-
product
Voice Quality Test
POLQA
POLQA is the next-generation voice quality testing technology for fixed, mobile and IP based networks. POLQA was standardized by ITU-T as P.863 and can be applied for voice quality analysis of HD Voice, 3G and 3G/LTE networks.
-
product
RS232 / RS485 / RS422 / Serial To Multi-Drop Fiber Optic Converters
Our advanced, rugged, industrial-grade, RS232 / RS485 / RS422 serial to multi-drop fiber optic converters are designed to cover large areas. These converters support up to 255 fiber nodes, and each fiber node can extend the RS232 / RS422 / RS485's distance to 3 miles (5km) for multi-mode converters and cables, or 25 miles (40km) for single-mode converters and cables. Depending on the site situation, these multi-drop fiber optic converters can be configured as a...show more -
product
Call Generator (Voice / Data)
Qosmotec Software Solutions GmbH
The Mobile Network Tester LTS is an automatic call generator, that establishes voice and data calls to and from actual mobile devices in the test system. Voice calls can be generated via the wireless PLMN network using actual mobile devices, via the PSTN network through analogue or ISDN lines or via Voice over IP. Wireless data sessions can be setup through the 3G or 4G network or over WiFi.
-
product
Digital LOOP/PSC/EARTH Tester
1824 LP
Standard Electric Works Co., Ltd
● Microprocessor-controlled.● Measures Earth Resistance without the need for poles in the ground or external measuring wires.● Earth measurement uses the real earth current path and the current generated by the electric network, without the need for any disconnection.● The Earth Resistance displayed is exactly the earth resistance that the earth current will need to go through if an earth fault occurs. (you do not need to add all the bonding points and connection paths)● Displays...show more -
product
Satellite Network Simulator
The DataSoft Satellite Network Simulator is a real-time software tool capable of simulating satellite links by operating as a hardware-in-the-loop tool for layer-2 verification and validation, or, as an offline planning tool for capacity and availability analysis for planned deployments.
-
product
PXI-8517, 2-Port PXI FlexRay Interface Module
780689-02
2-Port PXI FlexRay Interface Module—The PXI‑8517 is designed for developing FlexRay applications. As part of the NI‑XNET platform, the PXI‑8517 works well in applications requiring real-time, high-speed manipulation of hundreds of FlexRay frames and signals, such as hardware‑in‑the‑loop simulation, rapid control prototyping, bus monitoring, automation control, and more. The PXI‑8517 contains two fully functional FlexRay interfaces, allowing an individual ECU to be connected to the interface when other cold-start nodes are not available. You also can use the interfaces individually to connect two separate FlexRay networks while maintaining full performance on each interface.
-
product
Ethernet Switch
PRV-1059
Curtiss-Wright Defense Solutions
The Parvus PRV-1059 is a rugged VLAN-capable 5-port PC/104 Fast Ethernet switch featuring very low power consumption and highly reliable extended-temperature operation up to +85°C (185°F). Supporting auto-MDI-MDIX network installation, the board is designed for simple plug-and-play operation, enabling up to five embedded computing devices to be networked together using 10BaseT or 100BaseTX Local Area Network (LAN) connections.
-
product
HFC 7 Ways Return Path Optical Receiver 1 Way Reverse Optical Transmitter
HR2071A, HR2071B
Hangzhou Huatai Optic Tech. Co., Ltd.
HR2071 series of HFC seven-way return path receiver, one way reverse optical transmitter, mainly used at the head-end to convert upstream optical signal to RF signal at the user side. Moreover, send back the data at sub-HE to main head-end through one way of DFB return path transmitter. Eight independent units integrated into a 1RU 19" casing to provide service for HFC network terminal of ONTs. The receivers’ low noise design of -22dBm receive sensitivity, allow to supply service to farther dis...show more -
product
Embedded Wi-Fi Mesh Module
MNS-300EM
MNS-300EM is an embedded module that provides mesh connectivity for low-power portable devices to connect to a 802.11s capable mesh network. It features an 802.11ac radio, and a complete TCP/IP network protocol stack with an optimized QCA9377 wireless radio driver and security supplicant in a self-contained hardware package. It also supports enterprise security which ensures data integrity and privacy for highly sensitive applications.Embedded Wi-Fi Mesh with Enterprise Security
-
product
True-Mode Stimulus
S96460B
S96460B provides mismatch-corrected true-mode stimulus and enables accurate balanced measurements on 4-port E5080B vector network analyzers.
-
product
Short Range
A standard-compliant wireless technology, optimized to fit short range connectivity, energy per bit and bandwidth requirements, is behind every network - regardless of its nature or purpose. With the growing importance of wireless sensor networks and the IoT, most electronic systems require wireless connectivity.
-
product
Network Management
JAVA Agent
WebNMS SNMP Agent Toolkit Java Edition unleashes the power of network management through industry-acclaimed standard management technologies like SNMP and JMX.. Based on the technology needs, SNMP Agent Toolkit enables rapid building and prototyping of SNMP agents and Multi-protocol agents.
-
product
ABex in System Programmer with Onboard SMH FlashRunner LAN 2.0 NXG
ABex AM-307 FR-NXG Flashrunner
The ABex AM-FR-NXG incorporates the FlashRunner LAN 2.0 Next Generation from SMH Technologies. The FlashRunner is used to program microcontrollers, flash and other logic and memory devices. All DIO’s, the programmable voltage lines and the corresponding ground lines can be switched by relays.The ABex AM-FR-NXG is equipped with an onboard Ethernet Controller which connects the FlashRunner directly to the PXIe Backplane of the ABex Chassis. Using a windows host, each AM-FR-NXG will provide its own network adapter.
-
product
Signalling Relays
Mors Smitt is an authority when it comes to signalling relays. We have inhouse expertise and manufacturing of various standards used in several networks.
-
product
47~2400MHz FTTH CATV & SAT-TV Optical Receiver
HRS-24-H1
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai HRS-24-H1 product series is a kind of CATV & SAT-IF optical receiver with high-performance and high-index. 7~2400MHz operate bandwidth. Output level Vo=86dBμV ( Pin=-2dBm ), suitable for FTTH, FTTP fiber access network. It is a low power consumption, high performance and excellent cost performance CATV & DBS network ONU(Optical network unit). This series product adopts high sensitivity receiving tube and special low noise matching circuit. Under 3.8% modulation, when transmitting ...show more -
product
SIMRC - 16-Channel 1-Pole MUX, Screened Reed
1020-R-16-1RF-5/1D
Our small format embedded switching (SIM relay) cards offer a choice of switching configurations using low cost industry standard SIM connectors. They free the designer from the detail of routing complex switching circuits, you may select from a wide range of cards using the built in RS-232 and I2C interfaces. These low-cost embedded switching cards are intended to be mounted on to a simple motherboard. They may be used to construct very high density switching networks. SIM based switching cards also allow for very simple in-field maintenance.
-
product
Short-Depth Servers
Advantech short depth servers are designed to optimize performance and throughput of 5G, vRAN, MEC and IoT applications at the edge of the network.
-
product
Test Probe
UE
Qosmotec Software Solutions GmbH
Qosmotec UE Test Probe offers more flexibility to testers of mobile networks. It is a compact plug & play multi-UE test probe that allows for tests in UMTS, HSPA+ and LTE standards from any location. It can hold a custom set of up to 8 UEs.
-
product
NEON Signal Mapper
The NEON® Signal Mapper application leverages key parts of TRX’s patented NEON Location Service including sensor fusion and mapping algorithms that enable real-time 3D location and mapping within buildings. Signal Mapper’s ability to locate and geo-reference users where GPS is not available simplifies and dramatically reduces the time required for map indoor signal and sensor data.Deployed with only a small, wearable accessory and an Android device, NEON Signal Mapper is the ideal solution for professionals who conduct in-building testing of public safety and commercial networks, including public safety organizations, network operators, and indoor wireless network installers.
-
product
Impedance Standards and Calibrators
Impedance Calibrator is to replace countless single value RCL standards with one calibrator that can switch between the standards like a CD changer in your car. The calibrator contains stable and temperature independent resistance standards, partial capacitance standards and partial inductance standards, simulated by RC T-type passive network. Calibration values of both complex parameters of partial standards are displayed on large LCD screen in preselected pairs of parameters as well as voltage, current and frequency readouts from built-in test signal meter. OPEN and SHORT reference positions are available as well.
-
product
Optical Power Meter
Shanghai Stone Communication tech Co., Ltd
This optical power meter series is a compact and an easy-to-use testing instrument for optical fiber networks, which can be used for absolute optical power measurements as well as for relative loss measurements in optical fibers. It has features of ingenious appearance, wide range of power measurement, high accuracy with high performance-to-price ratio.
-
product
SPLIT MOUNT RADIO SYSTEM
CFIP PhoeniX C
CFIP PhoeniX C split mount system is designed to fit in a classic telecom architecture with a radio located outdoor and a sheltered indoor unit. CFIP PhoeniX C system has compact indoor unit that enables transition from TDM networks to hybrid TDM/IP networks providing up to 64E1, Gigabit Ethernet ports, or up to 16 ASI ports for transferring video signal. Total maximum capacity is up to 366 Mbps full duplex.
-
product
CAN/LIN Communications Expansion Kit
OP-SB87
OP-SB87 is an expansion board for CAN/LIN communications, inserting into a slot of communication analyzer LE-8200A/LE-8200. It has 2 CAN connectors and 2 LIN connectors, and measures 2 channels of CAN or LIN, or 1 CAN/1 LIN. It is useful to measure network where there are CAN and LIN communications at the same time.
-
product
ADSL Network Testing
BX Series
The VeEX BX series products support ADSLx installation and maintenance. Triple Play features include VoIP, IPTV, Web Browser, WiFi, and NetWiz. Weather proof, touch panel, 4+ hours LiIon battery pack, small and lightweight package make the BX series a powerful, feature rich, user friendly yet cost-effective solution.
-
product
Spectrum Monitoring and Interference Systems
Automate wide area, close-proximity signal monitoring, interference detection, identification, location, reportingIncrease flexibility; set up rugged, portable-RF sensors in fixed, temporary or mobile platforms in any environment for extended periods of timeRemotely deploy a single sensor or a network of sensors synchronously country or city-wide, or in a roomCustomize for your application with software for spectrum monitoring, emitter location, signal intercept, capture/analysis
-
product
Multidimensional Ultrasonic Anemometers
TriSonica®
TriSonica® sensors measure wind and other atmospheric variables with speed, accuracy, and precision. They are size, weight, and power (SWaP) optimized for rapid deployment in stationary, mobile, and network systems.
-
product
Voice Communications Systems
NAVICS
The NAVICS® fully IP based ICS from Rohde & Schwarz uses a uniform IP network to connect distributed on-board voice terminals and other subsystems for internal and external communications. The ruggedized, highly available IT technology with creditable security is also from Rohde & Schwarz
-
product
Network Gateways
The communication protocol of the master controller, Factory Automation (FA) network, is converted to Oriental Motor's own RS-485 communication protocol. Connection to Oriental Motor's network compatible products is completed with one RS-485 communication cable.
-
product
SIMRC - 8 x 2 Matrix 1-Pole Screened Relay
1030-R-8-2-1RF-5/1D
Our small format embedded switching (SIM relay) cards offer a choice of switching configurations using low cost industry standard SIM connectors. They free the designer from the detail of routing complex switching circuits, you may select from a wide range of cards using the built in RS-232 and I2C interfaces. These low-cost embedded switching cards are intended to be mounted on to a simple motherboard. They may be used to construct very high density switching networks. SIM based switching cards also allow for very simple in-field maintenance.
-
product
Bias Networks
RF and microwave bias networks are used in a wide variety of biasing applications for test and measurement requirements in laboratory and production environments. Bias networks provide the means of supplying DC bias to the center conductor of the coax connector for your device while blocking the DC to the RF ports.
