifier and a ceramic filter for selectivity, often required when used in a crowded amateur radio band. In addition, the receiver has a buffered rear panel output of the high frequency oscillator for use with either a frequency counter for exact receive frequency display, or for interface with an outboard transmitter. A rear panel jack is also provided for muting the receiver when a transmitter is placed into the transmit mode. And, the receiver is small enough to fit into carry-on luggage and taken on trips when it is desired to “keep an ear” on amateur radio or other high frequency activity. The receiver utilizes rear panel plug-in coil assemblies which contain the RF amplifier, mixer, and oscillator tuned circuits. Each plug-in coil assembly also comes with a separate dial scale, which is inserted onto the front panel for displaying the tuned frequency. A very smooth 6 to 1 planetary drive is used for tuning the receiver. Other front panel controls include RF preamplifier peak, volume control, Beat Frequency Oscillator adjustment, and RF gain control. Other switches include filter bandwidth, AM/CW/SSB selection, Power, and a general coverage/band spread control for certain plug-in assemblies. The receiver is intended to drive head-phones via a rear panel jack, but has sufficient output to drive a small external speaker.

Product

CATV & SAT IF Optical Receiver Module

MRS-26D

-

Hangzhou Huatai Optic Tech. Co., Ltd.

MRS-26D - Hangzhou Huatai Optic Tech. Co., Ltd.

*Ultra low noise push-pull technology *Band width of 2.7 GHz* 46dB CNR (typ.) for NISC with OMI = 4% at –8dBm optical input power @ 1550nm* 20dBmV RF output level (-5dBm,1550nm,OMI=4%)* Very low intermodulations *Low power consumption *Small package with single-mode fiber pigtail *Integrated optical demultiplexer (WDM filer) for RF overlay applications *Monitor voltage output and output disable input

Product

USB 3.2 Receiver Compliance Test Software

N5991U32A

-

Keysight Technologies

N5991U32A - Keysight Technologies

Maximize the usage of your test instruments with a fast and reliable application to automate system calibration and USB 3.2 receiver compliance tests.

Product

Low Power SNMP AGC FTTB Optical Receiver

BGL2000

-

Hangzhou Huatai Optic Tech. Co., Ltd.

BGL2000 - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai BGL2000 product series, is a low power consumption, high index, with SNMP network management, AGC, full function FTTB optical receiver. 2000 series' shells are structure compact aluminum wall hung ( without rain-proof ), RF interface horizontal output, Nixie tube displaying parameters. RF Overlay interface can be optional for IP/QAM and EOC insert, also can used for local program insert.

Product

EMC Test Receiver w/ Real-time bandwidth to 685 MHz

TDEMI ULTRA

-

Gauss Instruments

TDEMI ULTRA - Gauss Instruments

TDEMI ULTRA offers real-time bandwidth up to 685 MHz, ultra-fast receiver scanning and real-time scanning up to 40 GHz. Offers highest performance for all challenging applications. Also a time-saving and highly efficient full automation of your EMC and communication testings according to all EMC or ETSI standards is available by the EMI64k software suite.

Product

GPS Signal Splitter 16 Way, SMA Jack, 1 - 2 GHz, 50 Ohm Coaxial

GPS161

-

INSTOCK Wireless Components, Inc

GPS161 - INSTOCK Wireless Components, Inc

Wideband Frequency (1000-2000 MHz)Low Insertion Loss (0.6 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.15 : 1 avg)15 VDC & 75 mA Max on DC Block PortsTri Alloy SMA Female (Jack) Low PIM

Product

Infrared Receiver For SumoBot

350-00014

-

Parallax Inc.

350-00014 - Parallax Inc.

Infrared receiver with 38 kHz carrier frequency, for use with the original BASIC Stamp SumoBot Robot kits, now discontinued. We recommend purchasing replacements in pairs, since models supplied in kits may vary.