Pickering Interfaces Inc.
Pickering Interfaces designs and manufactures modular signal switching and simulation for use in electronic test and verification.
- 781 897 1710
- ussales@pickeringtest.com
- 170 Main Street
Unit 108
Tewksbury, Massachusetts 01876
United States
- PXI Chassis and Remote Controller
- Configurable PXI & PXIe Microwave Switch Platform
- PXI Power Supply Modules
- High-Voltage LXI Matrix Modules
- PXI Precision Programmable Resistor Modules
- PCI Precision Programmable Resistor Cards
- LXI 50 RF Matrix - 2.4GHz
- 25 Pin D-Type Cables - Connector to Unterminated for Pickering
- 25 Pin D-Type Cables - Connector to Unterminated
- Resistance Temperature Detectors (RTD) Simulators
- 2 Amp PXI Large Matrix Modules
- PXI Chassis
- 20-Pin GMCT Connector & Cable Accessories
- 25 Pin D-Type Cables - Connector to Connector for Pickering
- 25 Pin D-Type Connectors for Pickering
- PCI Switch & Simulation Cards
- LXI Switching Solutions
- LXI RF & Microwave Switching Solutions
- PXI Prototyping and Breadboard Modules
- PXI Attenuator Modules
- PCI Standard Programmable Resistor Cards
- PXI Simulation Modules For Sensor Simulation
- 25 Pin D-Type Connector Blocks for Pickering
- 68 Pin 1.27mm Pitch Micro-D Connectors for Pickering
- PXI Switch Solutions
- PXI Chassis And Remote Controllers
- Cables And Connector Solutions
- PXI High Voltage Amplifiers
- 20 Pin GMCT Cables - Connector to Unterminated for Pickering
- PXI Digital I/O Modules
- PXI Instrumentation Modules For Automated Test Systems
-
product
PXI Dual 8 to 1 RF Multiplexer 3GHz 50 Ohm SMB
40-874-002
The 40-874-002 is a 50 Ohm 8 to 1 RF multiplexer with 2 banks in a single PXI slot. It has low insertion loss and VSWR through the use of modern RF relay technology at an affordable cost. Each MUX has been carefully designed to ensure excellent and repeatable RF characteristics to frequencies of 3GHz with each path having a nominally equal insertion loss. The injection of noise and unwanted signals into the signal paths of this RF multiplexer has been minimized by careful attention to the mechanical and electrical design.
-
product
Cable Assembly 44-Pin D-Type Male to Unterminated With Cut Ends, 1m
A044HM5-C-0A100
The 44-Pin Connector to Unterminated Cable Assy is constructed from PFA insulated 7/0.15 (26AWG) Silver Plated Copper Wire. The connector can be secured to the product by screwlocks.
-
product
15 Pin D-Type Connector to Connector
The 15-Pin D-Type cable assembly is constructed from 19/0.18 (21AWG) Tinned Copper Wire with PFA insulation. Male screwlocks are provided to secure the connectors to their associated products.
-
product
PXIe 2 A Relay Module, 40xDPST
42-139A-102
The 40-139A-102 (PXI) and 42-139A-102 (PXIe) are 40xDPST relay modules suitable for high density switching applications with medium power and feature 2 A current capacity with voltage rating to 300 VDC/250 VAC
-
product
PXI 16x4 RF Matrix 300MHz 50 SMB With Loop-Thru
40-727-001-L
40-727/728/729 are RF Matrix Modules suitable for switching frequencies to 300MHz (50Ω version). The modules are available in either 50Ω or 75Ω versions with a choice of coaxial connectors. The 40-727/728/729 are designed designed to provide a simple and scalable bidirectional matrix to RF frequencies. They are intended for the easy construction of high performance bidirectional matrix switching systems.
-
product
PXI 1 Bank of 160 Channel 1 Pole MUX
40-615-022-1/160/1
High density multiplexer modules featuring a wide range of switching configurations, especially useful where a large number of small multiplexers are required. Typical applications include signal routing in ATE and data acquisition systems. Each module is factory configured into one of the configuration modes. Connections are made via a front panel 200-pin connector.
-
product
LXI Microwave Multiplexer, SP4T, 10-Bank, 67GHz, 50Ω, SMA-1.85
60-803-810
Our 60-803-810 is a 10 bank SP4T multiplexer and is part of a range of LXI based microwave multiplexers suitable for switching 50 ohm signals up to 67GHz. The 60-803 range is capable of supporting up to 16 banks of 4 channel multiplexers it is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA, SMA-2.9, SMA-2.4 or SMA-1.85 connectors.
-
product
PXI 12-Slot BRIC Matrix, 352x16 1-Pole (11 sub-cards)
40-558-121-352X16
The 40-558-121-352x16 matrix is part of a range of BRIC ultra-high-density large PXI matrices are available in 2, 4, 8 or 12-slot PXI sizes to suit all high-performance matrix requirements and are constructed using Pickering Electronics' 4mm x 4mm instrumentation quality reed relays.
-
product
PXI Solid State Multiplexer, 10 Amp, Dual 3-Channel
40-666A-011
The 40-666A-011 is a dual 3-channel 10A MUX and is part of our range of high current multiplexers occupying two slots of PXI chassis. Each multiplexer switch uses a fully isolated solid state relay which has been designed to offer fast operation under hot switching conditions and high inrush current with no operational life degradation. Each multiplexer channel can support 10A of continuous current and switch up to 200V signals. The switches can sustain inrush currents in excess of 50A. AC or DC signals can be switched since the switch is polarity insensitive.
-
product
PXI Dual 18 Channel MUX, 96-Pin SCSI Connector
40-735-912-S1
The 40-735 data communications multiplexer is designed for switching the data lines of serial interfaces (RS232, USB). Careful attention to the design of the module ensures that the switching system minimizes its impact on the transmission distance of USB1.1 interfaces. The MUX is available in 36:1 or 18:1 formats and enables a single source of serial data to be switched to one of 36 or 18 devices under test. This allows the data source to load information to, or receive information from, the d...show more -
product
PXI/PXIe MEMS Optical MUX, 8-Channel, Single-Mode
40-852A-518
The 40/42-852A-518 is a PXI/PXIe 8-channel multiplexer with ST connectors and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
product
PXI 3A Power MUX BRIC, 12-Channel, 12-Pole
40-571-303
The 40-571 is a Power Multiplexer designed to simplify the connection of a common set of test equipment to one of a number of different devices for testing (simultaneous multiple channel selection is possible for most configurations, see switching specifications for restrictions). It is ideal for applications where the equipment needs to conduct the same test process on a series of similar devices one at a time. It is available in a variety of configurations that allow testing with differing number of devices to be tested and different connection widths to suit differing test equipment pin counts.
-
product
PXI/PXIe Microwave Multiplexer, Triple SP6T, 40GHz, 50Ω, SMA-2.9
40-784B-043
The 40-784B-043 (PXI) and 42-784B-043 (PXIe) are triple SP6T 40GHz unterminated microwave multiplexers. The 40/42-784B range is available with single, dual or triple, SP6T or SP4T multiplexers with front panel mounted or remotely mounted relays.
-
product
Cable Assembly, 9-Pin D-Type Female to Unterminated With Tinned Ends, 0.5m, HV
A009DF4-T-HA050
A range of 9-Pin D-Type High Voltage cable assemblies with unterminated connections on one end, constructed from PTFE Type C insulated wire. The unterminated connections are coded to match the connector pin designation.
-
product
50 Ohm SMA to SMA Cable Assembly
40-977-521-1m
Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
Related
-
Virginia Panel Corporation
Virginia Panel Corporation (VPC) provides VPC provides Interconnect Solutions that enable simultaneous connection of multiple test and measurement signal types through one modular interface. Designed to accommodate signal, power, RF, thermocouple, pneumatic/vacuum, and fiber optic connector modules in multiple configurations, VPC’s innovative products meet the demands of test & measurement interconnect requirements.
