Showing results: 166 - 180 of 185 items found.
-
KT-266F -
KILTER ELECTRONIC CO.,LTD
3 1/2 digits LCD with max. reading of 1999AC/DC voltage and Resistance measurementFrequency test50 mm Large jaw DiameterPlug - insulation tester adapter 500 VDC (optional)Audible continuity, Data hold ,Diode testLow power indication
-
KT-95 -
KILTER ELECTRONIC CO.,LTD
Test device with UTP (Unshielded Twisted pair) ,STP (Shielded Twist Pair) and coaxial wiring ; Test with BNC and RJ45 socket. Test cable length, Check wire continuity, open, short, reversal and miswire. Main unit and one remote allow one person operate. Length Test Range:20m/200m/2km/20km Accuracy: À1% rdg À 0.3m. Self Calibrate available
-
KT-97B -
KILTER ELECTRONIC CO.,LTD
3 1/2 digits, Max. reading 1999Test battery Impedance, resolution up to 0.01mΩTest Voltage onlineFit to test battery: lead-acid, Li-ion; Ni-HM, etcTest the battery used in UPS,automotive,mobile phone,etcPure AC 1,000Hz test mode4 wire test clip with high accuracy
-
KT-266FT -
KILTER ELECTRONIC CO.,LTD
3 1/2 digits LCD with max. reading of 1999AC/DC voltage and resistance measurementTemperature & frequency test50 mm Large jaw DiameterPlug - insulation tester adapter 500 VDC (optional)Data holdLow power indication
-
KILTER ELECTRONIC CO.,LTD
3 1/2 digits, Max. reading 1999Test battery Impedance, resolution up to 0.01mΩTest Voltage onlineFit to test battery: lead-acid, Li-ion; Ni-HM, etcTest the battery used in UPS,automotive,mobile phone,etcPure AC 1,000Hz test mode4 wire test clip with high accuracy
-
KT-96B -
KILTER ELECTRONIC CO.,LTD
Take a new "VECTOR MEASUREMENT" technelogy in measuring the length of the cable. Self calibrating function.Locate the borken point of a cable.With RS232 interface,it can communicate with a PC or μc.A special software is supplied for your computer to connect it to your computer.
-
SE-1004A -
KILTER ELECTRONIC CO.,LTD
●Measure the capacity ●Measure the impedance of the battery●Used as a battery charger●For Li-ion battery (mobile phone battery) and Ni-MH battery ●Capacity range:0~4.000Ah Accuracy: ±2% of reading Resolution: 1mAh●Voltage range: 0 ~ 5V Accuracy: ±0.5% of reading Resolution: 0.001V●Impedance range: 0~1000mΩ Accuracy: ±5% of reading Resolution: 1mΩ●Maximum charge end voltage: 4.400V●Minimum discharge end voltage: 0.000V
-
SE-1004 -
KILTER ELECTRONIC CO.,LTD
● Test mobile phone battery capacity ● 0.1AH~1.9AH (2AH) in 19 steps, standard discharge time:1h(1AH) ● Automatic shut off at discharge finish ● Recharge available ●Set the switch to the Discharge , the led marked Discharge will start flash.When the discharging is completed,the led will stop flash and the beeper will sound.
-
KT-3500 -
KILTER ELECTRONIC CO.,LTD
• Non - intrusive AC and DC current measurement• 10mA resolution• Average responding, RMS calibrated• Auto ranging /Auto zeroing• Data Hold • Low battery indicator• Auto Power OffMeasuring Range: 0 - 500A DC or ACAuto ranging : 50A/500AResolution: 10mA in 50A range, 100 mA in 500A rangeBasic Accuracy: ±1.3% rdg ±5 digitsTemperature coefficient: ±0.05% of rdg /°CFrequency range: DC in DC: 40 HZ to 400 HZ in ACOverload capacity: 500 ADielectric strength: 3.7 KV RMS.50 Hz 60s(EN61010-2-032 Cat III, 300V Pollution Degree 2)Operating Temperature: 0°C to +50°CBattery removed: -20°C to +60°COperating Humidity : <80%RHPower supply: 9V alkaline batteryBattery life: 20 hours dependent duty cycle Display.: 5000 countDimensions: 184×71×31mmMax jaw capacity: 21mm ø CableMax jaw opening: 25mm
-
KT-99/99A -
KILTER ELECTRONIC CO.,LTD
Measure battery storage capacity with clamp-on sensorTest battery capacity under it’s real working conditionSelect different type of battery with discharge end voltageDisplay current and voltage during testingDisplay battery parameters and timeAuto-alarm when test finish,alternatively data savingAuto backlight on in dark areaMaximal capacity count up to 999.9Ah4-wires mode impedance measurement Up to 0.01mΩ resolutionOperating Environment: 0~40℃ ,<80% R.HStorage Environment : -20~60℃ ,<80% R.HPower supply: Heavy duty 9V Alkaline battery ( IEC-6F22)Accessories: “4 wire” test leads 1 pair “2 wire” test leads 1 pair
-
SE-1004B -
KILTER ELECTRONIC CO.,LTD
For Lithium,Ni-MH rechargable bat●Max Cap. : 4Ah●Prevent over heat while charging●Display charge voltage, capacity(Ah) , Intenal Resistance(mΩ)●Auto stop when charge full●Alarm at the end of charge or dischar
-
SE-1004B+ -
KILTER ELECTRONIC CO.,LTD
●For AA, AAA size Alkaline ,Ni-MH ,Lithium batteries●Three mode: Charge , Discharge & Internal Resistance●Capacity Range: 4Ah●Prevent over heat while charging●Auto alarm at the end of charge or discharge ●Display charge voltage, capacity(Ah) , Intenal Resistance(mΩ) ●Used for mobile phone or camera battery ●Accessories: battery clamp, power adapter
-
SE-1005A -
KILTER ELECTRONIC CO.,LTD
Range: 60mΩ / 600mΩ / 6 Ω / 60Ω (auto-range)Accuracy: ±1.0% of reading ±3digits Resolution: 0.01mΩDCV Range: 6V / 60V (auto-range) Accuracy: ±0.8% of reading ±3digits Resolution: 0.001VDCARange: 60AAccuracy: ±1.0% of reading ±3digits Resolution: 0.01ACapacityRange: 999.99AhAccuracy: ±1.5% of reading ±3digits Resolution: 0.01AhDischarge load:24Ω;
-
KT-97 -
KILTER ELECTRONIC CO.,LTD
3 1/2 digits, Max. reading 1999. Test battery Impedance. Test Voltage online. Resolution upto 0.1m¦¸ Fit to test battery: lead-acid, Li-ion; Ni-HM, etc. Judge battery capacity
-
KT-408 -
KILTER ELECTRONIC CO.,LTD
Test with mobile phone,automobile,autocycle and AA,AAA size bettery. Power with 3V button Li-ion. DC.inner resistance range:0-1.999/19.99¦¸ Display battery,know battery capacity or life. Test battery voltage from 0 to 19.99V. Fit to different type battery:lead-acid,Li-ion,Ni-HM,etc. Mini size, Easy to bring out ,high performance and low price