Showing results: 3061 - 3075 of 6622 items found.
-
NI
PXI SMUs are shipped with an interactive soft front panel for ready-to-run measurements. It includes two modes: one for constantly outputting a DC current or voltage and another for multichannel sweeps. You can monitor and debug the instrument during automated measurement by enabling a debug session.
-
SDI ~ POD -
Murraypro Electronics
Cost effective SDI Demodulator for general purpose use.Cat: 494-Pod (Completely revised)An extremely cost effective SDI to Generic Multi-format 8 Bit Video Converter.Ideal for converting a heritage TV monitor for SDI use.IEC input PSU with lockable low voltage plug
-
V965 -
CAEN S.p.A.
The Mod. V965 is a 1-unit wide VME 6U module housing 16 Charge-to-Digital Conversion channels with current integrating negative inputs (50 Ohm impedance). For each channel, the input charge is converted to a voltage level by a QAC (Charge to Amplitude Conversion) section.
-
V965A -
CAEN S.p.A.
The Mod. V965A is a 1-unit wide VME 6U module housing 8 Charge-to-Digital Conversion channels with current integrating negative inputs (50 Ohm impedance). For each channel, the input charge is converted to a voltage level by a QAC (Charge to Amplitude Conversion) section.
-
PG-50 -
Parker McCrory Manufacturing Co.
A small 110-120 volt A.C. electric fencer unit to protect your garden, flower beds, or shrubs from small animal damage. This fencer delivers a safe uninterrupted voltage with very low current to comply with the national electric safety code. Not recommended for livestock.
-
Ingenieurbüro Mencke & Tegtmeyer Gm
We offer appropriate transmitter for the measurement of different sizes. Our transducers are available with different output signals (10 V, 20 mA, frequency) and various supply voltages (230 Vac, 24 Vdc, 6 to 30 Vdc or 36-265 Vac / Vdc) available.
-
Keysight Technologies
Measure voltage, current and power on 4 channels: DC, 1-phase AC or 3-phase ACMake more accurate power measurements: 0.05% at 50/60 HzMeasure current directly: internal shunts to 50 Arms, or with external probes or transducersAddress multiple test scenarios with isolated inputs
-
NS-1230M -
Taiwan Nissei Sokki Co
Compact size Short circuit and over voltage protection Output power rated at continuous service Binding post output terminals Precision regulation of output voltage Lowe peak-peak ripple of less than 0.3% External fuse access High surge capacity Heavy duty metal cabinet with power coating LED Backlight
-
EL08-230M -
Manatronics Pty Ltd
For High Voltage UPS Battery Testing and Power Supply testing. This particular Load has been designed to operate with UPS Battery Systems and Telecom Rectifiers and Power Supplies with output Voltages in the range of 153V to 230V and is extremely cost effective.
-
1646 -
Peaceful Thriving Enterprise Co Ltd
Check on 6, 12 and 24V systems. Quickly and safely test high and low voltages on all vehicle voltages, including computerized engine. High impedance to protect sensitive electronic sensors, microprocessors, electronic ignition components and air bags.
-
1647 -
Peaceful Thriving Enterprise Co Ltd
Check on 6, 12 and 24V systems. Quickly and safely tests high and low voltages on all vehicle voltages, including computerized engine. High impedance protects sensitive electronic sensors, microprocessors, electronic ignition components and air bags.
-
YAV90084A -
6TL Engineering
4x 8-Bit 1KOhm reostat 4x 8-Bit 40 Ohm reostat 2x 8-Bit 5 MOhm reostat 10x Electronic Potentiometer 8-bit resolution -256 steps- with build-in selft test. 10x Voltage to current source 0(4)..20mA 10x Analog Outputs (Buffer for voltage or frequency) 36-Ch Test Point voltage divider 2xCAN Bus Channels Terminators tester Expandable with NI PXI-6723 and PXI-6345.
-
Model 156A -
TREK, INC.
The Trek Model 156A Charged-Plate Monitor System is designed to provide quantitative measurements of the effectiveness of air ionization systems, as to audit ionizer performance. The Model 156A employs a revolutionary charged-plate monitor design that utilizes an ultrahigh-impedance, high-voltage follower to monitor the ion collecting plate voltage.
-
EAC-AFV -
ET System Electronic GmbH
*Output from 15kVA to 2000kVA*Output voltages 0VAC to 700VAC / 1000VDC per phase*Maximum currents up to 2000A per phase*Simulation of 1- and 3-phase networks (worldwide)*Variable frequency of up to 2000Hz, sine, square, triangle*Indication via graphic display
-
FM-1126 -
Static Solutions Inc.
Now with an ionizer probe attachmentIndicates voltage and polarityDigital display is updated every three secondsNon-contactPower on/hold and zero buttonsEasy to read 3.5" LCD displayRange: 1-20,000v1" spacer bar9v batteryLeather case includedProduct conforms to the ESD S.20.20 spec standardsChecks for class zero conformance