Showing recent results 736 - 750 of 2357 products found.
-
40-199-002 - Pickering Interfaces Ltd.
The 40-199 is a 10 Channel Fault Insertion switch designed for the simulation of fault conditions in automotive/avionics applications, involving the reliability testing of safety critical controllers. It is designed to be able to insert 3 different fault conditions between the test fixture and the equipment under test: Open-Circuit, Short-Circuit between UUT connections, Short-Circuit to other signals such as Power, Ignition & Ground via Fault Insertion Bus.
-
40-192-012 - Pickering Interfaces Ltd.
This PXI fault insertion switch uses solid state switching elements and is capable of switching current up to 10A. It is designed to be able to insert three different fault conditions between the test fixture and the equipment under test: Open-Circuit. Short-Circuit between UUT connections. Short-Circuit to external signals. Through relays on each channel enable signals to the UUT to be set open-circuit. Fault Insertion Buses allow any channel to be shorted to any other channel and also enable any channel to be connected to an external signal such as Power, Ignition or Ground to simulate fault conditions. The module is supplied with 2 fault buses.
-
41-660-001 - Pickering Interfaces Ltd.
High voltage attenuator designed to reduce the high output voltages commonly generated by some types of sensors
-
40-755-110 - Pickering Interfaces Ltd.
The 40-755 is a 50 Ohm high-density RF multiplexer (4 to 1) array available with up to 10 MUXs in a single PXI module. It is available with two connector options, an SMB connector that provides a frequency range of 1.8GHz and is available in single or dual PXI slots, or a multiway connector which limits the bandwidth to 500MHz but offers a high density solution occupying just one PXI slot. The RF switch design is identical in each case. Each design in the 40-755 range offers low insertion loss and low VSWR through its usable frequency range and each multiplexer has been designed to have a nominally path independent loss. The array of 4 to 1 switches can be configured into alternative configurations through the use of external cabling.
-
40-755-010 - Pickering Interfaces Ltd.
The 40-75 Ohm is a 50 Ohm high density RF multiplexer (4 to 1) array available with up to 10 MUXs in a single PXI module. The 40-75 Ohm is available with two connector options, an SMB connector that provides a frequency range of 1.8GHz and is available in single or dual PXI slots, or a Souriau multiway connector which limits the bandwidth to 50 OhmMHz but offers a high density solution occupying just one PXI slot. The RF switch design is identical in each case.Need a higher performance, higher BW solution? Try the 40-872 Quad 4 to 1 MUX.
-
40-320-001 - Pickering Interfaces Ltd.
The 40-310/320 Range of High Voltage Switching Modules will hot switch up to 750V peak and cold switch up to 1000V peak in either general purpose relay (40-310) or multiplexer (40-320) configurations. These modules contain high-quality reed relays with switching ratings comfortably higher than the 40-310/320 specification. Applications for the 40-310/320 series modules include; circuit board isolation testing, relay testing, semiconductor breakdown monitoring and cable harness insulation testing.
-
40-332-001 - Pickering Interfaces Ltd.
Designed for applications requiring high voltage power relay switching with high density. They feature current handling up to 5A, 1000VDC/1000VDC peak cold switching and 110VDC/250VAC hot switching. This range is available in 12x2 (shown here) or 6x4 matrix configurations. Connections are made via a front panel mounted 37 pin high voltage D-Type connector.
-
40-726A-751 - Pickering Interfaces Ltd.
The 40-726A is a 12x8 RF Matrix Module suitable for switching frequencies up to 300MHz (50 version). The 40-726A is available in either 50 or 75 versions with a choice of coaxial connectors. The module is designed to provide a simple and scalable bidirectional matrix for RF frequencies. Isolation Switches are located on all coaxial connectors, these disconnect the matrix from the external test fixture. This maximizes isolation and RF performance.
-
40-726A-751-L - Pickering Interfaces Ltd.
The 40-726A is a 12x8 RF Matrix Module suitable for switching frequencies up to 300MHz (50 version). The 40-726A is available in either 50 or 75 versions with a choice of coaxial connectors. The module is designed to provide a simple and scalable bidirectional matrix for RF frequencies. Isolation Switches are located on all coaxial connectors, these disconnect the matrix from the external test fixture. This maximizes isolation and RF performance.
-
40-726A-511 - Pickering Interfaces Ltd.
The 40-726A is a 12x8 RF Matrix Module suitable for switching frequencies up to 300MHz (50 version). The 40-726A is available in either 50 or 75 versions with a choice of coaxial connectors. The module is designed to provide a simple and scalable bidirectional matrix for RF frequencies. Isolation Switches are located on all coaxial connectors, these disconnect the matrix from the external test fixture. This maximizes isolation and RF performance.
-
40-726A-511-L - Pickering Interfaces Ltd.
The 40-726A is a 12x8 RF Matrix Module suitable for switching frequencies up to 300MHz (50 version). The 40-726A is available in either 50 or 75 versions with a choice of coaxial connectors. The module is designed to provide a simple and scalable bidirectional matrix for RF frequencies. Isolation Switches are located on all coaxial connectors, these disconnect the matrix from the external test fixture. This maximizes isolation and RF performance.
-
40-662A-002 - Pickering Interfaces Ltd.
The 40-662A-002 is a dual 8-channel, 1-pole MUX and is part of our range of 16 Amp PXI power multiplexer modules is available in seven configurations ranging from 4-off 2:1 multiplexers to 1-off 16:1 multiplexer.
-
40-662A-011 - Pickering Interfaces Ltd.
The 40-662A-011 is a quad 2-channel, 1-pole MUX and is part of our range of 16 Amp PXI power multiplexer modules is available in seven configurations ranging from 4-off 2:1 multiplexers to 1-off 16:1 multiplexer.
-
40-662A-014 - Pickering Interfaces Ltd.
The 40-662A-014 is a single 12-channel, 1-pole MUX and is part of our range of 16 Amp PXI power multiplexer modules is available in seven configurations ranging from 4-off 2:1 multiplexers to 1-off 16:1 multiplexer.
-
40-662A-003 - Pickering Interfaces Ltd.
The 40-662A-003 is a single 16-channel, 1-pole MUX and is part of our range of 16 Amp PXI power multiplexer modules is available in seven configurations ranging from 4-off 2:1 multiplexers to 1-off 16:1 multiplexer.
