Showing results: 2581 - 2595 of 6622 items found.
-
APCI-2200-8-8 -
TEAM SOLUTIONS, INC.
*8 relay output channels*Switching voltage 60 V/DC, 48 V/AC, switching current 1 A*8 digital input channels, 24 V*Optical isolation*Watchdog*Easy programming
-
APCI-3300-4 -
TEAM SOLUTIONS, INC.
*4 channels for the acquisition of strain gauges*4 onboard voltage sources*18-bit resolution*Optical isolation 1000 V*Software linearisation*Direct connection of the pressure sensors with terminal board PX3200
-
MCH Instruments Co.,Ltd.
Is a device used to measure voltage against time in an electronic instrument. ... The simplest and earliest type of oscilloscope comprises of a vertical amplifier, a cathode ray tube (CRT), a timebase, a power supply and a horizontal amplifier.
-
PD-5 -
Tinker & Rasor
2.5- 100 volt output6 position output voltage selectorCompatible with all "Mark" receivers (Mark II, III, IV, V)Pulse "Identifying" signalBattery charging circuit built-inLED impedance meter
-
ams AG
Zero-offset battery sensor interfaces for current and voltage sensing offer high accuracy. All have a wide dynamic range. Shunt current sensing can take place at the either the positive or negative pole.
-
BUS1000/2000 -
GE Digital Energy
The BUS 1000/2000 is a solid state, high speed protectionsystem for the detection of phase-to-phase andphase-to-ground faults on bus bar installations. It can beused to protect high voltage bus bar installations of anyvoltage.
-
EL18-48M -
Manatronics Pty Ltd
For Telecom Rectifier and Power Supply testing. This particular Load has been designed to operate with Telecom 48V Rectifiers and Power Supplies with output Voltages in the range of 38V to 60V and is extremely cost effective.
-
EL12-48M -
Manatronics Pty Ltd
For Battery Discharge testing and Power Supply testing. This particular Load has been designed to operate with Telecom 48V Rectifiers and Power Supplies with output Voltages in the range of 38V to 60V and is extremely costeffective.
-
C100SFX-1PS-5A -
Pickering Interfaces Ltd.
Female straight PCB mount 100-pin Micro-D connector allows a user to create their own PCB based termination solution. Interfacing PCBs should be designed with suitable clearances for the voltage the application requires.
-
AJIT Electronics Co.
AJIT Transformer Oil Set is completely self contained, compact & portable unit giving smooth variable output voltage from zero to 60/80/100KV for testing the dielectric strength of insulating oil.
-
EL15-48M -
Manatronics Pty Ltd
For Telecom Rectifier and Power Supply testing. This particular Load has been designed to operate with Telecom 48V Rectifiers and Power Supplies with output Voltages in the range of 38V to 60V and is extremely cost effective.
-
EL12-110M -
Manatronics Pty Ltd
For Telecom Rectifier and Power Supply testing. This particular Load has been designed to operate with Telecom 110V Rectifiers and Power Supplies with output Voltages in the range of 100V to 135V and is extremely cost effective.
-
40-136-112 -
Pickering Interfaces Ltd.
The 40-136-112 16xDPST reed relay module is part of our range of medium power, general purpose relay modules which are capable of switching voltages up to 200V and current up to 2A.
-
F8300 -
Manta Test Systems
Use the F8300 for testing three-phase conventional schemes and digital protection systems. This seven-module F8000-series instrument is available in five standard configurations of HVA Current, HVA Voltage, and Low-Density Logic I/O modules.
-
INCAL Technology, Inc.
No. of Tahoe Drivers: 1 (1:1 Driver/BIB ratio)No. of Voltages available per BIB Slot: (16 (PS1…PS16)Same Dynamic Stimuli, DUT Monitoring and Sierra™ Software as the system.