-
Product
MPS™ Flammable Gas Sensor
-
NevadaNano’s Molecular Property Spectrometer™ (MPS™) Flammable Gas sensor is powering the next generation of combustible gas detection. The MPS delivers unprecedented reliability, accuracy, and worker safety by simultaneously detecting over a dozen of the most common combustible gases, including Hydrogen, Methane, Propane, Butane, and many more. We call this TrueLEL™. No other flammable gas sensor can accurately report 0-100% LEL across over a dozen different gases with just one factory calibration, the MPS never requires field calibration.
-
Product
AC Current Sensor
RCTi and RCTi 3ph
-
The RCTi & RCTrms sensors convert ac current to an isolated 0-5V voltage or 4-20mA current loop. TA5V-5A allows compatibility with existing 1A or 5A CT metering circuits. Both offer a choice of proportional (rms) and instantaneous outputs. The available RCT current ranges are 0-100A to 0-50,000Apk. Both RCTi and RCTrms provide accurate measurement over a wide bandwidth ensuring precise measurement even with harmonically distorted wave shapes - using a flexible clip-on sensing coil. The RCTs are available as single and three phase models.
-
Product
Temperature Sensors
-
A temperature sensor is a device that detects and measures hotness and coolness and converts it into an electrical signal. At TE Connectivity (TE), we design and manufacture a broad portfolio of temperature sensors – including our NTC thermistors, RTDs, thermocouples, and thermopiles – designed for efficiency and easy installation, with capacity to reliably integrate technology that responds to human behavior.
-
Product
TI HDC1080 Humidity and Temperature Sensor Breakout Board
SEN-37001
-
Breakout board for the Texas Instruments HDC1080. This sensor is an extremely accurate temperature and humidity sensing device, with +/-0.2C temperature and +/-2% humidity accuracy typical. These specs far exceed the accuracy of ICs that came before it, including the HTU2x and SHT2x series, and improves upon the success of the HDC1050. In addition, the HDC1080 has a wide input voltage range of 3V-5V and includes temperature and airflow cutouts as recommended for the best operation. Finally, in the case of environmental changes that could cause light condensation, the HDC1080 has a built-in heater to burn off any condensate. Example code (Arduino platform) is available below.
-
Product
Blank, Module, Receiver, Pull-Thru, 1 Position
510130113
Blank Module
Blank, Module, Receiver, Pull-Thru, 1 Position.
-
Product
Clamp type AC Current Sensor／for Power Monitor
ZCT-23S
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*Ultra compact size*AC 0.1A～120A*Current measurements of terminal feeder
-
Product
Sunshine Duration Sensors
-
Easy to install, with no moving parts or complex on-site adjustment, the MS-95S reinvents sunshine duration sensors, setting new standards for accuracy and stability.
-
Product
Inductive Sensors
-
Inductive Proximity Switches, self contained, depend on the output of an oscillator for their operation. The oscillator resonant circuit uses an open core coil to produce a concentrated high frequency electromagnetic (RF) field, which emerges from the active surface of the sensor. If a metal target (or other electrically conductive material) enters this field, eddy currents will be induced in it, causing the resonating oscillator to be damped.
-
Product
Long Range & Wide Area Photoelectric Sensor
PX-2
-
Panasonic Industrial Devices Sales Company of America
The advanced optical system of the PX-2 Series reduces the null zones in front of an automatic guided vehicle (AGV). The null zones on the sides are further minimized if auxiliary Sensors, which can be easily mounted with a Connector, are used.
-
Product
Solar Radiation Sensors & Transmitters
A70 Series
-
The Comptus A70 Series solar radiation sensors with transmitters are available in two models. The A70-A PAR Sensor measures photosynthetically active radiation (PAR) in the 400 to 700 nm range. The A70-I Insolation Sensor measures solar radiation in the 280 to 2800 nm range. The signals from the sensors are scaled by the signal conditioner to provide the desired output.
-
Product
Precision Linear Actuators
-
High-accuracy, motorized devices that convert rotational motion into linear, straight-line movement (push/pull) for tasks requiring extreme, repeatable accuracy.
-
Product
Digital output version optical fast DO sensor
RINKO II / II D
-
Rinko II is a digital output version with a fast-response optical DO sensor. The instrument can be easily integrated on platforms, because it works with communications by RS-232C or RS-485 and an external power (12 to 24V DC).Rinko IID has not only a temperature sensor but also a depth sensor. Their models can monitor DO in real time, if you have a personal computer and an external power.
-
Product
Integrated Current Sensors
-
Current sensors have to be smaller, smarter, cheaper. LEM’s R&D is actively developing a range of ICS to reduce the footprint of the current sensing function and simplify the integration of current measurement in a wide range of applications in automotive, industrial, or residential.
-
Product
Remote Sensor
-
McLennan Sound Monitoring, Inc
The remote noise sensor assembly consists of a noise sensor mounted in a laser-cut, powder painted, 16-gauge metal chassis. The noise sensor assembly is connected to the main instrument with a four conductor cables and has an “on” indicator LED. Due to the power-balanced low impedance return signal, the remote noise sensor can be placed up to 1000 feet away from the McLennan sound level monitor main instrument without significant change in the signal.
-
Product
GEO Instruments & Sensors
-
Jewell Instruments divides its Geo tiltmeters into eight different series based on model numbers.
-
Product
Remote Temperature Sensor
CHV-RTS
-
The CHV-RTS is a wall-mounted remote temperature sensor designed for use with select Crestron thermostats. The 1-1/2 inch diameter face of the CHV-RTS protrudes just 1/8 inch from the wall surface and is easily painted or wallpapered to blend into the wall surface.
-
Product
Rugged Package Sensors
SQ-RPS
-
Environmental protection IP65, IP67, IP68 with industry standard interfaces.
-
Product
Hexis Dual Sensor
-
The Fortis accelerometer and the Certis medium-motion seismometer combined in a single instrument for a total realised dynamic range that exceeds 200 dB.
-
Product
Submersible, Waterproof Sensors
-
Linear, rotary and tilt sensors, IP68 sealed for continual submersion to 10 bar (150psi, 100msw depth), 350 bar (5000psi, 3500msw depth). Designed for the marine environment these corrosion resistant sensors offer very long life and high performance.
-
Product
Single Channel Linear DC Power Supply
MPS-D+ series
-
Voltage stabilitySource effect CV≤0.01%+2mVLoad effect CV≤0.01%+2mVRipple and noise CV≤1mV(rms）CC≤5mA(rms）Voltage temperature coefficient 150ppm/°CCurrent stabilitySource effect CC≤0.2%+2mALoad effect CC≤0.2%+5mACurrent temperature coefficient 500ppm/°C
-
Product
Interface Between the Operator and the Sensor
Controller
-
The high-resolution touch screen provides best technical comfort and a virtual keyboard, including Latin, Asian and Cyrillic characters. A real time chart shows the trends and provides quick and clear information about the current process cycle, while the menu and display functions are clearly laid out. The user interface is intuitive and simple to use. Password-protected user administration and a stable, comprehensive data memory for all process values and events ensure the traceability, reliability and safety of the system.
-
Product
High Temperature Dynamic Pressure Sensors
-
PCB® high temperature dynamic pressure sensors can be structured with a quartz element or a UHT-12™ element.
-
Product
Smart Inductive Digital Measurement Sensors (DMS)
-
Contrinex Smart Inductive Digital Measurement Sensors (DMS)
-
Product
Colorimeter Logger Sensor
NUL-219
-
The colorimeter measures transmittance and absorbance of red, orange, green and blue light components projected on a solution. The colorimeter logger sensor has an opening for a special square solution cuvette. It turns on four different lights in known values and measures the received light that passes through the solution.
-
Product
Dedicated Pressure Sensor
-
The pressure sensors, transducers and transmitters engineered and manufactured by Stellar Technology in Amherst, New York, can be found in industrial applications around the world.
-
Product
Duct Type Wind Speed Sensor
WSA
-
Due to environmental quality management and energy management, we've developed WSA, wind speed sensors which can be applied on ventilation systems, air conditioning, and negative pressure rooms. WSA is a high-accuracy duct type wind speed sensor which can quickly measure the small wind speed. It is stable, high-accurate, and with small drift only. Also, it can caculate the value of the current air volume depending on the measured cross-sectional area of the ducting. Ducting installation and screwless terminals help the users work more easily. Besides, the sensor is equipped with EMC anti-interference devices so that it can withstand strong electromagnetic interferences.
-
Product
Sensor
Hyperion Fluorescein
-
The Hyperion Fluorometer sensor range delivers a high-performance measurement of Chlorophyll A, Fluorescein, Rhodamine and Phycocyanin. Offered as standard in a 6000m depth rated, titanium housing the Hyperion Fluorometer has a wide range (9-28V DC) isolated power supply, data output up to 16Hz and RS232, RS485 and Modbus communications.
-
Product
Fixed Mounting Panel, iCon, 4U, 8 Positions, Black Anodized
310113302
Mounting Panel
This 4U Fixed Mounting Panel has 8 vertical positions. The iCon cover plate is sold separately (310113467). The spacing of the positions will accommodate ITA P/N's 410123102, and 410123232. Also available in a painted gray finish - P/N 310113301.
-
Product
Chemitec Sensors And Analyzers To Monitor Oxidants In Water
-
Chemitec's S494 series of amperometric probes provide continuous, accurate monitoring of chlorine and other oxidants in clean water applications. A range of sensors assures accurate measurement of oxidation, with sensors optimized for Chlorine (total, organic or inorganic), Chlorine Dioxide, Ozone, Peracetic Acid, Hydrogen Peroxide, Bromine, or Chlorites.
-
Product
Ultrasonic Sensors
-
Chemically resistant ultrasonic sensors measure fill levels without contact both under normal pressure and at an overpressure of up to 6 bar in tanks and containers. Through the combination of switching and analog output, you can even conduct fill-level and overflow protection simultaneously.
