Light-Emitting Diode
Semiconductor diode that emits narrow spectrum light by converting electric energy into electromagnetic radiation.
-
Product
PIN Limiter Diodes
-
Macom Technology Solutions Holdings Inc.
MACOM’s PIN limiter diodes provide excellent broadband performance from 1 MHz to 20 GHz and higher for receiver protector circuits. Our PIN limiter diodes are available in die form, plastic and ceramic packaging. Our ceramic packaged diode series is ideal for waveguide, coaxial, and surface mount applications, while our die diode series is well suited for chip and wire high frequency microwave applications.
-
Product
SCR Diode Testers
-
SCRs and Diodes are used in the power sections of various power systems. A SCR Diode Tester is an important piece of equipment to determine if a SCR or a diode is defective in a power circuit. It is difficult and time-consuming to troubleshoot SCRs and Diodes with a digital meter.
-
Product
.13u ESD diode
Impulse TSMC
-
The Impulse TSMC .13u ESD diode was made to provide ESD discharge paths when integrating third party IP in an integrated circuit design for total ESD protection. The Impulse ESD diode has been successfully used with Dolphin Technologies, Artisan/ARM, TriCN/Synopsis I/O libraries, as well as popular IP blocks from RAMBUS, Chip Idea and other quality IP vendors. A 5.5 volt reverse bias anode to cathode operational specification enables the Impulse TSMC .13u ESD diode to be the device of choice for 5 volt tolerant designs.
-
Product
Spectral Single-Mode Diode Laser
-
The diode lasers are compact, single-mode light sources with a spectral width in the sub-MHz range (cw). A modulation input is optional. The wavelength for standard products is in the range 1530nm-1565nm (other wavelength can be tested).
-
Product
Diode Lasers
-
The large spectral coverage of our diode lasers combined with the compact form factor, direct modulation capability (up to 150 MHz), true off during modulation (>70 dB aspect ratio), and integrated spectral clean-up filters make them ideal for applications in high resolution bioimaging, flow cytometry, optogenetics and quantum technologies.
-
Product
Step Recovery Diodes
-
Macom Technology Solutions Holdings Inc.
MACOM’s Silicon and GaAs varactor multiplier diodes provide broadband performance ranging from 10 MHz to 70 GHz. They are ideal for multiplier circuits and are available in die form, plastic and ceramic packaging. These diodes boast a flip chip series for higher frequency millimeter wave applications; plastic packaged series for microwave frequency surface mount applications; ceramic packaged series for high power waveguide and coaxial applications.
-
-
Product
Laser Diode Modules
-
Fiber-coupled laser diodes are finding more and more industrial applications, for example in printing technology, comparable graphic areas, material processing or sensor technology.
-
Product
Diode Lasers
Spot Creator
-
Advanced Photonic Sciences LLC
Spot Creator is an innovative accessory developed for enhancing the performance of blue laser diode based engraving and cutting machines. Spot Creator solves a major problem with using asymmetric blue laser diodes: the production of engraving features that are different in the X-Y directions, resulting in unequal or blurred lines. Using Spot Creator, line widths are equal in the X-Y directions, with a minimum spot of 50 μm. The intensity on the engraved part is thus maximized.
-
-
Product
Laser Diode
-
Is a Polarization Maintaining CWDM Coaxial DFB-LD for CWDM analog communication, CATV return-path, laboratory instrument, and R&D applications. This cost-effective, high reliability DFB laser chip has a selectable wavelength with range between 1270 nm to 1610 nm. The versatile DFB-CWDM also features a built-in InGaAsP monitor photodiode, built-in optical isolator and 4-pin coaxial- pigtailed package, single mode coupling, and an FC/APC connector. Contact Optilab for more information.
-
Product
Diode Submounts
-
Ultra-precise patterning of thin film metals on dielectrics with high thermal conductivity are used for diode submount applications. Via the acquisition of Ion Beam Milling, Inc., SemiGen is the industry leader for laser diode submount fabrication. As each application is different, we work with customers to develop a custom design that perfectly fits their requirements. We have experience producing circuits utilizing substrates of varying thicknesses with high thermal conductivity such as alumina (Al), aluminum nitride (AlN), and beryllium oxide (BeO). SemiGen can deliver laser diode submounts with or without Au/Sn pads depending on your needs.
-
Product
Steering Diodes
-
ProTek's low capacitance Steering Diode Arrays provide high-speed data line and I/O port protection from transients caused by Electrostatic Discharge (ESD), Electrical Fast Transients (EFT), Tertiary Lightning and other induced voltages. Steering diodes divert the transient to the power-bus or ground and away from sensitive IC components.
-
Product
PIN Diodes
-
PIN photodiodes convert light to current – without a bias voltage having to be applied. Silicon is commonly used as an inexpensive detector material in the Vis range. For higher demands, InGaAs is used; it covers the widest spectral range from the Vis to the NIR. We offer silicon carbide as a “solar-blind” detector specifically for the UV range.
-
Product
Schottky Mixer Diodes
-
Teledyne Lincoln Microwave GaAs beam lead Schottky diodes for the up/down conversion of millimetre wave detected signals are designed for applications which demand ultimate performance. The device is easily assembled onto a wide variety of surface mount substrates using thermo-compression, thermo-sonic or epoxy bonding techniques.
-
Product
Millimeter-wave and Microwave GaAs Diodes
-
Keysight Technologies provides MMIC diodes ideal for microwave radio, aerospace and defense, and instrumentation applications.
-
Product
Diode Tester
FEC VF40CM
-
Frothingham Electronics Corporation
The VF40CM is intended for testing VF, HALF CYCLE SURGE, and THERMAL RESPONSE/RESISTANCE on small- and medium-power diodes and rectifiers. It can also measure THERMAL RESPONSE/RESISTANCE on NPN and PNP bipolar transistors using an external user-supplied VCB supply.The VF40CM also is sometimes used to measure VZ of low-voltage zener diodes up to the compliance voltage limit of the tester. 20V at 20A is possible.
-
Product
Laser Diode Life Test
-
Life-tests consist of the highly accelerated ageing, under controlled conditions, of a group of lasers taken as a representative sample. Optical degradation of the laser diodes is observed and recorded by precisely measuring changes in the laser's operating characteristics during the test. Life-tests are used for vendor qualification of the laser diodes during product development and can be conducted throughout the production life of the laser.
-
Product
Fast Recovery Diodes
-
We offer high-performance products with low forward voltage (VF) and high-speed reverse recovery time (trr) for increasing device efficiency.
-
Product
High-power Laser Diode Assembly
-
The laser diode is one of the most common devices used throughout photonics. The micro-assembly process calls for the placement and bonding (align-&-attach) of single emitters, or multiple laser diodes (stacked or complete bars), the placement, active alignment and bonding of necessary micro-optical elements, subsequent device testing, and ultimately packaging and quality control. ficonTEC’s machine systems are capable of all the steps necessary for assembling laser diodes, even high-power devices. Multiple in-line systems can be configured to address entire process segments.
-
Product
Rotating Diode Assembly, P/N 6118CA
-
CEHCO is a specialist in the repair of Rotating Diode Assemblies.
-
Product
PIN Diode Switches
-
After producing quality PIN diode switches in-house for many years, K&L Microwave is pleased to offer packaged options for customer applications. The offerings below are intended to highlight standard products; however, with our extensive in-house capabilities, custom parts are also available.
-
-
Product
High Voltage Diode Assemblies
-
High voltage diode assemblies are built by adding diodes in series to yield a higher peak inverse voltage. For example, if each diode is rated for 1200 peak inverse voltage (PIV), then six diodes in series would have a total peak inverse voltage of 7200 PIV. The detailed circuit is shown below.
-
Product
Diode Assembly
CDA&TDA
-
*Simple Installation*Low Cost*RoHS Compliant (Directive 2002/95/EC)
-
Product
Laser Diode Drivers For Automotive
-
Automotive Head-Up Displays (HUDs) are benefiting from big innovations in MEMS projection systems and are central to ADAS and safety. The latest laser scanned-MEMS projection systems can provide higher resolution images and at a lower cost. Renesas' highly integrated laser diode driver enables automotive head-up displays (HUDs) with high resolution, high color-depth and high frame-rate projections.
-
Product
MOSFETs, MESFETs, and Schottky Diodes
Semiconductor Module
-
The Semiconductor Module allows for detailed analysis of semiconductor device operation at the fundamental physics level. The module is based on the drift-diffusion equations, using isothermal or nonisothermal transport models. It is useful for simulating a range of practical devices including bipolar, metal semiconductor field-effect transistors (MESFETs), metal-oxide-semiconductor field-effect transistors (MOSFETs), Schottky diodes, thyristors, and P-N junctions.
-
Product
Power Diodes
-
Renesas power diodes support the high performance and small size and weight of mobile and information devices.
-
Product
Diode Lasers
-
Offering diode lasers in a wide range of wavelengths, power, and package configurations. Providing optimum solutions for applications in laser pumping, materials processing, medical, defense, and instrumentation.
-
Product
Laser Diode
-
A laser diode, also known as an injection laser or diode laser, is a semiconductor device that produces coherent radiation (in which the waves are all at the same frequency and phase) in the visible or infrared (IR) spectrum when current passes through it.
