Laser Diode Drivers
An integrated circuit that supplies modulated current to a laser diode in response to an input serial-data stream. (maxim-ic.com)
-
Product
CO2 Laser Marker
LP-400
-
Panasonic Industrial Devices Sales Company of America
The LP-400 Series is a CO2 Laser Marker best suited for glass and most plastic applications.
-
Product
Brush DC Drivers
-
Allegro provides a broad portfolio of safe and robust brush DC solutions. With both integrated and MOSFET gate drives our product lines are ideal for low- and high-power applications alike. Increased digital content with embedded drive algorithms simplify your implementation, while enhanced diagnostics and protection features ensure a safe and reliable solution.
-
Product
Laser energy meter with high dynamic range
PM 200
-
In the past laser energy meters often required a whole selection of pyroelectric detectors for measuring different energies. From this point of view the PM 200 is a very modest instrument. A single detector enables monitoring of energies from the detection limit at 3 ?J up to highest energies of 200 mJ. The active sensor area with an aperture diameter of 34 mm ensures simple and reliable alignment for the detection of large beam profiles.?
-
Product
SP1T RF Pin Diode Switches To 18 GHz
-
Pulsar Microwave manufactures pin diode RF switches that are controlled by TTL logic. This configuration is known as single pole, single throw and is often abbreviated SPST or SP1T. They have been engineered to function in 50-ohm systems, and are designed to operate from 40 MHz to 18 GHz. They have a switching time of 100 nanoseconds and input power rating of 200 mW (23 dBm). Performance of 1.6:1 or better VSWR and minimum isolation of 60 dB is typical of most models.All switches of this type require both +5VDC and -5VDC to operate. Typical current consumption is +/- 30 mA. TTL control logic of 0 to +5VDC is required. Units comes standard with SMA connectors.
-
Product
Two Diode Assembly, P/N 6030C
-
Two Diode Assembly, P/N 6030CEach diode is rated for 400 Amps, 1200 PIVTwo diodes are installed on one heatsinkDimensions: 8”H x 8”W x 10”DEstimated weight: 20 lbs.When A is greater than B, Battery 2 is reversed BiasWhen B is greater than A, Battery 1 is reversed Bias
-
Product
PXI 32 Channel I/O, High and Low Side Driver
40-413-003
-
The 40-413 range is available in three configurations, a high side only, a low side only and a combined high and low side (shown here) –each capable of driving 2A loads. Each output is fully protected against over-voltage, over-current and thermal overload, ensuring robust and reliable operation in the toughest test environments.
-
Product
Picosecond Lasers
PL2230 Series
-
The first commercial fully diode pumped high pulse energy mode-locked laser, producing 28 ps pulses with up to 140 mJ pulse energy.
-
Product
Nanosecond Pulsed Lasers
-
Our nanosecond pulsed lasers feature pulses in the ns range. For picosecond and femtosecond lasers please see Ultrafast Lasers.
-
Product
Solid State PIN Diode Transfer Switch, 100 MHz to 18 GHz
P9400C
-
The Keysight P9400C solid state PIN diode transfer switch offers outstanding performance in terms of port-to-port isolation, switching speed and low insertion loss over a broad operating frequency range of 100 MHz to 18 GHz. The P9400C is particularly well suited for ultra-fast RF and microwave switching applications in instrumentation, communications, radar, switch matrices and various other test systems where high isolation, speed and lifetime of a switch is critical.
-
Product
Saturable Spectroscopy Laser Lock Module
-
A compact, mechanically-robust laser frequency reference.
-
Product
Laser Level Transmitters
-
ABB is a leading manufacturer of state-of-the-art level and volume instrumentation for liquid and bulk solids detection. The family of non-contact laser volume and level products, LLT100, LM80, and LM200, provide solutions for accurate measurement in the following applications: inventory in bunkers, blending hoppers, reactor vessels, level control, volumetric measurement, and various dry bulk solids and liquids in silos.
-
Product
Laser Module
LDM200
-
Artifex Engineering GmbH & Co. KG
The LDM200 series of laser diode modules are specialized units for high-end applications. The fibre coupled design allows flexible installation and separation of the electrical and optical sections. High quality optics and precision adjustment provide for excellent beam quality and very long collimation distances up to 100m. Customized fixed focus distances may also be provided. The option of choice of pola
-
-
Product
Low-Barrier Schottky Diode Detector, 10 MHz to 12.4 GHz
423B
-
The Keysight 423B Low-Barrier Schottky Diode detector has been widely used for many years in a variety of applications including leveling and power sensing. It offers good performance and ruggedness. Matched pairs (Option 001) offer very good detector tracking. A video load (Option 002) extends the square-law region to at least 0.1 mW (-10 dBm).
-
Product
Low-Barrier Schottky Diode Detector, 10 MHz to 18 GHz
8473B
-
The Keysight 8473B Low-Barrier Schottky Diode (LBSD) detector has been widely used for many years in a variety of applications including leveling and power sensing. It offers good performance and ruggedness. Matched pairs (Option 001) offer very good detector tracking.
-
Product
Laser Doppler Anemometry
-
Laser Doppler Anemometry (LDA), also known as Laser Doppler Velocimetry (LDV), is an optical technique ideal for non-intrusive 1D, 2D and 3D point measurement of velocity and turbulence distribution in both free flows and internal flows. Science and industry apply our LDA systems to gain a clearer understanding of fluid mechanics. The measurement results are important steps in fine-tuning product designs to improve aerodynamic efficiency, quality and safety.
-
Product
Thermopile Laser Power Measuring Heads
BB Series
-
The BB series of heads has a black broadband absorbing coating. The HP series is equipped with a ceramic layer which allows for high energy and power densities.
-
Product
SP2T RF Pin Diode Switches To 18 GHz
-
Pulsar Microwave's 2-way switches are available in absorptive and reflective designs from 20 MHz to 18 GHz. They are also referred to as single pole, double throw and abbreviated SPDT or SP2T. These switches have a typical VSWR performance of 1.6:1 or better and input power handling of 200 milliwatts maximum. Switching time is 100 nanoseconds, and isolation of 60 dB or greater for most models. Supply voltages are +5V and -5V, with TTL logic control voltage of 0 to 5 volts.Both absorptive and reflective SPDT switches are packaged into Pulsar Microwave's SW2 outline. Configuration is standard with SMA female connectors. Voltage is applied with wire wrap feed thru terminals. The housing serves as electrical ground, and two turret terminals are installed for wiring.
-
Product
Modulator Drivers
-
Is ideal for driving external mach-zender modulators in 100Gbps DP-QPDK applications.
-
Product
IVI Driver Package
IVI Development
-
The most complete IVI driver package from the most trusted name in IVI. Driver development can be tedious and distracting when you are scrambling to meet product deadlines. Researching the latest IVI standards, lack of driver documentation, and changing firmware all work against your product deadline. As a result, quality control over your product or driver or both can suffer. With IVI Development services from Pacific MindWorks you are free to focus on your product.
-
Product
Phase Locked Laser System
SolsTiS-Phase Locked
-
The phase locked SolsTiS system is primarily designed for use in atom interferometry and quantum computing where Raman transitions are commonly used, although we can tailor the setup to other applications. The system provides extremely low phase noise and high output powers. Full control over the system is provided through our easy to use Ice Bloc user interface.
-
Product
Laser Tachometer
LT-880
-
The LT-880 Laser Tachometer is a non-contact instrument designed to sense the presence or absence of a reflective surface in its optical beam. A TTL signal is asserted whenever a reflective surface is placed within its field of view. The signal may be used with a counter or spectrum analyser to sense linear translation, rpm or transient vibrations.
-
Product
Amplifier-separated Type Digital Laser Sensor
LS-500
-
Panasonic Industrial Devices Sales Company of America
The LS-500 Series Amplifier-Separated Type Digital Laser Sensor offers high-class Laser Sensors able to detect very small objects with a processing speed of down to 60µs. The new full stainless steel M6 housing is robust and optimally suited for applications in harsh environments. The unique controller can handle Thru-Beam, Diffuse Reflection and Retroreflection Laser Sensor heads. All Sensors are equipped with two digital outputs, and cable-type Sensors offer an additional analog output, opening new dimensions in the detection of small objects.
-
-
Product
Lasers FP/DFB-LDs For OTDR
-
C is a 1 650 nm Multiple Quantum Well (MQW) structured Distributed Feed-Back (DFB) pulsed laser diode DIP module with single mode fiber and internal thermoelectric cooler. It is designed for light sources of Optical Time Domain Reflectometer (OTDR).
-
Product
Laser Levels
-
Fast, accurate and portable, PLS laser levels save time and money versus traditional layout methods using a bubble vials, plumb bobs or complex measurements. Compare the benefits PLS laser tools: Beam quality will be bright, thin and crisp. Drop tested with water and dust Ingress Protection (IP). Designed for the professional contractor with self-leveling technology. Green Laser Levels, Rotary Lasers, Point Lasers and Line and Combo Lasers.
-
Product
IVI Driver Development Software
Nimbus Driver Studio™
-
The only set of tools you'll need for standards-compliant IVI driver development and management ... all within the Microsoft Visual Studio environment
-
Product
Laser Measurement Systems
-
Starrett-Bytewise offers laser-based measurement systems that are employed on the factory floor for quality monitoring, process control and inspection. We are a vertical technology company with in-house resources for designing sensors, systems and software. We deliver products through our own sales and service network. Starrett-Bytewise is based in Columbus Georgia, USA, with offices in Europe and China, and is supported by independent sales and service representatives around the world.
-
Product
Laser Head
5517DL
-
The Keysight 5517DL is used primarily in VME and PC based laser interferometer systems where the velocity of motion is faster, such as semiconductor lithography and flat panel applications. Please contact Keysight for custom requirements.
-
Product
Compact Manual Laser Repair System
LCD 2400C
-
Extremely versatile, the LCD-2400 is available in both tabletop and console configurations.Korima's 2400 Laser Repair System is an economical, precision instrument designed to cut lines, repair shorts, and drill holes in passivation in virtually any metal.
