Pickering Interfaces Inc.

product

20-Pin Scorpion Cable Assembly, Male to Female, 30A, 0.5m

A020AMR-020AFR-3A050

Pickering Interfaces Inc.

A020AMR-020AFR-3A050 - Pickering Interfaces Inc.

This is a 0.5m long male to female 20-Pin Scorpion cable assembly constructed from 37/0.4 (10AWG) Silver Plated Copper Wire with PFA insulation. Screwlocks are provided to secure the connector to associated product.

product

PXI Quad Microwave SPDT Relay 26.5GHz 50 SMA

40-780A-534

Pickering Interfaces Inc.

40-780A-534 - Pickering Interfaces Inc.

This PXI microwave module is part of a range that gives you the highest RF & microwave switching performance available. Applications are mainly in the microwave region, however there are many uses in the RF spectrum where extremely low insertion loss and ultra high isolation are critical, they may also be used for lower frequency RF applications where power handling to 240W is required (700W for N-Type options).

product

PXI 8 Slot BRIC 322x8 1-Pole (7 sub-cards)

40-560A-121-322X8

Pickering Interfaces Inc.

40-560A-121-322X8 - Pickering Interfaces Inc.

This version of our BRIC is part of a range of high-density PXI matrix modules. These modules are available in 2, 4 or 8 slot PXI sizes to suit all high-performance matrix requirements and are constructed using instrumentation quality reed relays. With this high level of switching density, these PXI matrix modules allow a complete Functional ATE system to be housed in a single 3U PXI chassis. These BRIC matrix modules allow the use of lower cost 8 or 14-slot PXI chassis.

product

PXI 2 Amp MUX, Dual 32-Channel 1-Pole

40-635-005

Pickering Interfaces Inc.

40-635-005 - Pickering Interfaces Inc.

The 40-635 2 Amp Multiplexer module is available in 9 standard configurations as well as 9 half density configurations, all using high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 300VDC/250VAC. The module is suitable for signal routing in ATE and data acquisition systems. Connections are made via a front panel 78-way D-type connector.

product

PXI Breadboard Module, 1-Slot, 96-Pin Micro-D

40-220A-001

Pickering Interfaces Inc.

40-220A-001 - Pickering Interfaces Inc.

The 40-220A series of breadboard modules allow the user to construct their own circuit in situations where a suitable PXI module is not available. For example when it is required to integrate a non-switching function into a PXI chassis. Typical applications include: Creating custom circuitry that can be housed in on a 3U board, or to build special –one-off” switching modules.

product

PXI 2 Amp Multiplexer, Single 32-Channel, 2-Pole

40-635A-002

Pickering Interfaces Inc.

40-635A-002 - Pickering Interfaces Inc.

The 40-635A-002 is a single 32-channel, 2-pole MUX and is part of a range of Multiplexer modules available in 9 standard density and 9 half density configurations, all using high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 300VDC/250VAC. The module is suitable for signal routing in ATE and data acquisition systems. Connections are made via a front panel 78-way D-type connector.

product

PXI Mixed Configuration Relay Module - 1 Cell Populated

40-138-AA-BB-CC-DD (1 CELL)

Pickering Interfaces Inc.

40-138-AA-BB-CC-DD (1 CELL) - Pickering Interfaces Inc.

The 40-138 2A Relay Module with 1 cell populated is a cell-based mixed configuration switching module suitable for applications requiring medium power switching with high density. It provides a broad selection of mixed relay types for greater flexibility and features 2A current capacity and voltages to 300VDC/250VAC.

product

PXI Solid State Multiplexer Module, Single 6-Channel, 10 A

40-666B-012

Pickering Interfaces Inc.

40-666B-012 - Pickering Interfaces Inc.

The 40-666B-012 is a single 6-channel 10A MUX and is part of our range of high current multiplexers occupying two slots of PXI chassis. Each multiplexer switch uses a fully isolated solid state relay which has been designed to offer fast operation under hot switching conditions and high inrush current with no operational life degradation. Each multiplexer channel can support 10A of continuous current and switch up to 200V signals. The switches can sustain inrush currents in excess of 50A. AC or DC signals can be switched since the switch is polarity insensitive.

product

Single Bus 36-Channel 2A PCI Fault Insertion Switch

50-190-201

Pickering Interfaces Inc.

50-190-201 - Pickering Interfaces Inc.

This PCI fault insertion switch range is available with 75, 64 or 36 channels. It is primarily designed for the simulation of fault conditions in automotive & avionics applications involving the reliability testing of safety critical controllers. The Stimulus/Measurement to UUT path is suitable for supporting CAN and FlexRay bus systems.

product

PXI Attenuator Modules

Pickering Interfaces Inc.

Pickering Interfaces Inc.

Programmable RF Attenuators – accurate DC to 3GHz programmable attenuator has a 1dB step resolution, allowing it to adjust signal amplitudes for optimum measurement by other devices.Solid State Programmable RF Attenuators – available in triple or hex formats with bandwidths between 10MHz and 6GHz.High Voltage Attenuators – provide a convenient way of attenuating high voltage low frequency signals to levels that can be captured by other PXI devices without risk of damaging them.

product

PXI 4-Slot BRIC Matrix, 66x16 2-Pole (6 Sub-cards)

40-562B-022-66X16

Pickering Interfaces Inc.

40-562B-022-66X16 - Pickering Interfaces Inc.

The 40-562B-022-66X16 is a high density BRIC4 matrix module with a size of 66x16 with 2-pole switching. It is part of a range of BRIC matrices available in 2, 4, 8 or 12-slot formats to suit high performance PXI matrix requirements and is constructed using instrumentation quality reed relays.

product

Cable Assembly, 200-Pin LFH, Female (Female Screwlocks) to Unterminated (Tinned Ends), 2m

40-972B-200-2m-FU

Pickering Interfaces Inc.

40-972B-200-2m-FU - Pickering Interfaces Inc.

This female rear exit to unterminated 2m long cable assembly does not connect directly to Pickering Interfaces products that use the 200-Pin LFH connector, but customers may find it useful in the development of their own connection solutions. It is constructed from 4 bundles of 50-wire round/flat ribbon cables, unterminated with tinned ends. The connector assembly can be secured to its mating connector by female screwlocks.

product

PXI 2A Multiplexer, 4-Bank, 32-Channel, 1-Pole

40-614C-006

Pickering Interfaces Inc.

40-614C-006 - Pickering Interfaces Inc.

This 4-bank, 32-channel, 1 pole version is part of the 40-614C High Density 2A multiplexer module range that is available in 20 configurations (see Also in this Range link above). All configurations use high quality electro-mechanical signal relays allowing each channel to switch current up to 2A and voltage up to 300VDC/250VAC.

product

PXI 8 Slot BRIC 64x12 2A 1-Pole Matrix

40-597-102

Pickering Interfaces Inc.

40-597-102 - Pickering Interfaces Inc.

The 40-597 PXI Matrix BRIC provides a range of high density matrix modules able to switch up to 2 Amps or 100VDC/70VAC. The 40-597 BRIC modules are available in 2, 4 or 8-slot PXI sizes to suit most high performance PXI Matrix requirements, constructed using high quality electromechanical relays for high switching confidence.

product

PXI/PXIe RF Matrix, 16x4, 300 MHz, 50 Ω, SMB

42-724-012

Pickering Interfaces Inc.

42-724-012 - Pickering Interfaces Inc.

The 40-724-012 (PXI) and 42-724-012 (PXIe) are 16x4 RF matrix modules suitable for switching frequencies up to 300 MHz. Having a 50 Ω characteristic impedance and front panel SMB connectors, these modules provide a simple and scalable bidirectional matrix for RF and are intended for the easy construction of high performance switching systems.