Educated Design & Development, Inc.
A manufacturer of product safety test equipment for various industries and standards, including UL, IEC, CE, CSA, and ASTM.
- 800-806-6236
919-469-9434 - 919-469-5743
- info@productsafet.com
- 901 SHELDON DRIVE
Cary, NC 27513
United States of America
-
Product
Creepage & Clearance Testing
-
Educated Design & Development, Inc.
Creepage Distance Definition: The shortest distance over the surface of the insulation between two conductive parts. Clearance Distance Definition: The shortest distance through air between two conductive parts.
-
Product
Breaking Capacity Testing
-
Educated Design & Development, Inc.
Evaluates the maximum fault current an electrical protective device (like a circuit breaker or fuse) can safely interrupt without failing, exploding, or causing an arc flash.
-
Product
IP code Testing
-
Educated Design & Development, Inc.
Ingress Protection Test Equipment is used to determine the degree of protection provided by a product enclosure. The level of protection provided by an enclosure is represented by an "IP" code (i.e. IP43). The first digit indicates protection against ingress of solid foreign objects. Many of these tests require accessibility probes. The equipment for these tests is provided below. All equipment fully complies with IEC 60529 (IP Code standard) and all other international standards with similar tests.
-
Product
temperature Measurement
-
Educated Design & Development, Inc.
Up to 8 resistance reading channels, 4-wire methodUp to 12 temperature reading chanels, use of Type K, 24 AWG, Teflon thermocouplesIn the Box:8 - data cable (Cat5e) to connect the isolation modules to the Resistance Reading Channels8 - Isolation Module connected between the HOT-30 and EUT (Equipment Under Test) to isolate high voltage8 - Banana Jack Sets (2 red, 2 black), to replace Kelvin Leads in tight places8 - Kelvin Probe Set12 - 72 inch K Type Thermocouple1 - USB2.0 Type A (standard) to Type B USB cable
-
Product
Plug Socet & Cord Testing
-
Educated Design & Development, Inc.
Flexing Tests: On flexible cables (or cords sets with fitted plugs), electric tools or hand lamps. Meets requirements of standards such as IEC 60335, IEC 60227, IEC 60745 and UL745. This product is for continuous bending tests of cables or cord sets fitted with plugs. The model F39 allows the simultaneous testing of two samples in it's standard version. This not only allows for substantial time savings, but also allows for the testing current circuits to be simplified by looping through the cables.
