-
product
Vibration Condition Monitoring
PROTOR
PROTOR provides a complete hardware and software solution for vibration monitoring of rotating machines. Acquisition subsystems monitor the machinery and are networked to a central server. Realtime and historical data can be accessed on the server or remotely via a LAN, WAN or VPN. Data and reports are available in graphical and numerical forms.
-
product
GreenEye Monitor
Residential
The GreenEye Monitor (GEM) is a multi-channel energy consumption monitor. The GEM is used to measure consumption of up to 32 electrical circuits and provide up to the minute consumption data.
-
product
Industrial Panel PCs and Monitors
Advantech provides HMI and monitors with C1D2 certification. Apply to asset monitor and data process in harsh environments like O&G or pharmaceutical.
-
product
Bulk Current Monitoring Probe
MP-50
The Current Monitoring probes may be used whenever RF current measurements are required. Current measurements are made by placing a current carrying conductor within the “sensing” window of the probe and measuring the probe’s output voltage with an RF detector. Calibration of the probe permits the conversion of the voltages measured to current. Current measurements can be made over the frequency range shown in the transfer impedance curve furnished with each probe. There is virtually no loading of the circuit and the technique permits normal operation of the device under test during measurements. The MP-50 can be used for the procedure for clamp injection when the common- mode impedance requirements cannot be met given in chapter 7.4 of IEC/EN 61000-4-6 „Immunity to conducted disturbances, induced by radio frequency fields”. The MP-50 can also be used as current monitor for BCI testing as per ISO11452-4, RTCA/DO-160 section 20, MIL-STD-461 and various automotive standards.
-
product
IR Temperature Sensors for Critical Equipment Monitoring
FLIR A310
The FLIR A310 is a fixed-mounted thermal imaging camera that can be installed almost anywhere to monitor your critical equipment and other valuable assets. The camera can safeguard your plant and measure temperature differences to assess the criticality of a given situation. This allows you to see problems before they become costly failures, preventing downtime and enhancing worker safety.
-
product
TPMS - Tire Pressure Monitoring System Sensors
The new Bosch Universal Sensors for Tire Pressure Monitoring Systems (TPMS) measure the air pressure of the vehicle’s tires in real time and transmit it directly to the control unit by radio. Universal, compact and easily programmable, Bosch QUICK FIT sensors offer a vehicle coverage of over 90% with just two part numbers.
-
product
Audio Monitor
TouchMonitor TM7
For environments where space is an issue, an audio metering unit of the TouchMonitor TM7 series is the ideal choice. Combining the simple and flexible operational concept and GUI of the TM9 with a 7" high-grade touch screen, the TM7 lets you configure the instruments of your choice with ease. Instruments can be scaled, randomly positioned and combined for optimized use of available screen space. The modular software concept lets you purchase exactly the features you actually require.
-
product
Environmental Monitoring Modules
Unidata’s environmental monitoring modules are robust and easy to install, simple to use and require very little maintenance. Typical applications include temperature monitoring, solar radiation monitoring, wind speed and direction measurement, barometric pressure measurement, rainfall recording and many more.
-
product
Aerosol Monitor
DUSTTRAK II-8530
The DUSTTRAK™ II Aerosol Monitor 8530 is a desktop battery-operated, data-logging, light-scattering laser photometer that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
product
Radiation And Process Monitoring Systems
ProTK
Monitoring of the main steam line for leakages in a PWR nuclear power plant with a wide-range gamma ionization chamber.
-
product
Electrostatic Dust Monitor
201LP
The Redkoh Model 201LP is a three wire particulate monitor that measures particulate levels in air ducts on a real time basis. The Model 201LP is powered by an external 24V dc supply and its continuous 4-20 ma output can be connected directly to a PLC, recorder, or digital readout. Changes in the 4-20 ma output are directly related to changes in the concentration of particulate in the gas stream.
-
product
Thermalert Clinical Monitoring Thermometer
TH-8/AOP
The TH-8/AOP is one of our most economical precision thermometers in the Physitemp product line. The TH-8 offers the same high accuracy (0.1°C ±1 digit) and resolution as all our other thermometers, but with a narrow temperature range. The TH-8 has a temperature range 0f -10 to +60°C with 3 probe inputs. The TH-8 is also switchable from celsius to Fahrenheit. The TH-8 is ideally suited for either a laboratory or hospital setting where continuous temperature readings within the physiological range are sufficient.
-
product
Aerosol Monitor
DUSTTRAK DRX-8533
Real-time dust monitoring takes a giant leap forward! Only the DUSTTRAK™ DRX Aerosol Monitor 8533 can simultaneously measure both mass and size fraction - no other monitor can do both. The DUSTTRAK DRX desktop monitor is a battery operated, data-logging, light-scattering laser photometers that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
product
Indoor Air Quality Monitoring
Si-AQ Expert
The Si-AQ Expert is the ideal tool for testing indoor air quality in warehouses and office buildings. It can measure concentrations of multiple different hazardous of gases and compounds that can affect air quality and worker safety.
-
product
Partial Pressure Monitor for RGA
PPM100
Stanford Research Systems, Inc.
The PPM100 is a stand-alone controller/monitor for SRS residual gas analyzers. It measures partial pressures from SRS RGAs and total pressure from up to four capacitance manometers. Graphical output is available on a touchscreen LCD display.
-
product
Monitoring System
A112
The photoelectric sensor model A112 allows to realize a system for detecting breaks of thin wires from 10 um in diameter, with a detection range greater than 50 cm.The A112 produces these results without the use of laser technology, allowing high immunity to vibration and a secure alignment between receiver and transmitter.
-
product
Drone Detection RF Monitoring System
Shenzhen Tangreat Technology Co., LTD.
Drone Detection RF Monitoring System by Tangreat
-
product
Automated Data Management and Capacity Monitoring Solution
SafeCapacity
SafeCapacity, an automated data management and capacity monitoring solution, addresses the difficulties inherent to exponential data growth, 24 by 7 operational requirements, and optimization of data across varying levels of storage resources.
-
product
Laser Power Meter Monitor
11UNO
New 11UNO portable laser power meter brings unprecedented performance in a compact hand-held instrument. The one-finger navigation of the 11UNO laser power meter makes it our most simple to use monitor, and it has just the functions you need to take a fast and precise laser power measurement.
-
product
LE Photoacoustic Infrared Refrigerant Monitor
Chillgard LE
The Chillgard LE Photoacoustic Infrared Refrigerant Monitor is specifically designed for reliable detection of some of the most common refrigerants from up to four remote locations—with a minimum detection level of 20 ppm.
-
product
Health and Usage Monitoring Systems
Honeywell Aerospace Technologies
Health and Usage Monitoring Systems (HUMS) for helicopters provide diagnostic information required for optimum performance. HUMS sensors and embedded diagnostic software monitor and communicate the health and maintenance needs of critical components.
-
product
Microwave Monitor + Power Check Kit
A100c
This single-range, RF power measurement instrument is designed to operate in the 2.45 GHz range. Used by field service engineers, engaged in the repair and maintenance of commercial and domestic microwave heating equipment, its primary function is the detection RF microwave energy leakage.
-
product
External Pyrometric Camera for Combustion Thermal Monitoring
PYROSCAN-U
Pyroscan-U is specifically designed to perform thermal monitoring and mapping of any object inside a kiln, furnace, boiler or reactor, while looking at the area of interest through a standard window, from outside the combustion chamber. This megapixel pyrometric camera captures both visible and infrared HDR (High Dynamic Range) images of the burning zone.
-
product
In-Situ Spectroscopic Ellipsometer for Real-Time Thin Film Monitoring
UVISEL Plus In-Situ
The UVISEL Plus in-situ spectroscopic ellipsometer can be easily mounted on process chambers (PECVD, MOCVD, sputter, evaporation, ALD, MBE) for the real-time control of thin film deposition or etch processes.The UVISEL Plus in-situ provides the unique combinations of very high speed, sensitivity, dynamic range and accuracy making the instrument able to control deposition / etch at the atomic layer thickness level, even for rapid processes.
-
product
Digital Dust Monitor
3443
The Kanomax Digital Dust Monitor – Model 3443 measures aerosol concentrations corresponding to PM10. The intake isolates the aerosol sample so that the optics chamber is kept sterile for improved reliability and low maintenance. The unit measures 0.1 to 10µm particle size aerosol contaminants such as fumes, dust, smoke and mists. It is battery-operated, data-logging, light-scattering laser photometer that gives you real time aerosol mass readings. It is also suitable for clean office settings well as harsh industrial workplaces, construction and environmental sites, and outdoor applications.
-
product
Monitoring Products
The motor condition monitoring device with the ability to quantify the status of a three-phase induction motor and incorporating EtherNet/IP communication to trend information on current analysis, motor vibration, motor temperature, and insulation resistance.
-
product
Condition Based Monitoring
Test Products International, Inc.
Vibration analysis at the touch of a button. Overall machine and bearing conditions: vibration values are displayed with color coded alarm levels for ISO values and Bearing Damage (BDU).
-
product
Co2 Monitor Indoor Air Quality
VAT920-CO2/ VAT920-CO2-VOC80
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Co2 monitor Indoor air quality monitor and controller :CO2 monitor , indoor air quality including CO2,VOC temperature ,humudit.
-
product
Heat Stress Monitors
Heat stress management is often viewed as time-consuming and complex. Simplify your heat stress management with TSI’s intuitive QUESTemp° Series Heat Stress Monitors.
-
product
Dynatrace Application Monitoring
Start Dynatracing your applications in minutes with easy deployment and zero-configuration.Auto-discover and map all applications and transaction-flows in your distributed environment.Leverage self-learning baselines with alerts, out-of-the-box dashboards and auto-correlated system monitoring.Find problems before your users notice them with smart, early production error detection.Configure, manage and update easily with a centralized configuration consoleeven for thousands systems.Enable easy access for everyone who needs it. Provide one system valuable to all stakeholders by de-coupling system access and performance analysis.
