-
Product
Power Line Isolators & Conditioners
-
A power line conditioner (also known as a line conditioner or power line conditioner) is a device intended to improve the quality of the power that is delivered to electrical load equipment. While there is no official definition of a power conditioner, the term most often refers to a device that acts in one or more ways to deliver a voltage of the proper level and characteristics to enable load equipment to function properly.In a nutshell, poor incoming electrical power converted to good output power.
-
Product
Signal / High Power, Module, ITA, TriPaddle, iCon Series, 4/4 Position
510161124
ITA Module
Primary mating module 510160124. (May mate with other Receiver modules, as well.)
-
Product
Power Sensor and SNS Noise Source Cables (3 m/10 feet)
11730B
Power Sensor
The Keysight 11730 series power sensor cables are used with the 8480 and E-series power sensors (except the E9320 family of peak and average sensors). These cables are designed to reduce RFI effects on low power readings with an improved shielding design in the cable itself. Cables may be ordered individually or in pairs in any combination desired for single and dual-channel measurements.
-
Product
Power Supplies
ZP-380B
-
Many power supplies fail to obtain the 80-Plus certification, which indicates that the power supply can provide 80% plus power efficiency. The ZP series, however, can. It is one of the few power supplies that can give you the power you need at higher efficiency, which means you can use the same power with less energy. It is also built with a 120mm fan that maximizes its cooling system and Active PFC to improve the stability and efficiency of the transmission network. APFC will help reduce transmission loss and improves voltage regulation. Save money at high power efficiency with ZP.
-
Product
PXI 48 x SPDT Power Relay Module
45-157-001
Relay
The 45-157 SPDT Power Relay Module consists of 48 single pole changeover relays controlled by a PXI/CompactPCI interface. It is suitable for applications were conventional reed-relay based switching modules do not have sufficient voltage rating or current carrying capacity. All 48 contacts are electrically isolated from each other and are capable of switching resistive and inductive loads up to 2000VA at 240V AC.
-
Product
Waveguide Power Sensor
R8486D
Power Sensor
Excellent SWR for reducing mismatch uncertainty50 MHz calibration port Accurate calibration and traceability to US National Institute of Standards and Technology (NIST) millimeter-wave sensor calibration Compatible with EPM (new N1913A/ 14A, E4418B/ 19B), EPM-P (E4416A/ 17A) and P-series (N1911A/ 12A) power meters, plus the E1416A VXI and discontinued 70100A and 43X power meter Accurate average power measurements over -70 to -20 dBm Frequency range 26.5 GHz to 40 GHz Diode power sensing element
-
Product
Power Meter
TW3203R
-
Techwin(China) Industry Co., Ltd
TW3203R handheld optical power meter is the oldest portable test instrment in the Techwin power meter series. It features compact size, ease-of-use and economy advantages. It can be used for absolute optical power measurements as well as for relative loss measurements of optical fibers. TW3203R is an essential test instrument in Optical Communications, CATV and other Fiber Optic measurements.
-
Product
Tool, Extraction, High Power, Receiver and ITA
910112129
Extraction Tool
Tool, Extraction, High Power, Receiver and ITA.
-
Product
Power Quality Monitoring Terminal Detection Platform
PQC1650
-
PQC1650 power quality terminal detection platform is a test system specially designed for power quality terminals. It can fully complete the power quality test method and accuracy test of power quality terminals.
-
Product
Cable Assembly, ITA, I1 Hybrid 4/4, TriPaddle, High Power, 36", Flying Leads
410128565
Cable Assembly
Cable Assembly, ITA, i1 Hybrid 4/4, TriPaddle, High Power, 36", Flying Leads
-
Product
PXI/PXIe Power Relay Module, 25xSPST, 5 Amp, 50-pin SGMC Connector
40-153-003
Relay
The 40/42-153-003 is a PXI/PXIe high density power relay module with 25xSPST switches rated at 5A. User connection is via a 50-pin SGMC male connector. The 40/42-153 range is available in 18, 25, 36 or 50 SPST configurations with or without hardware interlock. Electro-mechanical power relays are used which are suitable for switching loads up to 5A at 250VAC.
-
Product
PathWave BenchVue Power Supply App
BV0003B
-
Keysight PathWave BenchVue power supply control app offers easy control of your power supplies to set parameters, visualize I/V data, and quickly build automated tests.
-
Product
1U Type Power Supply; ATX 300 W
PS300-1U
-
*Input Range: 90 ~ 264Vac Full Range8Output Voltage:**+5V, 14A**+3.3V, 12A**+12V, 25A (0.1A min)**-12V, 0.3A**+5Vsb, 3A*MTBF(hours): At 25°C, 100,000h*Safety: TUV, CSA22.2 NO.60950-1, IEC, UL, CE*Dimensions: 150 x 81.5 x 40.5 mm*Compatible with Axiomtek products: AX61120TB/AX61131TM/AX61133TM
-
Product
DC System Power Supply, 8 V, 90 A, 720 W
N5742A
Power Supply
The single output, 720 W N5742A provides universal AC input, GPIB, LAN, USB, LXI compliance, and analog/resistance control of output voltage and current
-
Product
Micro Power / Micro Coax, Module, ITA, 90 Series, 50 Position
510108262
ITA Module
Primary mating module 510104267.
-
Product
AC/DC Linear Power Supply
-
Linear AC-DC power supplies are electronic devices used to convert electrical energy from alternating current (AC) to direct current (DC), providing a stable and regulated power supply for electronic devices. They are represented by the DA series.Linear power supplies of the DA series are characterised by their low output noise and high speed. They can be used as power amplifiers; a sinusoidal voltage of 8/10 Vpp can be superimposed on the test voltage up to a frequency of 50 kHz.Another application for this power supply family is the simulation of the curve of a photovoltaic panel by programming the voltage and current.
-
Product
PXI/PXIe Power Relay Module, 8xSPDT, 5 Amp, 37-Pin D-type Connector
42-158-104
Relay
The 40/42-158-104 is a PXI/PXIe high density power relay module with 8xSPDT switches rated at 5A. User connection is via a 37-pin D-type male connector.
-
Product
Panel-mounted Power Amplifier(Hardware In The Loop Testing)
PA60Bi
-
PA60Bi is the panel-mounted power amplifier, which can produce 3-phase current, with maximum RMS phase current of 60A and maximum output power of 800VA, and 4-phase voltage, with maximum RMS phase voltage of 120V and maximum output power of 60VA.
-
Product
Universal Multichannel Low Voltage Power Supply System
SY8800
-
- Factory configured modular system- 5 free slots for power supply modules- 3U x 19″ x 35 cm crate size- Floating channels- Local and Remote Control- Remote control via Ethernet, USB, CANBUS and RS232- Max output power: 2.5kW @ 220Vac, 1.5kW @ 115Vac- Up to 8 independent channels- Low noise
-
Product
Power Programmer JK Edition
Max Energy 2.0 Jeep JK Edition
-
The New Max Energy 2.0 Power Programmer JK Edition for 2014-2007 Jeep JKs takes the lead with an expanded menu of desired features and options to maximize power and control on and off the road. The Max Energy 2.0 also has a larger backlit LCD screen for quick and easy setup anduser-friendly navigation for simple installation, tuning, and feature options.
-
Product
Power Electronics Test Solutions
-
Chroma Power Electronics Test Solutions not only apply in the industries of Information Technology, Communication, Aerospace and National Defense, but also in energy efficient products such as Hybrid Automobiles, LED luminance devices, solar and fuel cells that are developed aggressively under the pressure of natural resource constraints. Chroma has a wide variety of instrumentation including AC Power Sources, DC Power Supplies, DC Electronic Loads, AC Electronic Loads, Digital Power Meters, and Automatic Test Systems that are ideal for power input/output terminal tests and dynamic simulation.
-
Product
Power Architecture Tools
-
Cosmic's toolchain for the Power Architecture family is part of a complete and uniform product line incorporating over 20 years of innovative design and development. All Cosmic products include one year of technical support and updates.
-
Product
High Power Digital Lab Series Regulated DC Power Supply – 3000W
-
- 3000W different combination- High current density.- 19″ rack adaptable -5U high- Remote sensing.- Front panel potentiometer to set V&I- 3Digit seven segment display for V&I- High stability and close regulation- Phase controlled preregulation plus linear post regulation Optional, at extra cost- Over voltage protection- 19″ rack mounting
-
Product
Power Quality Analyzers
-
Is used to measure electric power signals to determine the load's ability to function properly with that electric power.
-
Product
IEC60884 Plug Power Cord Bending Test Machine
CX-YB06
-
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60884 plug power cord bending test machineThe power cord bending tester is used to bend (bend) the power cords of non-reconnectable plugs and household appliances and similar appliances.It complies with UL817, VDE0620, IEC60884-2006 Figure 21, and other standard requirements.The device can preset the number of tests (up to 999999 times), the test is automatically carried out, and when the te
-
Product
AC-DC POWER SUPPLIES
-
Universal Input 85-264 VACContinuous Short Circuit ProtectionPCB MountableEfficiency to 82%Industry Standard Pin OutMeets, UL, CSA, TUV CE
-
Product
Micro Power Contacts
-
Rated to 10,000 cycles.Rated to 21 Amps cont w/ 12 AWG wire.Max contact resistance of 1.5 mOhms.Mating force of 2 lbs.
-
Product
Power Tester
PS-228
-
The product designs with LCD to show ATX power voltage. Easy to plug with ATX power 20/24 pin and plug in (P4/P6/P8) to show the voltage on the LCD panel.
-
Product
Power Meters
Power Meter
Teledyne Test Tools range of digital power meters are for single-phase (1P/2W) AC power measurements with a test Bandwidth ranging from DC, 0.1 Hz to 100 kHz. The T3PM1006 model features a 4” TFT LCD screen with a five-digit measurement display. It offers 19 power measurement parameters to choose from, integration measurement function, front/rear panel input terminals, and various communication interfaces to help users to make convenient and accurate power measurement. The T3PM1100 model offers DC, 0.1 Hz ~ 100 kHz test bandwidth, 16 bits ADC, and 300 kHz sampling rate. It features a 5” TFT LCD screen with a five-digit measurement display. It also has options to display waveform (voltage/current/power), the integration measurement function, harmonic measurement and analysis of each order (meeting the IEC 61000-4-7 harmonics measurement requirements at 50/60 Hz), external sensor input terminals, and various communication interfaces to help users to make convenient and accurate power measurements.
-
Product
2 GHz to 6 GHz, 45 dBm Power Amplifier
HMC7885
-
The HMC7885 is a 32 W gallium nitride (GaN), monolithic microwave integrated circuit (MMIC) power amplifier (PA) module that operates between 2 GHz and 6 GHz, and is provided in an 18-lead hermetically sealed module. The amplifier typically provides 21 dB of small signal gain and 45 dBm of saturated radio frequency (RF) output power. The amplifier draws 2200 mA of quiescent current (IDD) from a 28 V dc supply. The RF input and output are dc blocked and matched to 50 Ω for ease of use.
